Buffalo Tech WZR-1750DHP Manuel utilisateur
www.bualotech.com
User Manual
AirStation
WZR-1166DHP
- 1 -
Contents
Chapter 1 - Product Overview .........................................5
Package Contents ................................................................... 5
Hardware Overview ................................................................. 6
Front Panel LEDs ........................................................................... 6
Back Panel ..................................................................................... 8
Bottom ............................................................................................ 9
Right Side ...................................................................................... 10
Vertical Placement .................................................................. 11
Horizontal Placement .............................................................. 11
Wall-Mounting ......................................................................... 12
Chapter 2 - Installation .....................................................13
Initial Setup ............................................................................. 13
Appendix A -
Specications .............................................16
WZR-1750DHP ....................................................................... 16
WZR-1166DHP ....................................................................... 19
Appendix B - Environmental Information .......................22
Appendix C - GPL Information ........................................23
- 5 -
Chapter 1 - Product Overview
Package Contents
The following items are included in your AirStation package. If any of the items are missing, please
contact your vender.
• AirStation ....................................................................................................................................... 1
• AirStation Setup Card ................................................................................................................ 1
• AC adapter ..................................................................................................................................... 1
• Stands .............................................................................................................................................. 2
• Screws for wall-mounting ........................................................................................................ 2
• Ethernet Cable ............................................................................................................................. 1
• Quick Setup Guide ...................................................................................................................... 1
• Warranty Statement ................................................................................................................... 1
1
2
3
5
4
- 6 -
Chapter 1 Product Overview
Hardware Overview
Front Panel LEDs
1AOSS button To initiate AOSS, hold down this button until the wireless LED ashes
(about 1 second). Then, push or click the AOSS button on your wireless
client device to complete the connection. Both devices must be powered
on for this to work.
2Wireless LED (Blue or Amber)
On: Wireless LAN is enabled.
Randomly blinking: Wireless LAN is transmitting.
Double blinks: AirStation is waiting for an AOSS or WPS security key.
Continuously blinking: AOSS/WPS error; failed to exchange security keys.
O : Wireless LAN is disabled.
Note:
Wireless LED is blue : Security settings have been made for the wireless LAN.
Wireless LED is amber : Security settings have not been made for the wireless LAN.
Chapter 1 Product Overview
- 7 -
3Internet access LED (Blue)
On: Internet access is available.
O: Internet access is not available.
Router functionality is disabled.
4Router LED (Blue)
On: Router functionality is enabled.
O: Router functionality is disabled.
5Bualo LED (White or Red)
On (White): Power is on.
O: Power is o.
On (Red)*1: Booting.
2 blinks (Red)*2: Flash ROM error.
3 blinks (Red)*2: Wired Ethernet LAN error.
4 blinks (Red)*2: Wireless LAN error.
5 blinks (Red)*3: IP address setting error.
9 blinks (Red)*2: System error.
Continuously blinking*1:
Updating rmware, saving settings, or initializing settings.
*1 Never unplug the AC adapter while the Bualo LED is blinking continuously.
*2 Turn o AirStation rst, wait for a few seconds, then turn it back on.
*3 Because the network addresses of both the Internet port (WAN port) and the LAN port are the
same, it is not possible to establish communication. Change the LAN-side IP address of the
AirStation.
15 13
14 12
17
9
8
7
11
16
6
10
- 8 -
Chapter 1 Product Overview
Back Panel
6Mode switch Switches operation mode.
7Mode button This button turns the router on and o . The operation mode is changed
by holding down the button.
8USB LED (Blue)
On: A USB drive is connected.
Blinking: A USB drive can be removed.
Note: When this LED is blinking, the connected USB drive cannot be used. Remove the connected USB
drive. If the LED continues to blink even after the USB drive is removed, restart the AirStation. Do
not remove the USB drive or turn o the AirStation while the USB LED is on.
9USB Eject button To dismount a USB hard drive, hold down this button until the USB LED
ashes (about 3 seconds). The USB drive can then be unplugged safely.
10 USB 3.0 Port Connect the USB drive.
11 USB 2.0 Port Connect the USB drive.
12 LAN Port Connect your computer, hub, or other Ethernet devices to these ports.
This switching hub supports 10 Mbps,100 Mbps, and 1000 Mbps
connections.
19
18
Chapter 1 Product Overview
- 9 -
Bottom
18 Reset button To reset all settings, hold down this button until the Bualo LED turns red
(about 3 seconds). The power must be on for this to work.
19 Setup card slot This is the slot where the AirStation setup card is stored. The initial
settings for the username, password, SSID, and encryption type are
provided on the card for logging into the conguration interface.
13 Internet Port 10 Mbps, 100 Mbps, and 1000 Mbps connections are supported.
Note: In bridge/AP mode (router o), the Internet port becomes a
regular LAN port, for a total of 5 usable LAN ports.
14 LAN LED (Green)
On: An Ethernet device is connected.
Blinking: An Ethernet device is communicating.
15 Internet LED (Green)
On: The Internet port is connected.
Blinking: The Internet port is transmitting data.
16 Power button This button turns the power on and o.
17 DC connector Connect the included AC adapter here.
20
- 10 -
Chapter 1 Product Overview
Right Side
20 Mounting holes Mounting holes are provided for mounting the AirStation to a
wall. Use the supplied screws to mount to a wall.
Stand
Stand
Stand
Chapter 1 Product Overview
- 11 -
Vertical Placement
Attach the stand as shown in the gure below.
Horizontal Placement
The same stand also allows horizontal placement. Install the stand as shown in the gure below.
Mounting holes
85 mm (3.35 in.)
Screws
50 mm (1.97 in.)
- 12 -
Chapter 1 Product Overview
Wall-Mounting
Attach to the wall with the supplied screws in the mounting holes as shown below.
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Buffalo Tech Routeur réseau
Buffalo Tech
Buffalo Tech AirStation WHR-HP-G54 Manuel utilisateur
Buffalo Tech
Buffalo Tech AirStation WHR-HP-AG108 Manuel utilisateur
Buffalo Tech
Buffalo Tech WZR-RS-G54 Manuel utilisateur
Buffalo Tech
Buffalo Tech AirStation NFiniti Draft-N WZR-AG300NH Manuel utilisateur
Buffalo Tech
Buffalo Tech AOSS WZR-HP-G54 Manuel utilisateur
Buffalo Tech
Buffalo Tech AirStation Nfiniti WZR-HP-G300NH Manuel utilisateur
Manuels Routeur réseau populaires d'autres marques
NETGEAR
NETGEAR FS526T - Switch Manuel utilisateur
Korenix
Korenix JetNet 5710G Series Manuel utilisateur
Automated Logic
Automated Logic ZN551 Manuel du propriétaire
Cisco
Cisco ASR 1000 Series Manuel de l'opérateur
EnGenius
EnGenius ESR-9710 Manuel utilisateur
Cisco
Cisco 805 Series Instructions d'utilisation et de sécurité