Consort WMH3RX Manuel

58000361 Iss 02

MAINTENANCE

ALWAYS ENSURE THAT THE MAIN EXTERNAL ELECTRICAL SUPPLY IS SWITCHED OFF BEFORE ANY

MAINTENANCE IS CARRIED OUT.

To obtain the best results from the heater, it is necessary to avoid any accumulation of dust or dirt

within the unit or on the air inlet grille. The unit should be cleaned regularly.

SAFETY

This equipment has been designed and manufactured to the highest international standards but, like

all electrical appliances which are operated by mains voltage, care must be taken if you are to obtain the

best results and safety is to be assured.

NOTE: The appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge unless they have been given

supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Do NOT use this appliance in bathrooms or where similar conditions of excessive moisture are

present.

No NOT handle the appliance with wet hands.

Do NOT use the appliance in an enclosed room so small that the heater will generate ambient

temperatures in excess of 300C.

Do NOT use the appliance with young children unattended.

Do NOT use the appliance in rooms where excessive dust is generated or present.

Do NOT touch THE outlet grille when appliance is in use.

Do NOT cover or restrict any aperture of the appliance when in use.

Do NOT use the appliance if damaged.

If the appliance has been kept in freezing conditions, run at cold/fan setting for 5 minutes before

using heat settings.

This appliance meets the requirements of EU Directive 98/336/EEC for EMC.

GUARANTEE

This guarantee is offered to you as an extra benefit and does not affect your legal rights.

All electrical appliances produced for the Company are guaranteed for one year against faulty

material or workmanship. This applies only if the appliance has been used for purposes in accordance

with the instructions provided and has not been connected to an unsuitable electricity supply, or subject

to misuse, neglect, damage or modified or repaired by any person not authorised by us.

The correct electricity supply voltage is shown on the rating label attached to the appliance.

Please retain your receipt as proof of purchase.

CUSTOMER HELPLINE

Should you need any advice on the use of your new Consort product, or should you require service or

repair, please contact our Helpline:

Operating hours: Mon to Thu 8.30am to 4.30pm | Fri 8.30am to 3.30pm

Consort Equipment Products Limited

Thornton Industrial Estate, Milford Haven, Pembrokeshire, SA73 2RT

Tel: 01646 692172 Fax: 01646 69519

Email: technic[email protected] Web: www.consortepl.com

Quality Space Heaters

INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS FOR

CHELSEA WALL MOUNTED FAN HEATER

FOR WIRELESS ELECTRONIC CONTROLS

Catalogue Numbers: WMH3RX (brushed aluminium fascia)

PLEASE RETAIN THIS LEAFLET FOR FUTURE MAINTENANCE

58000361 Iss 2

INSTALLATION

Ensure the electricity supply is disconnected from any relevant fixed wiring before

commencing the installation. The supply circuit must be adequate for the input of the

appliance and must be protected by a 13 Amp fuse.

The heater must not be located immediately below a fixed socket outlet.

There must be a minimum clearance of 600mm above the heater.

CONNECTION TO THE MAIN SUPPLY

Electrical installation should be carried out by a competent installer, preferably

registered with NICEIC (National Inspection Council for Electrical Installation Contracting) in

accordance with the 16 edition of the IEE Wiring Regulations, (BS.7671: 1992), and any

relevant Local Authority Bye-Laws.

This heater is fitted with a 3-core mains supply cable and should be permanently

connected to the electricity supply via a double pole switch having 3mm gap on each pole.

A switched fused connection unit to BS.1363 Part 4 is a recommended mains supply

connection accessory to ensure compliance with safety requirements applicable to a fixed-

wiring installation.

PROCEDURE

1. Remove the front cover (2 screws on the side and 2 screws on the bottom).

2. Mark top 2 screw fixing positions ‘A’ in accordance with the dimension shown on the

diagram. The unit must be screwed to the wall with 3 screws through the holes provided

in the case. Drill 2 holes in the wall to suit No 10 wood screws (round Head) and insert

wall plugs. At the top 2 screw positions ‘A’ screws can now be screwed in until the

heads are approximately 5mm from the wall. The unit can now be hung on these two

screws and the position of the third bottom fixing marked on the wall. Remove the unit

from the wall and drill a third fixing hole in the position marked and insert a wall plug.

The unit can now be hung on the wall and the third screw screwed in. Before tightening

all three screws ensure the unit is horizontal.

3. Refit front cover. Ensure grille bars internal/external are spaced equally.

OPERATION

This heater can only be used when connected to a CRX2 wireless programmable timer.

Each CRX2 can control any number of heaters. The heater has an indicator light positioned

behind the fascia panel on the top right side. The light may be:

Green -when no heat is needed

Yellow -when some heat is needed to maintain the room temperature

Red -when the heater is on full power

Fast Flashing Red - when the heater has overheated and the Electronic Safety Control

has switched the heater off.

Please refer to the CRX2 user and operating instructions for full operational details.

ELECTRONIC SAFETY CONTROL

The appliance is fitted with an Electronic Safety Control (ES). This is a safety device,

which switches the heater off if, for any reason, the appliance overheats. Overheating is

indicated by a fast flashing red light. The ES control can only be re-set after the appliance

has cooled down. In order to re-set the ES control, proceed as follows:

Switch the appliance off at the mains by using the isolator switch and leave to cool

down for approximately 5 minutes.

Switch appliance back on and the ES control will re-set.

Ensure that the appliance is functioning correctly. If the ES control operates again,

the appliance should be checked by a competent electrician.

Autres manuels Consort Chauffage

Consort

Consort RWH2S Manuel

Consort

Consort HE7915G Manuel d'utilisation et d'entretien

Consort

Consort Frost Fighter Manuel utilisateur

Consort

Consort CN2MLSTiERF Manuel d'utilisation et d'entretien

Consort

Consort PLSTi050ERF Manuel d'utilisation et d'entretien

Consort

Consort PLSTi050E Manuel d'utilisation et d'entretien

Consort

Consort HE6502SL Manuel d'utilisation et d'entretien

Consort

Consort Claudgen HE6137E Manuel d'utilisation et d'entretien

Consort

Consort PLSTi150RX Manuel d'utilisation et d'entretien

Consort

Consort LST500ERF Manuel d'utilisation et d'entretien

Consort

Consort PRX050SS Manuel d'utilisation et d'entretien

Consort

Consort WMH3E Manuel d'utilisation et d'entretien

Consort

Consort DF2SL heatflow Manuel utilisateur

Consort

Consort CN1LSTW Manuel utilisateur

Consort

Consort UHA05 Manuel d'utilisation et d'entretien

Consort

Consort CN2MLSTiE Manuel d'utilisation et d'entretien

Consort

Consort CN2LSTRX Manuel utilisateur

Consort

Consort CN1LSTRX Instructions d'utilisation d'origine

Consort

Consort QZWP15N Manuel d'utilisation et d'entretien

Consort

Consort BFH2SL Manuel d'utilisation et d'entretien

Consort

Consort CN1LST Mode d’emploi

Consort

Consort CHELSEA WMH3 Manuel

Consort

Consort WMH3RX Manuel utilisateur

Consort

Consort CSL2SC Manuel d'utilisation et d'entretien

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur