Canon ImagePROGRAF W8400D Manuel utilisateur

Moving the Printer

Follow this procedure before moving the printer to protect the internal parts

during moving or shipping.

•If you cannot avoid tilting or standing the printer on end when you are

moving it, please contact the dealer where you purchased the printer

or the nearest service center.

•Before you move the printer, always execute the Move Printer menu

function and follow the directions given by the messages on the

display. The printer may be damaged if you attempt to move it after

disconnecting the power cord before switching off the printer. If you

accidentally disconnect the power cord before switching the printer off,

reattach the power cord, reinstall the ink tanks, then start the

procedure again from Step 1.

•You cannot execute Move Printer once the MTCart Full Soon or

Replace MT-Cart appears. Replace the maintenance cartridge before

executing Move Printer.

•Never tilt the printer while you are moving it. This could spill ink from

the maintenance cartridge and cause ink stains in the surrounding

area.

1 If the printer power is off, press the Power button to switch the printer

on.

After a few moments, Online appears in the display.

2 Press the Online button to display MAIN MENU.

3 Press [ ] or [ ] to select Maintenance, then press [ ].

4 Press [ ] or [ ] to select Move Printer then press [ ].

5 Press [ ] or [ ] to select Yes, then press OK.

Open RightCover is displayed.

6 Open the back right cover.

Remove Ink Tank is displayed on the operation panel.

7 Open the ink tank cover, then remove all the ink tanks.

Place each ink tank in a plastic bag and seal the bag.

Store the removed tanks with the ink supply ports facing up (a).

If the ink tanks are stored with the ink supply ports (a) facing down, ink may

leak out.

8 Lock all of the ink tank covers, then close the right cover.

Please Wait.. appears followed by Ink Draining..while the ink is sucked

from inside the tubes. This process requires about 4 minutes to complete.

The printer switches off automatically once the process is complete.

9 Disconnect the power cord, earth wire and interface cable.

10 Open the top cover, and then open the paper tray.

Do not touch any areas other than as indicated. Doing so

may damage the printer.

11Rewind the roll media back onto the roll and remove the roll holder and

the four overwind prevention stays, and then remove the paper tray.

12 Lower the holder stopper lever, remove the stopper, remove the roll

from the roll holder, then store the roll holder and the holder stopper.

13 Clamp the belt with the belt stopper then use the hex screws to

fasten the belt stopper.

Attach the belt stopper that you removed and stored during the

initial installation.

14 Close the top cover.

15 Remove the accessory pocket.

16 Tape each printer cover in the reverse order of tape removal during

setup.

17 To remove the stacker, apply the attachment procedure in reverse.

18 Apply the printer mounting procedure in reverse to unmount the

printer.

19 Apply the stand assembly procedure in reverse to disassemble and

pack the stand.

20 Reattach the tapes and shipping materials to the roll holder and

printer, then pack them in the original shipping box.

This completes the preparation for moving the printer.

Table des matières

Autres manuels Canon Imprimante

Canon

Canon Laser Shot LBP-5200 Manuel utilisateur

Canon

Canon LBP-3200 Manuel utilisateur

Canon

Canon MX490 Series Instructions d'utilisation

Canon

Canon i475D Series Manuel utilisateur

Canon

Canon imageCLASS LBP6780dn Manuel utilisateur

Canon

Canon TM-5300 Guide de configuration

Canon

Canon iP4200 - PIXMA Photo Printer Manuel

Canon

Canon S450 Manuel

Canon

Canon PIXMA MG7500 Series Guide de configuration

Canon

Canon MP-C635 Manuel utilisateur

Canon

Canon S 530D Manuel utilisateur

Canon

Canon imagePROGRAF iPF770 Manuel utilisateur

Canon

Canon i-SENSYS MF416dw Manuel de service

Canon

Canon imagePROGRAF iPF6350 Manuel utilisateur

Canon

Canon imagePROGRAF iPF810 Manuel utilisateur

Canon

Canon PIXMA MG6120 Series Manuel

Canon

Canon imageCLASS MFG500 Series Guide de configuration

Canon

Canon PIXMA TS3310 Manuel utilisateur

Canon

Canon PIXMA G5020 Guide de configuration

Canon

Canon PIXMA iP8720 Manuel utilisateur

Canon

Canon imagePROGRAF iPF765 Manuel utilisateur

Canon

Canon PowerShot A480 Manuel

Canon

Canon LASER SHOT LBP-470 Manuel utilisateur

Canon

Canon varioPRINT 6000 TITAN Series Manuel utilisateur

Manuels Imprimante populaires d'autres marques

Lexmark

Lexmark 1400 Series Manuel

Evolis

Evolis Elypso Manuel utilisateur

Kyocera

Kyocera FS-9530DN Manuel utilisateur

Samsung

Samsung BIXOLON SRP-350plusF Manuel utilisateur

Dell

Dell Color Laser Printer 2130cn Manuel utilisateur

Tektronix

Tektronix Phaser 840 Manuel utilisateur

Epson

Epson ET-7750 Mode d'emploi

Eltron

Eltron P210 Guide Manuel utilisateur

Ricoh

Ricoh MD-P1 Manuel utilisateur

Epson

Epson SC-F7100 series Manuel utilisateur

Epson

Epson Stylus C40UX Manuel utilisateur

IRA3D

IRA3D POETRY4 Manuel utilisateur

Ricoh

Ricoh Aficio AP400 Manuel utilisateur

BIXOLON

BIXOLON SRP-352plusV Manuel utilisateur

Epson

Epson Stylus Photo PX700W Instructions de montage

Ricoh

Ricoh SP204SF Manuel utilisateur

Star Micronics

Star Micronics futurePRNT TSP100 Manuel utilisateur

Epson

Epson TM-TM88V-i Manuel d'utilisation et d'entretien