
9
Adjustment Button
Please remove the grommet before making the adjustment.
Adjusting The Black Drop
We only recommend the experienced AV installer to undertake below procedures:
Downwards
Ensure that the screen is in the CLOSED
Stand in reach of the screen while holding the RF remote.
Press the DOWN button of the RF remote, when the screen goes down about to the desired
position, press the adjustment button.
Press the adjustment button repeatedly until the screen reaches the desired position.
Press the UP button of the RF remote to save the settings.
Upwards
Ensure that the screen is in the OPENED
Stand in reach of the screen while holding the RF remote.
Press the UP button of the RF remote, when the screen goes up about to the desired position,
press the adjustment button.
Press the adjustment button repeatedly until the screen reaches the desired position.
Press the DOWN button of the RF remote to save the settings.
CAUTION: To avoid the bottom bar from going too far into the casing, please follow
the above procedures with strict accordance.
It is the responsibility of the installer to verify drop and retraction limit controls. We only
recommend that experienced AV installers adjust the motor limits of the projection screen.
The upper limit should never be adjusted - it controls the point at which the screen stops
Improperly adjusting the limits of the motor will cause damage to the screen and motor and
will void all warranty.