7
PROGRAMMABLE KEY FUNCTION
The PF1, PF2, PF3 keys are programmable by PC software, each key can
be enabled up to 3 functions. a short press, a 1 second press or a long
press. Consult your radio provider for available functions that have been
programmed into your radio.
1. Voltage
In standby, press the key programmed as " Voltage" to check current battery
capacity.
2. Power Switch
In standby, press the key programmed as " Power Switch" to change the
power level.
3. Repeater
In standby, press the key programmed as " Repeater" to turn on Repeater
function, press this key again to turn off repeater function.
Note: If current channel is working by repeater frequency, turning off this
function, the radio will stop repeater communication.
4. Revers
In standby, press the key programmed as "Revers" to turn on frequency
revers function, press this key again to turn off revers function.
Note: This function is only valid in analog mode, when frequency revers
function is on. The TX frequency and RX frequency will be reversed, the
CTCSS/DCS will also be reversed.
5. Digital Encryption
In standby, press the key programmed as" Digital Encryption", the radio will
announce encryption status or encryption group. Press this key again to
choose encryption group or turn off encryption.
Note: This function is valid only in DMR mode only, when 2 radios use the
same encryption code.
6. Analog Call
In standby, press the key programmed as" Ana Call", the radio will transmit
the DTMF/2TONE/5TONE code in current channel.
Note: This function is valid only for an analog channel.
