▲
▲
Item
1312
Chapter 4
External channel (OSD) Setting
OSD menu control
The projector external channel has screen display (OSD)setup menu
can be used to adjust and change the settings.
Four submenu in OSD menu :
Picture- Adjust the image quality in this menu.
Sounds Adjust sound effect in this menu.-
Setting Adjust menu display time in this menu.-
Time Setting automatic switch time.-
If you want to to adjust the Settings menu,
please perform the following steps:
1. Press key to enter the OSD menu and
then press choose the menu need to setting.
2. Press ▲ or ▼ button，choose the item need
to adjust and then press OK to entry.
3. Press or button set parameters.
4. Press to save setting.
Instructions
Picture mode
Color Temperature
Zoom Mode
Image noise reduction
MPEG noise reduction
PC iamge adjust
Setting picture display mode,adjust picture effect.
(User,Bright, Standard Soft )
Adjust the image display different color temperature.
(standard warm cold)
Adjust the image display aspect ratio.
(Automatic point-to-point 16:9 4:3)
Setting reduce noise level
(Low Middle High Automatic Off)
Setting reduce noise level (Low Middle High Off)
Setting reduce noise level (Low Middle High Off)
Chapter 5, Maintenance
Cleaning the Projector
Cleaning the projector to remove dust and grime will help running normally.
Warning:
1 Before cleaning, turn off the projector and unplug the power cord. Otherwise,
it may result in injury or damage to the system.
2. When cleaning ,you should only use a damp cloth . Do not allow water to enter
the ventilation of the projector.
3. If a little water enter the interior of the projector when cleaning, please don’t
connect the projector to power ,the projector should be placed in a well ventilated
area for several hours before using.
.
Cleaning the Lens
Cleaning fluid of optical lens can be purchased from most camera stores and other
retail shops. To clean the projector lens, perform the following steps:
Note：
1. Do not use abrasive cleaners or solutions.
2. To prevent discoloration or fading, do not let the cleaning liquid contact projector
cabinet.
Note：
Some parameters need to adjust it in user mode.
Because of the different signal sources, OSD items could be settled will be
different . For example, when the projector is connected to PC via VGA , user can
alter the " "horizontal position/vertical position" of "picture> PC image adjust" menu.
If connected to other signal source , this setting could not be changed and
display by gray color.
Simple Troubleshooting
The operation of the machine is very simple , generally in use will not encounter any
problems . Sometimes on the operation and connection of peripheral equipment of the
machine will caused by some fault illusion, please refer to the following for
troubleshooting. If malfunction cannot be solved in the end, please contact the
company's after-sales service.
After-sales service no：+86 731-83751062
product specif i c a tionproduct specif i c a tion
▲
