Clevertronics LIFELIGHT-2PRO-SMS-600 Instructions d'installation et d'utilisation

1942090 V1.33 March 2020

Clevertest and Clevertest Plus

Refer to the supplementary operation guide supplied with the Product.

After Power ON, the Status LED on a Clevertest Plus enabled fitting will display a rapid Green or Red

flashing for a period up to 2 minutes.

Zoneworks and DATA Monitored Options

Lifelights with part numbers LLIFE-2PRO-ZW-SMS, LLIFE-2PRO-DATA-SMS are fitted with Zoneworks

communications modules (nodes). These fittings are monitored using either Powerline Carrier Technology

that utilising the power cable to provide data communication or a dedicated data cable to/from data routers

installed on a dedicated data trunk connected to a central Server

(can also be connected via

Ethernet/Internet/Fibre). Zoneworks software on the server is used to monitor, coordinate testing and

collate test data from each Lifelight. Zoneworks Lifelights can be commissioned by a single push of the test

switch or scanning of the supplied barcode. The LED Test Switch indicator provides a multifunction

indication of the status of the Lifelight during testing and normal operation:

State

LED Operation

Commissioned LED on Solid (Green)

Un-commissioned LED flashes at 0.5Hz (0.5s Green, 0.5s Yellow)

Emergency Light Test In Progress LED flashes at 3s On (Yellow) & 0.5s Off

In the case of the DATA version a 2-way “figure 8” cable and terminal block facilitates the connection to the

DATA network via a multi-drop bus (daisy chain connection). For further information of installation of a

Zoneworks system, please refer to the Zoneworks Users Guide and Commissioning Guide (incl. DATA

version)

DALI EM Option

Lifelights with part numbers LLIFE-2PRO-DALI-SMS are fitted with DALI modules (nodes) that facilitate

connection and integration to 3rd Party Lighting Control Systems.

Before installing the

LLIFE-2PRO-DALI-SMS please confirm that the Lighting Control System has the capability to monitor

DALI Emergency Luminaires. The LLIFE-2PRO-DALI-SMS will be addressed and configured into the

control system by the Lighting Control System Commissioning Technicians and not Clevertronics.

State

LED Operation

Commissioned/ Un-commissioned LED on Solid (Green)

Emergency Light Test in progress LED flashes at 1s On (Yellow) & 1s Off

“IDENTIFY COMMAND” Fitting goes into emergency mode for 10 seconds

A 2-way “figure 8” cable and terminal block facilitates the connection to the DALI network OR a 5/6way

“structured wiring system” lead and plug facilitating the power and DALI connection. DALI connections

are marked as Da Da.

LIFELIGHT-2PRO-SMS-600

Surface Mount Emergency Luminaire

Installation & Maintenance Instruction Leaflet

Victoria (Head Office & Manufacturing)

Website:

www.clevertronics.com.au

Email:

info@clevertronics.com.au

Phone:

+61 3 9559 2700

Fax:

+61 3 9559 2799

New South Wales

Phone:

+61 2 8805 6400

Fax:

+61 2 8805 6444

Queensland

Phone:

+61 7 3442 9700

Fax:

+61 7 3442 9777

South Australia/Northern Territory

Phone:

+61 8 8301 8800

Fax:

+61 8 8351 8286

Western Australia

Phone:

+61 8 9248 3720

Fax:

+61 8 9248 3725

New Zealand

Phone:

+64 800 548 448

Designed in Australia to comply with the requirements

of AS2293.3: 2005 and AS/NZS CISPR15: 2011

NOTE: Standard product codes with this symbol are

enabled with Clevertest Plus capability. Please refer to the

operation guide supplied with the product for details.

Models: LLIFE-2PRO-SMS-xx-600-yy

Testing:

Options:

Manual Test

xx = Blank

BLK

yy = BLK

Zoneworks

xx = ZW

Z/W DATA

xx = DATA

DALI Comp.

xx = DALI

Clevertest

xx = CT

(NOTE: -CT Products supplied with the Clevertest Plus Symbol are activated with

Clevertest PLUS capability. Please refer to the operation guide supplied with the product for

Spare Parts:

1530230 Battery, L10 3.3V 5Ahr, 200mm Lead Bracket

1100869 Lifelight Pro Head Assembly, Ld:280mm,Rnd,LT,Gen 2

LLIFE-PRO-CKIT-NP Lifelight Pro,Control Only,Batten,L10, NP

Important:

It is illegal for anyone, except for a licensed electrician to install or maintain this product. Before

installation, ensure that the electricity supply has been switched off and isolated.

Installation must be

carried out in accordance with the relevant Australian and International Standards.

1942090 V1.33 March 2020

Initial Testing:

When the

LIFELIGHT 2PRO unit is connected to the un-switched active, it

must be allowed to charge the

battery for at least 24 hour

s. The emergency lamp only illuminates during a power failure. Conduct the

following tests:

•

During the first commissioning test the emergency lamp must illuminate for at least 2 hours after

disconnection from the main supply. The results of all tests are required to be recorded in a service

logbook, which is to be kept on-site at all times. If the unit fails to illuminate for the requisite time,

remedial action must be taken to repair the situation and once completed, the unit must pass a

subsequent test.

•

Press and hold Test Button for each LED head

or switch Off Mains Supply, check that the emergency

lamps are On.

•

Release the Test Button or Switch on Mains Supply, check that the emergency lamp is Off

(Non-maintained operation).

Below are a list of

common problems and their possible causes:

Fault:

The Green LED indicator is not illuminated.

Check:

A.C. is connected and is turned on.

Battery is connected.

Test Switch for damage.

Fault:

Lamp does not illuminate in emergency mode.

Check:

A.C. is connected.

Lamp is correctly inserted.

Battery is connected

Fault:

Lamp illuminates in emergency mode, but only stays on for a short period.

Check:

Battery has been allowed to charge for at least 24 hours.

Battery for damage.

Rated Emergency Lumen Output

in accordance with AS2293.1 (refer to

spacing tables for installation positions)

Refer to the Technical Label for classification information.

Caution:

On many building sites, power

circuits may be cut off in an uncontrolled and repetitive basis during

construction. As a result, any Exit & Emergency Units, on these circuits, will have their batteries discharged

or “cycled”. The battery in this fitting has been selected to give excelle

nt long-life performance in a

controlled AS2293 testing environment. Excessive battery cycling will reduce through

life performance and

may lead to premature battery failure. Battery warranty claims, as a result of such abuse, are specifically

EXCLUDED fro

m Clevertronics warranty terms.

Warranty:

For Product Warranty information and Terms and Conditions of Sales please refer to our website

http://clevertronics.com.au/terms

-conditions-sale-australia-nz/

Installation:

This

LIFELIGHT-2PRO-SMS Surface mount non-maintained Emergency Luminaire

can be installed on

solid

or T-BAR ceilings or used to replace an existing unit.

•

Locate the installation position.

•

Refer Images and Dimensions below for the Cut-out Hole and other dimensions.

•

Pre-drill mounting holes

•

Mount base plate and use suitable fixings to secure the base plate into the pilot holes

•

Bring in supply cables via the rear entry hole or via the end of the base plate (surface mount

conduit entry)

•

Terminate the supply cables to the L, N & E terminals (in the case of the –DALI or –

DATA fittings

terminate the DALI or DATA cable to the terminals marked Da Da or DATA).

•

Install the top cover, containing the control gear, ensuring to reconnect the control gear assembly

to the connector from the supply terminal block

•

Ensure the Battery is connected

•

Screw the cover to the base plate and, in the case of side/conduit entry remove the knock-out at

the end of the cover.

•

If the CTP capabilities are activated, please affix the CTP status label to a visible surface

and Four

Segment Marking on the product will include an ‘’F’’ in third segment block.

Networking:

When installing th

e product on a monitored network, (ZONEWORKS, DATA, DALI) simply insert the

relevant Smart Node PCA.

Autres manuels Clevertronics Équipement d'éclairage

Clevertronics

Clevertronics LP LIFELIGHT-2PRO-SMS-600 Manuel utilisateur

Clevertronics

Clevertronics FVP2LED-P Series Guide de maintenance et de service

Clevertronics

Clevertronics CleverEVAC L10 UltraBlade Pro Dynamic Red Instructions d'installation et d'utilisation

Clevertronics

Clevertronics L10 LIFELIGHT PRO Instructions d'installation et d'utilisation

Clevertronics

Clevertronics LP LIFELIGHT CLIFE-RECSP Series Instructions d'installation et d'utilisation

Clevertronics

Clevertronics L10 LWPLIFE PRO Series Instructions d'installation et d'utilisation

Clevertronics

Clevertronics L10 LWFLED 2IPREM Series Mode d’emploi

Clevertronics

Clevertronics L10 Argonaut PLUS Manuel utilisateur

Clevertronics

Clevertronics L10 Lifelight Pro LWPLIFE-PRO-WM Series Instructions d'installation et d'utilisation

Clevertronics

Clevertronics LP CWP2LIFE-PRO-WPPOD Series Instructions d'installation et d'utilisation

Clevertronics

Clevertronics L10 Ultrablade Pro LUBPRO-SM Series Mode d’emploi

Clevertronics

Clevertronics L10 Supalite LFLLED Series Manuel utilisateur

Clevertronics

Clevertronics L10 LJELED-40 Series Manuel utilisateur

Clevertronics

Clevertronics Nifty Lifelight Surface Mount Instructions d'installation et d'utilisation

Clevertronics

Clevertronics FBKLED Series Instructions d'installation et d'utilisation

Clevertronics

Clevertronics LP Cleverfit Pro CCFPRO Series Instructions d'installation et d'utilisation

Clevertronics

Clevertronics TS Trade Series Instructions d'installation et d'utilisation

Clevertronics

Clevertronics FBS2LED-DIF Series Manuel utilisateur

Clevertronics

Clevertronics CLP LIFELIGHT PRO Caractéristiques techniques

Clevertronics

Clevertronics Argonaut PLUS Guide de maintenance et de service

Clevertronics

Clevertronics L10 LJWELED-40 Series Manuel utilisateur

Clevertronics

Clevertronics ECFLED-LI-TH Series Instructions d'installation et d'utilisation

Clevertronics

Clevertronics ECFLED-LI Instructions d'installation et d'utilisation

Clevertronics

Clevertronics L10 ARGOPRO-1200-L10POD Series Manuel utilisateur

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur