C.P. Electronics Vitesse Plus Manuel utilisateur
Vitesse Plus Quick Start
Connect all detectors and switches to the LCM before following this procedure. Refer to the VITP7-MB installation guide
for details on how to do this.
CH1
CH5
CH2 CH3
CH6
CH7
CH1 CH2 CH3 CH4 CH5 CH6 CH7
CH6
Mains power supply
Master switch
Emergency
lighting
test
CH4
Use the following procedure with the UNLCDHS handset to get your Vitesse Plus installation up and running:
1
Connect the power to the LCM. It then goes through a
power-up sequence of 8 seconds, after which all
connected lights switch on.
2
Press
ON/OFF
to turn on the programming handset.
3
Select Vitesse Plus from
the main PRODUCT FAMILY
menu and press .
PRODUCT FAMILY
Rapid >
àVitesse Plus >
Handset Config >
4
Select LCM and press
or .
VITESSE PLUS
àLCM >
Detector >
Scene Panel >
5
Select Program and press
or .
LCM
àProgram >
Lux Settings >
Device Info >
6
Select Preset and type in
the number of the preset.
PROGRAM
àPreset 7
Load Type DALI
Detection
Mode Pres
7
Point the handset directly at
the device and press
. An LED flashes
red/green to acknowledge
the command, then green till
the preset is programmed.
8
Press twice to return to
the Vitesse Plus menu.
VITESSE PLUS
àLCM >
Detector >
Scene Panel >
9
Select Detector and press
or .
VITESSE PLUS
LCM >
àDetector >
Scene Panel >
10
Select Program and press
or .
DETECTOR
àProgram >
User >
Device Info >
11
Select Time Out (mins)
and enter the number of
minutes to wait (0 - 99)
before lights turn off when
absence detected.
PROGRAM
àTime Out
(mins) 10
Light Level 600
Detection
Mode No
12
Select Light Level and
enter the target lux value (0-
999) that daylight linking is to
maintain.
PROGRAM
Time Out
(mins) 10
àLight Level 600
Detection Mode No
13
Point the handset directly at
the device and press
.
14
Perform this sequence
with the centre-biased
retractive switch to
activate daylight linking:
1. Dim all the way down
2. Dim all the way up
3. Switch off
4. Switch on
Autres manuels C.P. Electronics Système de contrôle
