3 of 3 LPN00622X0001A0_A
lighting.cree.com
© 2018 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change.
See http://lighting.cree.com/warranty for warranty and specifications. Cree®and the Cree Logo are registered trademarks, and
CPY250™ is a trademark of Cree, Inc..
ELECTRICAL CONNECTIONS
STEP 1:
Make the following Electrical Connections :
a. Connect the black fixture lead to the voltage supply position
of the terminal block or Hot 1 (for 208/240V wiring).
b. Connect the white fixture lead to the neutral supply position
of the terminal block or Hot 2 (for 208/240V wiring).
c. Connect the green or green/yellow ground lead to the green
wire position of the terminal block.
d. If Dimming is an option; connect the violet dimming positive
lead to the supply dimming positive lead.
e. If Dimming is an option; connect the grey dimming negative
lead to the supply dimming negative lead.
LINE
OR HOT 1
GREEN
LINE-BLACK
GROUND-GREEN
NEUTRAL-WHITE
DIM (-) GREY
DIM (+) VIOLET
NEUTRAL
OR HOT 2
VIOLET
GREY
SUPPLY WIRING
(DIMMING OPTIONAL)
LUMINAIRE
TERMINAL
BLOCK
9
Cable
Boss
Air Craft
Cable
View of the Back
of CPY250TM
CPY250TM
Hub
STEP 10:
Attach the Air Craft Cable to the cable boss
on the back of the CPY250TM luminaire and
attach the other end of the Air Craft Cable to
the Adapter Plate with supplied #8 screws
to 30 in-lb torque. Then carefully let the
CPY250TM luminaire hang down for wiring.
See Figure 9.
STEP 11:
Make wiring connections between the
CPY250TM luminaire and the leads coming
out of the center of the Adapter Plate per the
“Electrical Connections” section.
STEP 12:
Position the CPY250TM luminaire over the
Adapter Plate, carefully push excess leads
through the Adapter Plate hole into the 304
driver cavity.
STEP 13:
Align the CPY250TM mounting holes with
the mounting holes in the Adapter Plate
and insert (4) 3/4" long 5/16" drive supplied
fasteners. Secure the CPY250TM luminaire by
tightening the (4) 5/16" drive fasteners to 30
in-lbs torque. See Figure 10.
NOTE: (1) 1"long 5/16" drive fastener is
included in hardware bag if needed to draw
CPY250TM closer to Adapter Plate in the event
of an uneven canopy surface.
10
(4) Mounting
Holes Adapter Plate
(4) 5/16"
Drive
Fasteners
