CiDRA SMARThatch Guide de démarrage rapide
Contact Information:
Concrete Quality Measurement
Batch Plant to Job Site
smarthatchsupport@cidraconcrete.com
© CiDRA Concrete Systems 21941-01-EN Rev 02
If you have any questions/concerns, please contact us:
Technical Support Line: +1.203.626.3430
or E-mail below
© CiDRA Concrete Systems 21941-01-EN Rev 02
SMART Driver Notes:
hatch
Reset Water Add Meter, Rev Counters and Batch Timer:
• Every time the truck cycles power, the water add meter,
revolution counter and batch timer, will automatically reset
• Driver can reset these features at any time by pressing
menu button #1, then button #2
Resetting
Counters
Swapping Batteries:
• Battery in hatch lasts 7-8 days. Swap battery from cab
with sensor battery every Monday morning. Sensor
battery can be accessed via the (4) ¼ turn screws
• Insert new battery foam side first – then gently insert
female terminals into male terminals
In-cab charger Battery in sensor
Insert foam
side first
To Get Volume Reading:
Same 9 revolutions criteria as air and temperature applies
for establishing volume from 1- 5cy
• Park the truck on FLAT ground
• Drum must be turning SLOW enough (1-6 RPM)
• If this criteria is met and there is less than 5cy in the drum,
the volume will report on the In-Cab Display and on the Portal
• For small volumes approximately 2cy or less, turning the drum
slower 1-2 rpm may be needed to obtain a reading
Volume is on
page 2
Press either arrow for page 2
To Get Air Reading:
9 Revolutions at 5 rpm in the yard or at job site to get Air and Temp in < 2 min
Drive to job normally at 1-2 rpm. Will get updated info with each drum rev. Countdown
Display page 1
Autres manuels CiDRA Instrument de mesure
CiDRA
CiDRA AIRtrac Instructions d'installation
CiDRA
CiDRA Sonartrac GVF-100 Manuel d'installation et d'exploitation
CiDRA
CiDRA SMART HATCH Manuel utilisateur
CiDRA
CiDRA CYCLONEtrac PST Manuel utilisateur
CiDRA
CiDRA SMARThatch Manuel d'utilisation et d'entretien
CiDRA
CiDRA SONARtrac 20924 Manuel utilisateur
CiDRA
CiDRA CYCLONEtrac PST Manuel utilisateur
Manuels Instrument de mesure populaires d'autres marques
Endress+Hauser
Endress+Hauser Proline Promag 50 Caractéristiques techniques
Siemens
Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces
KLINGER
KLINGER CMF V Series Manuel utilisateur
EXFO
EXFO FTB-2 Manuel d'exploitation et d'entretien
Keysight
Keysight M8290A Manuel utilisateur
ADTEK
ADTEK MW-5 Manuel utilisateur