Canon Creative Park Elastic-powered Turtle Manuel utilisateur

1. Carefully cut out the parts.

2. Fold along the dotted lines, making mountain

or valley folds as indicated.

3. Attach the glue spots on each part together.

4. Glue the parts together, and you’re done!

*Please read the Assembly Instructions

carefully before you begin.

Tools

Scissors

Glue (We recommend quick-drying paper glue)

3 rubber bands (preferably brand new ones)

Actual size illustration:

check the size of your rubber bands here.

How to assemble your model neatly

Scoring along the fold lines in advance with a dried

up pen or a ruler with slightly sharp corners will result

in a neater model.

*Be careful not to press too hard as the paper may tear.

Caution

Keep scissors and glue away from small children.

Be careful not to cut your fingers when using scissors.

Scissors line

Cut in line

Glue spot

Notation Key

Assembly Instructions

About 1.57 inches in diameter

Mountain fold

Valley fold

Elastic-powered Turtle : Assembly Instructions

After gluing parts J and K together back to back,

attach the ring you have made.

Assemble all four in the same way.

Assemble the tires

Glue Glue

Fold in half along the fold lines,

glue together at the back and make a ring.

Adding curves to the part first will make it

easier to form a ring.

Back

Assemble the axle

Glue down the end after rolling.

Wind part H around and glue it down.Add curves by pressing and rolling it

against the corner of a table,

with the printed side face up.

Fold the edge to make a triangular prism,

and roll the piece up to form a stick

(about 4mm wide).

Attach part A, enveloping it

around the parts you cut

and bent back.

Attach the other side too.

View from above

Cut three, equally-spaced slots in both ends

of part C, up to the red valley fold line,

and bend them back.

*The fine strips of paper are thick and hard

so be careful of paper cuts.

Attach part M to both ends.

Follow the same process to

assemble the other axle.

Glue

Elastic-powered Turtle : Assembly Instructions

Attach the tires to both ends of the axle.

Make one more in the same way.

*Do not attach a rubber band to the other axle.

*The wheels with the rubber band should be

at the back, and the wheels without at the front.

Assemble the front and back wheels

If necessary, cut off the ends.

Tie one end of the band

to the band stopper,

and the other end

to the middle of the axle.

Cut the rubber band

to make a string.

Assemble the head and tail

Do not attach. Do not attach.

Glue together as shown in the diagram,

and assemble the turtle's head.

Glue together as shown in the diagram,

and assemble the turtle's tail.

Assemble the body

Glue together as shown in the diagram,

and assemble the turtle's body.

Glue and connect

parts E, F and G together.

Elastic-powered Turtle : Assembly Instructions

Attach the wheels

Fold along the fold lines

and glue together

at the reverse side.

Glue

Being careful not to mix up the front and back wheels,

put the axles into the grooves on the body.

Check that the wheels spin smoothly.

Attach. Attach.

Feed the band stopper through the hole

at the front of the body to the outside.

Be careful that the band doesn't come undone.

When you have got the band stopper out,

glue it in place as shown in the diagram,

and wind the wheel band around the back wheels

(the tires furthest from the band stopper).

Assemble together

Attach the turtle's head and tail

to the completed body, and you're done!

After turning the turtle's body over,

glue the tummy to it.

Elastic-powered Turtle : Assembly Instructions

How to play

Pull the car backwards along the ground, gently

pushing down on the back wheels.

Point the car in the direction you want it to run,

let it go and watch it take off!

Be careful not to wind the band too tightly

as it may snap or come untied.

Play with it on a flat surface such as a table or the floor

(wooden floorboards work better than carpet).

If your car doesn't run well, check the following points to repair it.

Are the axles or tires stuck against the body? Are the wheels or tires bent?

Has the band lost its elasticity? Is the band wound up too tightly?

Has the band come loose from the tire? Is the band tangled up around the axle?

Elastic-powered Turtle : Assembly Instructions

Table des matières

Autres manuels Canon Jouet

Canon

Canon Creative Park Nikko Toshogu Shrine Yomeimon Manuel utilisateur

Canon

Canon CREATIVE PARK Manta ray Manuel utilisateur

Canon

Canon Creative Park Pop-up Card Halloween/Black cat &... Manuel utilisateur

Canon

Canon Paper Craft Clown and sea lion acrobatics Manuel utilisateur

Canon

Canon PAPER CRAFT Moving Tiger through o ring of... Manuel utilisateur

Canon

Canon Creative Park Shaky-Shaky Maracas Manuel utilisateur

Canon

Canon CREATIVE PARK Sugar Glider Manuel utilisateur

Canon

Canon Creativ Park Manuel utilisateur

Canon

Canon Amerigo Teddy Bear Manuel utilisateur

Canon

Canon CREATIVE PARK Bottlenose Dolphin Manuel utilisateur

Canon

Canon Creative Park Toy Poodle Manuel utilisateur

Canon

Canon Paper Craft Special Vehicle 01 Series Manuel utilisateur

Canon

Canon Creative Park Paper Aquarium Clown Fish Manuel utilisateur

Canon

Canon CREATIVE PARK Pop-up card (Swings) Manuel utilisateur

Canon

Canon PaperCraft White striped longhorn beeetle Manuel utilisateur

Canon

Canon Creative Park Teddy Bear Manuel utilisateur

Canon

Canon Paper Craft Emperor Penguin Manuel utilisateur

Canon

Canon CREATIVE PARK Moving Money Box: Pig Manuel utilisateur

Canon

Canon Creative Park Rabbit Manuel utilisateur

Canon

Canon Tyrannosaurus rex Manuel utilisateur

Canon

Canon Paper Craft Circus strongman Manuel utilisateur

Canon

Canon Paper Craft Manuel utilisateur

Canon

Canon CREATIVE PARK Lion Dance Manuel utilisateur

Canon

Canon CREATIVE PARK Pop-up ABC QRSTUVWX Manuel utilisateur

Manuels Jouet populaires d'autres marques

marklin

marklin 37321 Manuel utilisateur

GREAT PLANES

GREAT PLANES Pitts M-12S Manuel utilisateur

NOCH

NOCH 14261 Manuel utilisateur

Hausler

Hausler 450 SE V2 Manuel utilisateur

Dynaflite

Dynaflite Daydream Manuel utilisateur

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manuel

Kenner

Kenner Batman 63651 Manuel utilisateur

LEGO

LEGO 8527 Manuel utilisateur

iKarus

iKarus ECO 8 Manuel utilisateur

Multiplex

Multiplex EasyStar II Mode d’emploi

Walkera

Walkera 38 Mode d’emploi

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manuel utilisateur

MD MXION SWD Manuel utilisateur

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manuel utilisateur

marklin

marklin 39671 Manuel utilisateur

Meccano

Meccano 15103 Manuel utilisateur

LEGO

LEGO TECHNIC 8735 Manuel utilisateur

Mattel

Mattel HOTWHEELS DWL04 Manuel utilisateur