Measuring a load / Terms
v2.00
Part No:
SU3343
07
Ensure that the device is switched on 10 minutes before loading, this will allow
the temperature stability circuitry to acclimatise.
Apply the load SLOWLY and watch the display on the device to ensure that the load applied is not greater
than you had estimated.
Avoid shock loads.
Do not apply large twisting forces to these devices as it may damage them beyond repair.
After use, switch off and, if removing the device from the test site, clean and store, ideally in a
Crosby | Straightpoint carry case. If the device is to be stored for long periods of time, please remove the
battery.
Terms
Crosby | Straightpoint (UK) Ltd warranty this product against malfunction for a period of two years from
manufacture.
Conditions of warranty:
1) The equipment is used as described exactly in the operators manual supplied.
2) Whilst we make every effort to ensure each device is calibrated before despatch, Crosby | Straightpoint
(UK) Ltd do not accept responsibility for inaccurate readings indicated by this equipment.
3) In the event of malfunction, the device is returned to the manufacturer:
Crosby | Straightpoint (UK) Ltd, Unit 9 Dakota Park, Havant, Hampshire, UK, PO9 2NJ.
4) If we consider any malfunction to be caused by misuse, this warranty is void and any repair will be
charged for accordingly.
Warranty
These products are supplied with a certificate of calibration which is valid for one year.
After this date, it is recommended the device is recalibrated by Straightpoint or an approved calibration
laboratory.
Contact the Crosby | Straightpoint service department or your supplier for more information.
In the unlikely event of this device failing, fit new batteries and re-test. Only when this has been done should
you contact your supplier to report the fault. When reporting the fault it is important to give a full description
of the problem and the type of application the device is being used for.
Service and calibration
While these devices are sealed to IP65 / NEMA4X standards, they should not be immersed in water.
The effects of solvent on the device can not be guaranteed, and should therefore be avoided.
Avoid use within 20-30 minutes of rapid changes in temperature, for example moving the device from a cold
vehicle into a warm room. The change in temperature can affect the accuracy of the device. The operating
temperature is -10°C to +50°C or 14°F to 122°F.
Should the display show "OVERLOAD" remove the load immediately as this indicates an overload situation.
Check that the load applied is within the working load limit of the device. If it continues to display overload,
contact your supplier.
Product aftercare
