9
Fan heater oscillation mode
• Press the button (11) « » on the control panel (3)
or the button (15) « » on the remote control (17) to
switch the body oscillation mode on, the symbol «
» will appear in the operation mode icons row (9). To
switch the oscillation mode o, press the button (11)
«» or (15) « » again, the symbol « » on the
control panel (3) will go out.
Timer setting
• Press the timer on/o button (8) « » on the control
panel (3) or the button (14) « » on the remote control
(17) and set the requited timer operation time.
• Time setting range is up to 12 hours.
• The timer operation time is indicated with the digital
symbols (10) on the control panel (3).
• To switch the timer o, consequently press the button
(8, 14) « » until the digital symbols (10) show the
room temperature.
Room heating temperature setting
ATTENTION! You can set the room heating temperature
only with the remote control (17).
• Press the buttons (16) « » on the remote control
(17) to set the required room heating temperature.
• The temperature setting range is from 15 to 47
degrees, the temperature is displayed on the control
panel (3) with digital symbols (10).
• Switching the fan heater o
• Switch the fan heater o by pressing the on/o button
(6) « » on the control panel (3) or the button
(12) « » on the remote control (17).
• Note: — after pressing the buttons (6, 12), the
heating element will switch o, but the fan will
continue to operate for 30 seconds to cool the
heating element.
• After the fan stops, switch the power o by setting
the switch (5) to the position «0».
AUTOMATIC EMERGENCY SWITCH-OFF
FUNCTION IF THE OUTGOING AIR IS TOO
HOT
• If the outgoing air temperature exceeds the
acceptable value, the automatic thermal switch will
switch on, and the fan heater will be switched o.
• Set the power switch (5) to the position «0» and
unplug the unit, let the fan heater cool down for
approximately 15-25 minutes (depending on the air
temperature in the room) and only after that you can
switch the unit on again.
• Make sure that the front (2) and rear grids are not
blocked with foreign objects.
• Insert the power plug into the mains socket and
switch the fan heater on.
• If the fan heater does not switch on, it may be caused
by another malfunction. In this case apply to a
service center for repairing of the fan heater.
