ClearCube A1010 Manuel utilisateur

Quick Start Guide

ClearCube Technology 8834 Capital of Texas Hwy N Austin, Texas 78759 voice 512 652 3500 www.clearcube.com

The A1010 single-processor blade allows upgrading the memory from

the factory configuration of 512 MB to as high as 4 GB. For optimum

compatibility, always use memory modules from ClearCube.

MEMORY CONFIGURATIONS

The A1010 features four memory slots that accept 184-pin DDR400

SDRAM DIMMs. The memory is organized in two pairs of sockets, and

can operate in interleaved or non-interleaved memory mode. Use only

non-ECC, non-registered memory with the A1010 blade.

The A1010

can work with a single DIMM, as well as with a combination

of DIMMs of different sizes and speeds. When equal size DIMMs are

used in pairs, the memory controller on the A1010 uses interleaved

memory to give better performance.

The memory channels are color-coded. Channel A has blue sockets.

Channel B has black sockets. ClearCube recommends populating

Channel A first.

Note: Using mismatched DIMMs incurs a performance penalty. With

equal-sized DIMMs, a mismatch in speed or timing causes the system

to run at the slower of the two DIMMs. With mismatched sizes, the sys-

tem always runs in non-interleaved mode at the slower speed or timing

of the two DIMMs.

A1010

Memory Upgrade

DIMM_A1

DIMM_A2

DIMM_B2

DIMM_B1

Channel A – Populate First Channel B – Populate Second

A1010 Blade

ClearCube Technology 8834 Capital of Texas Hwy N Austin, Texas 78759 voice 512 652 3500 www.clearcube.com

G020089-A rev 8/15/2006

RoHS

WEEE Disposal Guidelines

In the European Union, this electronic

product falls under the European

Directive (2002/96/EC) WEEE. When it

reaches the end of its useful life or is

no longer wanted, it should not be dis-

carded with conventional waste, but

disposed of at an approved designated

recycling and/or treatment facility.

Laws are different in each country, so

please check with your local authori-

ties for proper disposal instructions.

For assistance, contact ClearCube at

[email protected]

UPGRADING MEMORY

Observe suitable anti-static procedures whenever you work on blades. To

upgrade memory for an A1010, do the following:

1. Power down the blade, and remove it from the A3000 chassis.

CAUTION: Some surfaces may be hot.

2. Place the blade on a suitable flat surface.

3. Remove the three 6-32 screws that retain the top cover.

Slide the top cover back and rotate to remove from chassis.

5. Pull the tabs on the sides of the memory socket away from the DIMM

socket. If necessary, remove any existing memory.

6. Insert each new DIMM into its socket, pressing gently to seat it com-

pletely. Push the tabs on the sides of the memory socket toward the DIMM

so that they latch.

7. Replace the top cover panel, ensuring that the side walls of the cover are

on the outside of the flanges on the base frame.

8. Replace the three 6-32 screws that retain the top cover.

9. Replace the blade in the A3000 chassis.

10. Replace the bezel.

11. Depress the power button on the back of the blade to power it on.

For more information about the A1010 blade and A3000 chassis system,

please see the A Series Data Center Products User’s Guide or contact

ClearCube Technical Support.

Email: [email protected]

Website: support.clearcube.com

In the US (866) 652-3400

Outside the US +1 (512) 652-3400

Autres manuels pour A1010

Table des matières

Autres manuels ClearCube Serveur

ClearCube

ClearCube I9420 Manuel utilisateur

ClearCube

ClearCube C7424 Manuel utilisateur

ClearCube

ClearCube MVX Mode d’emploi

ClearCube

ClearCube CD8620 series Manuel utilisateur

ClearCube

ClearCube R4300 Manuel utilisateur

ClearCube

ClearCube M2010S Manuel utilisateur

ClearCube

ClearCube R1350 Manuel utilisateur

ClearCube

ClearCube R2200 Mode d'emploi

ClearCube

ClearCube A1410 Manuel utilisateur

ClearCube

ClearCube R1200 Manuel technique

ClearCube

ClearCube A1010 Manuel utilisateur

ClearCube

ClearCube V5340 Manuel utilisateur

ClearCube

ClearCube I8800 Manuel technique

ClearCube

ClearCube A6108 Manuel utilisateur

ClearCube

ClearCube CD7424SFPST Manuel utilisateur

ClearCube

ClearCube SmartVDI-110 Manuel utilisateur

ClearCube

ClearCube R3040S Manuel utilisateur

ClearCube

ClearCube R1200 Manuel utilisateur

ClearCube

ClearCube I8442 Manuel utilisateur

ClearCube

ClearCube I8020 Manuel utilisateur

ClearCube

ClearCube R2200 Manuel utilisateur

ClearCube

ClearCube I8330 Manuel utilisateur

ClearCube

ClearCube I9420 Manuel utilisateur

ClearCube

ClearCube I8440 Manuel utilisateur

Manuels Serveur populaires d'autres marques

HP AlphaServer ES47 Manuel utilisateur

Dell

Dell PowerEdge R410 Manuel utilisateur

PowerNAS

PowerNAS CMA Manuel utilisateur

Supero

Supero FatTwin F617R3-FT Manuel utilisateur

MSI

MSI P1-109N-L70 Manuel utilisateur

Dell

Dell PowerEdge XE9640 Manuel

Dell

Dell PS4100 Instructions de montage

EtroVISION

EtroVISION EV3151 Manuel utilisateur

NEC

NEC Express5800/T110j Manuel utilisateur

HP ProLiant Gen9 Manuel utilisateur

Compaq

Compaq ProLiant 3000 Manuel

Dell

Dell PowerEdge 3YPMN Manuel utilisateur

iRobo

iRobo IPC2U Manuel utilisateur

Nortel

Nortel 1000 Con?guration guide Manuel utilisateur

Asus

Asus AP7500 Manuel d'utilisation et d'entretien

Avid Technology

Avid Technology AirSpeed 5000 Manuel utilisateur

HP Integrity rx2600 Guide d'installation

Milestone

Milestone Husky IVO 350T Manuel utilisateur