Celestron FirstScope 90EQ Manuel utilisateur

Use the three tightening screws located at the

bottom of each leg to secure the extended legs

in place.

To set up the tripod, spread the legs outward

until they are fully extended. Extend the center

portion of each of the three tripod legs down 6-

8".

Item #31132

Quick Set-up Guide

123

All three legs should be the same length to

provide a level platform for the telescope.

Locate the equatorial mount and place the

base of the mount through the hole in the

center of the tripod mounting platform.

Properly assembled, the accessory tray should

appear as pictured above.

From underneath the tripod mounting platform,

thread the mounting bolt with washer into the

threaded hole on the bottom of the equatorial

mount.

Thread the attached latitude adjustment screw

into the equatorial mount until the screw is

touching the inside of the mount and the

mount can no longer pivot up and down.

FirstScope 90EQ

Your FirstScope 90 EQ includes: optical tube w/

tube rings attached; tripod with center support

bracket; equatorial mount; two eyepieces;

StarPointer finderscope; 5 lb. counterweight;

counterweight bar; two slow motion cables; star

diagonal; accessory tray; documentation including

an owner’s manual, The Sky™ CD Software.

Item# 21085

Place the accessory tray on top of tripod's

center leg brace. Thread the tray into the

threaded hole in the center of the leg brace.

Questions or Problems with Set-up?

CONTACT:

Celestron Technical Support: 310.803.5955

Quick Set-up Guide [cont]

Locate the counterweight bar and

counterweight. Slide the counterweight half

way down the counterweight bar and tighten

the locking screw to secure in place.

Thread the threaded end of the counterweight

bar into the Dec axis of the equatorial mount.

The other cable attaches to the Declination

axis as pictured above.

Place the telescope tube on the equatorial

mount so that the tube is facing forward as

pictured above.

Slide the tube onto the mount as shown

above. Secure tube in place by tightening the

bolt as shown above (inset).

Locate the StarPointer finderscope. Remove

the knurled nuts on the threaded posts at the

focuser end of the telescope tube.

17 18

Loosen the set screw on the focuser so that it

does not obstruct the inner diameter of the

focuser. Remove the plastic cap covering the

end of the focuser.

19 20

Insert the chrome barrel of the 20mm eyepiece

into the focuser and tighten the set screw.

Remove the lens cap from the front of the

telescope. To observe, look through the

eyepiece as shown above.

Orient the Star Pointer so that the glass

window is facing towards the front of the tube.

Place Starpointer over the posts on the tube

and tighten it down with the knurled nuts.

Slide the chrome end of the slow motion

control cables onto equatorial mount gear

shaft.

Insert the diagonal into the focuser and tighten

the set screw.

For detailed usage information please consult your owner’s manual.

Autres manuels Celestron Télescope

Celestron

Celestron PowerSeeker2 70 Manuel utilisateur

Celestron

Celestron PowerSeeker 21007 Manuel utilisateur

Celestron

Celestron NexStar 102SLT Manuel utilisateur

Celestron

Celestron 21056-K Manuel utilisateur

Celestron

Celestron PowerSeeker 50 Manuel utilisateur

Celestron

Celestron FirstScope 80EQ Manuel utilisateur

Celestron

Celestron Compustar Manuel utilisateur

Celestron

Celestron NexStar 102SLT Fiche technique

Celestron

Celestron C4.5 Manuel utilisateur

Celestron

Celestron 91012 Manuel utilisateur

Celestron

Celestron NexStar 90GT Manuel utilisateur

Celestron

Celestron PowerSeeker 127EQ Fiche technique

Celestron

Celestron STARSENSE EXPLORER 8 DOBSONIAN Manuel utilisateur

Celestron

Celestron PowerSeeker 50 Manuel utilisateur

Celestron

Celestron NexStar 114SLT Manuel utilisateur

Celestron

Celestron NexStar 102 GT 102x1000 AZ Manuel utilisateur

Celestron

Celestron Ultima 8 Manuel utilisateur

Celestron

Celestron Wide View 52260 Manuel utilisateur

Celestron

Celestron Travel Scope 70 Manuel utilisateur

Celestron

Celestron Star-Gazer 300X Manuel utilisateur

Celestron

Celestron POWERSEEKER 80 EQ Manuel utilisateur

Celestron

Celestron CGE800 Manuel utilisateur

Celestron

Celestron 22201 Manuel utilisateur

Celestron

Celestron PowerSeeker 50 Manuel utilisateur

Manuels Télescope populaires d'autres marques

Meade

Meade 81005 Condor Manuel utilisateur

Meade

Meade 114 EQ-DS Manuel utilisateur

Meade

Meade LX200 CLASSIC Manuel utilisateur

Leica

Leica 82 HD Manuel utilisateur

EASTCOLIGHT

EASTCOLIGHT 9920 Manuel utilisateur

zoomion

zoomion Genesis 200 EQ Manuel utilisateur

TEC

TEC APO 140 Manuel utilisateur

Orion

Orion 7832 Manuel utilisateur

Carson

Carson Skelescope SK-100 Manuel utilisateur

SKY-WATCHER

SKY-WATCHER VIRTUOSO Manuel utilisateur

Orion

Orion EZ Finder 7228 Manuel utilisateur

cassini

cassini C-JRS Manuel utilisateur

nedis

nedis SCTE5060WT Manuel utilisateur

Meade

Meade Polaris 60EQ-D Manuel utilisateur

PlaneWave

PlaneWave CDK700 Manuel utilisateur

William Optics

William Optics Synta Crayford Manuel utilisateur

Orion

Orion FUNSCOPE Manuel utilisateur

Levenhuk

Levenhuk Skyline Travel Manuel utilisateur