Installing Tank Thermostat
The Tank Thermostat is typically installed and aached to
your hot water tank/cylinder. It is set up using Bluetooth
and connects wirelessly to your home Wi-Fi network. The
Tank Thermostat is aached directly to the cylinder while
the sensor facing the cylinder wall. The adhesive mounts
and cables hold the Thermostat firmly for accurate
temperature reading.
If you’re installing a cylinder thermostat
for the first time, cut- away a small piece
of cylinder insulation about 3cm in
diameter to allow your Tank Thermostat
sensor to face the surface of your hot
water cylinder.
Loop one cable tie through one hook of
the Thermostat case and then through
one adhesive mount before tying loosely.
With the sensor positioned over the
opening in the tank insulation, aach
adhesive mount to the cylinder. Repeat
for each cable tie.
Connect heat resistant
USB-C cable to Tank
Thermostat
1
2
3
Steps:
10
