Casa CK LUNA IS Manuel utilisateur

ISLAND HOOD

EMBRACING FINEST MOMENT

CK LUNA IS

User Manual

Safety Guidelines………………………………………………………………………………………...1

General Information…………………………………………………………………………..………….4

Installation………………………………………………………………………………………………...5

Operation…………………………………………………………………………………………...…….9

Cleaning and Maintenance……………………………………………………………….……………11

Trouble Shooting………………………………………………………………………………………..14

Warranty and Service………………………………………………………………………..…………15

Dear Customer,

Thank you for having purchased and given your preference to our product. This manual

provides a means to make full use of the features of this product. We recommend that you read

this manual for best performance and to extend the life of your appliance.

Please preserve this manual for future use, in the event that doubts arise relating to the

operation.

Packaging

•

This appliance and the packaging are produced by processes that minimize waste

and friendly to the environment.

•

Please dispose the packaging in an environmentally friendly manner

•

Please do not allow young children to play with the plastic film and packaging as

this may result in suffocation.

•

Before disposing of any old appliances, be sure to cut off the power cord so that

others will not be end angered by a defective electric appliance

Installation and Usage

•

Read this user manual thoroughly before attempting to use this

appliance.

•

This appliance is intended for domestic use only. The appliance is not

intended for use outside.

•

The appliance can only be used safely if it is correctly installed according

to the safety instructions.

•

Do not connect the appliance if there are obvious signs of transportation

damage.

•

Ensure that the appliance is installed in a location with good ventilation.

•

Installation and repair should be attempted only by qualified technical personnel.

•

Do not modify any part of this appliance.

•

This appliance may be used by children over the age of 8 years old and above and

persons with reduced physical, sensory or mental capabilities or lack of experience

SAFETY GUIDELINES

TABLE OF CONTENTS

and knowledge if they have been given supervision or instruction concerning use of

the appliance in a safe way and understand the hazards involved.

•

Children must not play with the appliance. Cleaning and user maintenance shall not

be made by children without supervision.

•

Caution: The appliance and its accessible parts can become hot during operation.

Never touch the hot parts. Allow appliance to cool down before cleaning.

•

Check that the main voltage in your area corresponds to the voltage of the

appliance shown on the rating label before plugging in.

•

The electrical connection of this appliance must be connected to earth.

Green & Yellow = EARTH

Blue = NEUTRAL

Brown = LIVE

•

Multiple plugs and extension cables must not be used. Overload is

dangerous and may cause a fire.

•

Ensure that the power supply cord is free from any heat source or sharp

objects.

•

The recommended minimum installation height from the bench top to the lower

part of the hood is 700mm and 600mm respectively for gas hob and electric hob.

•

If the instructions for the installation of gas hob is greater than the

recommended height, this has to be taken into account.

•

Ensure that the filters are cleaned or replaced at an appropriate intervals

to prevent grease deposit to build up and increases the risk of fire.

•

The appliance should be switched off and the electrical supply has to be

disconnected before any cleaning or maintenance work can be carried

out.

•

Do not flambé or grill with an open flame directly under this appliance.

Flame could be drawn up to the hood by the strong suction and may risk

the grease filter to catch fire.

IMPORTANT:

The company declines all responsibilities for any damages resulting from

improper installation or poor layout design and/or failure to adopt proper

safety measures stated in this manual.

Gas

Min.700mm

Electric

Min.600mm

Warning!!!

•

Never operate the appliance without the grease filters or if the filters are excessively

greasy

•

Do not install above a cooker with a high level grill.

•

Do not leave frying pans unattended during cooking as overheated fats or oil might

catch fire.

•

Never leave naked flames under the appliance.

•

If the cooker hood is damaged, do not attempt to use.

•

Do not flambé under the cooker hood.

•

The air must not be discharged into a flue that is used for exhausting fumes from

appliances burning gas or other fuels. Range hoods and other cooking fume

extractors may adversely affect the safe operation of appliances burning gas or

other fuels (including those in other rooms) due to back flow of combustion gases.

The gas can potentially result in carbon monoxide poisoning. After installation of a

range hood or other cooking fume extractor, the operation of open flued gas

appliances should be tested by a competent person to ensure that back flow of

combustion gases does not occur.

SPECIFICATIONS:

COMPONENT LIST:

GENERAL INFORMATION

This appliance can be installed in ducted or recirculation mode.

Ducted Mode

In ducted mode, the extractor hood fan extracts the cooking vapour and passes them through the

grease filter before it is expelled to outside atmosphere.

The grease filter absorbs the solid particles in the cooking vapors.

In this mode, only aluminum filters are installed (charcoal filter is optional).

MOUNTING OF THE V-FLAP

The image only show an example on mounting the V-flap. The outlet may vary according to different

models and configurations.

To mount the V-flap:

• Mount two half-parts 2 into the body 6;

• No.3 should be top oriented;

• Insert No. 4 to No. 5 on the body;

CONNECTION OF EXHAUST DUCT



Attach Ø150mm pipe directly to the air outlet and secure appropriately



Connect pipe to the outdoor duct

INSTALLATION

The hood can be connected as below

picture by means of an exhaust

duct(enamel, aluminum, flexible pipe or

non-flammable material with an interior

diameter of 150mm)

CEILING MOUNTING

•

The ceiling must be able to bear the weight of at least 120kg and the thickness of the ceiling must be

≧30MM, drill 1*170mm round hole in the ceiling.

•

Do ensure that there are no electrical wires, gas pipes or water pipes in the area where holes are to

be drilled.

•

The appliance should be placed at a distance of 60~70cm above the cooking surface for best effect,

see pic 1.

•

The surface of the appliance is sensitive, avoid damaging it during installation.

1. Before fitting, determine the total height of the support frame and mark the screw holes.

2. On the ceiling, mark the centre point of the appliance.

3. According to the picture of the hanging board, drill 12 holes in the ceiling for the fasteners, see pic2,

and press in the wall plugs flush with the ceiling.

4. Fasten the hanging board with 12pcs of ST6*40mm big flat screws to the ceiling, see pic 2.

5. Fix the 4 x angle irons (upper part) into the hanging board by using 8pcs of M4*10mm screws and

M4 nuts with gaskets, see pic 3.

6. Calculate the required length of the angle iron and connect the other 4 x angle irons (lower part) with

16pcs of M4*10mm big flat screws and M4 nuts with gaskets(the overlapping length of the angle iron

cannot be less than100mm), see pic 3.

7. Let one side of the exhaust duct go outside through the hole of 170mm, see pic 3.

8. Connect the inside chimney (upper chimney) to the hanging board with 4pcs of ST4*8 big flat screws.

Then put the outside chimney (lower chimney) and secure it with a hook to temporarily hold on to the

upper position for ease of subsequent installation, see pic 4.

9. Hold the appliance main body and fastening the appliance to the angle iron using 16pcs of M4*10mm

big flat screws, see pic 5.

10. Connect the exhaust duct to the outlet of the appliance.

11. Once the connection is done, remove the hook that hold on the outside chimney previously (pic.4)

and re-position the outside chimney, see pic 6&7.

HINTS FOR EXHAUST DUCT INSTALLATION

The following rules must be strictly followed to obtain optimal air extraction:

•

Keep the exhaust duct short and straight.

•

Do not reduce the size or restrict the exhaust duct.

•

Failure to observe these basic instructions will reduce the performance and increase noise level of

the appliance.

•

Any installation work must be carried out by a qualified electrician or competent person.

•

Do not connect the ducting system of the hood to any existing ventilation system which is being used

for any other appliance, such as warmer tube, gas tube, hot wind tube.

•

The angle of the bend of the exhaust duct should not be less than 120º; you must direct the duct

horizontally or alternatively, the duct should go up from the initial point and should be led to an outer

wall.

•

After the installation, make sure that the appliance is level to avoid grease collection at one end.

•

Ensure the exhaust duct selected for installation complies with relevant standards and is fire

retardant.

WARNING:

For safety reason, please use only the same size of fixing or

mounting screws which are recommended in this instruction

manual.

Failure to install the screws or fixing device in accordance

with these instructions may result in electrical hazards.

To achieve a more effective way to remove the fumes, we recommend that to switch on the appliance a

few minutes before cooking and leave it on for 5-10 minutes after cooking.

Touch Control Panel with LED Light Display:

Symbol

Indication

Delay Stop Timer

Light On/Off

Display Window

Fan Speed

Power On/Off

1. Power-on: After connecting the appliance to the main supply, all the symbol will be light up and an

audible signal will sound before the LED light is off. The appliance is on stand-by mode.

2. Touch the on/off switch once, the appliance will start operating at low speed“1”.

3. Touch the speed button to increase the fan speed 1 (low) –> 2 (medium) –> 3 (high). The

speed button is working in circulating module. To reduce the speed, touch the button

again and the speed will go back to “1” after the highest speed of “3” is selected – “1->2->3->1->2-

>3….”

4. Light button . Touch the light button to on or off the LED light.

5. Delay Stop Timer

I. The delay stop timer is working only when the appliance is in operation mode (speed 1, 2 or

3).

II. Touch the delay stop timer to enter to time delay function. The delay stop timer setting is

9 minute and the display window will show “9”with decrement by one minute. When the time

is up, the appliance will turn off automatically including the LED light.

OPERATION

Table des matières

Autres manuels Casa hotte de ventilation

Casa

Casa CK VISTA Manuel utilisateur

Manuels hotte de ventilation populaires d'autres marques

emmeti

emmeti RECUPA MED A-140 Mode d’emploi

Nibe

Nibe F135 Manuel utilisateur

Kuppersberg

Kuppersberg INTRO 60 Instructions d'installation et d'entretien

Zephyr

Zephyr Spruce AK9834BS Guide d'installation

Hisense

Hisense MH6INBG Manuel utilisateur

Miele

Miele DA 1255 Manuel utilisateur

Broan

Broan 46000 Manuel utilisateur

GE Profile PV977 Instructions originales

FALMEC

FALMEC FFRIA24W5FS Manuel utilisateur

Whirlpool

Whirlpool RH2600XL-1 SERIES Manuel utilisateur

Küppersbusch

Küppersbusch DX ISLA Manuel utilisateur

ETNA

ETNA AV360RVS Manuel utilisateur

JUNO

JUNO JDF603E6 Manuel utilisateur

Miele

Miele DA 6708 D Manuel utilisateur

Tricity Bendix

Tricity Bendix LE 150 Manuel

AEG

AEG X68163BV1 Manuel utilisateur

AEG

AEG 125 D Manuel utilisateur

Smeg

Smeg KSEV97X Manuel utilisateur