ClodPi Labs ATOM Hub Manuel utilisateur
How to install battery in to ClodPi Labs ATOM Hub for Home Assistant?
ClodPi Labs ATOM Hub for Home Assistant does not come with pre-installed battery. Before you start using the ATOM Hub device, battery
installation has to be done. Below are the suggested steps to install / replace the battery
Pre-Requisite:
1) We need to open up the ATOM Hub enclosure using a screw driver (PH0 / PH1)
2) Buy locally a battery “CR2032”, 3 Volts.
Steps:
1) Take the device, do not connect to power and internet.
1
2) Keep the device upside down
3) Remove the rubber feet.
4) Take a screw driver (PH0 / PH1) and remove all the four screws
5) Cautiously pick the device and keep it in a way with cover is at the top
6) Remove the top cover
7) Observe a battery slot labelled U10 (highlighted in blue –adjacent image)
2
8) Battery placement:
•Remove the battery from the package
•Slide it intothe battery slot as shown inadjacent image with battery slipping
under the two teeth.
3
•Hold the ATOM Hub base board from the left side firmly.
•Push the battery from right side and press.
•The battery should get fixed int o the slot.
9) Place the top cover
10)Keep the device upside down
11)Tighten all the 4 screws
12)Place back all the 4 Rubber Feet
13)Keep the device with cover on the top. Your device is ready to use again.
Autres manuels pour ATOM Hub
1
Autres manuels ClodPi Labs Changer
