G:\Masters\Installation Sheets\Laser\L40P L80P Installation Sheet.doc
Page 3 of 16
1. Conditions of use
Read this manual completely before working on or making adjustments to the Compac
equipment.
Compac Industries Limited accepts no liability for personal injury or property damage resulting
from working on or adjusting this unit incorrectly or without authorisation.
Along with any warnings, instructions, and procedures in this manual, you should also observe
any other common sense procedures that are generally applicable to equipment of this type.
Failure to comply with any warnings, instructions, procedures, or any other common sense
procedures may result in injury, equipment damage, property damage, or poor performance of
the Compac equipment
The major hazard involved with installing and operating the unit is electrical shock. This hazard
can be avoided if you adhere to the procedures in this manual and exercise all due care.
Compac Industries Limited accepts no liability for direct, indirect, incidental, special, or
consequential damages resulting from failure to follow any warnings, instructions, and
procedures in this manual, or any other common sense procedures generally applicable to
equipment of this type. The foregoing limitation extends to damages to person or property caused
by the unit or damages resulting from the inability to use the unit including loss of profits, loss of
products, loss of power supply, the cost of arranging an alternative power supply, and loss of
time, whether incurred by the user or their employees, the installer, the commissioner, a service
technician, or any third party.
Compac Industries Limited reserves the right to change the specifications of its products or the
information in this manual without necessarily notifying its users.
Variations in installation and operating conditions may affect the unit's performance. Compac
Industries Limited has no control over each installation's unique operating environment. Hence,
Compac Industries Limited makes no representations or warranties concerning the performance
of the unit under the actual operating conditions prevailing at the installation. A technical expert of
your choosing should validate all operating parameters for each application.
Compac Industries Limited has made every effort to explain all servicing procedures, warnings,
and safety precautions as clearly and completely as possible. However, due to the range of
operating environments, it is not possible to anticipate every issue that may arise. This manual is
intended to provide general guidance. For specific guidance and technical support, contact your
authorised Compac supplier, using the contact details in the Product Identification section
Only parts supplied by or approved by Compac may be used and no unauthorised modifications to
the hardware of software may be made. The use of non-approved parts or modifications will void
all warranties and approvals. The use of non-approved parts or modifications may also constitute
a safety hazard.
Information in this manual shall not be deemed a warranty, representation, or guarantee. For
warranty provisions applicable to this unit, please refer to the warranty provided by the supplier.
Unless otherwise noted, references to brand names, product names, or trademarks constitute the
intellectual property of the owner thereof. Subject to your right to use the unit, Compac does not
convey any right, title, or interest in its intellectual property, including and without limitation, its
patents, copyrights, and know-how.
Every effort has been made to ensure the accuracy of this document. However, it may contain
technical inaccuracies or typographical errors. Compac Industries Limited assumes no
responsibility for and disclaims all liability of such inaccuracies, errors or omissions in this
publication.
