BoysStuff Playseat Manuel utilisateur
Need Help? Email: inf[email protected] Web: www.boysstuff.co.uk
Phone +44 01676) 535557
ASSEMBLY INSTRUCTION FOR THE PLAYSEAT EVOLUTION
Safety
instruction the Playseat is not included or suitable for use in cars!
First you need to assemble the chair frame supporting the chair by attaching plates P1 &P2 to the bottom of
the chair (photo 1) using the Allen screws ①. You will find these screws already attached to the bottom of
the chair.
Take the oval tube P3 (photo 2) and turn the adjustment knob ② a few times so it is secured in the large
screw thread at the front. Then attach the two long square bars P4 & P5 to the oval tube (photo 3) using the
Allen screws ③.
After this, attach the section you have just assembled to the bottom of the chair between the side plates. Take
care when assembling the section to ensure that the adjustment knob is at the front of the chair (photo 4).
Use the Allen screws for this ④.
The chair cam now be folded out and secured. If the chair has sprung open the backrest can be secured using
the two locking pins in the backrest. In order to do this you need to first turn the chair over and rest it on the
floor. Then you need to pull the cover up from the rear of the chair (photo 5) and pull up the backrest. (photo
6).
The locking pins can now be pushed in firmly. Finally, pull the cover back down and secure it using the Velcro
strips.
The next step is to assemble the frame for the steering wheel and pedals. Take the steering column P6 and the
oval tube P7. Push the oval tube through the steering column and into the tube beneath the chair (photo 7)
and tighten the adjustment knobs in both the steering column and the oval tube.
The pedal plate P8 can now be attached to the oval tube (photo 8). Two Allen screws ④ need to be used for
this. This pedal plate can be installed in two different positions. The middle position is always used as the
standard position, however with some pedals it is goof to position the pedal plate so it is slightly off-centre to
the left. An additional support P9 is provided to ensure optimal control over the pedals. This may be attached
to the bottom of the pedal plate (photo 9) using two Allen screws ④.
Fianally, insert the pre-assembled steering plate & steering rod P10 into the steering column (photo 10).
You can then tighten the adjustment knob gently.
Your racing cockpit is now ready for you to attach you own steering wheel and pedals using the universal fasteners
provided. Most steering wheels and pedals can be attached using the special Velcro strips which can be stuck to the
frame. Some steering wheels and pedals can even be attached with small bolts.
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels BoysStuff Accessoires de jeux vidéo
Manuels Accessoires de jeux vidéo populaires d'autres marques
Sega
Sega Visual Memory Unit Manuel utilisateur
Datel
Datel Go-tcha Expedition Manuel utilisateur
TruGolf
TruGolf TruFlight 2 Manuel utilisateur
CH Products
CH Products CH PRO THROTTLE Manuel utilisateur
Thrustmaster
Thrustmaster T2PA Manuel utilisateur
Cube Controls
Cube Controls Mercedes-AMG - GT Edition SIM Wheel Manuel utilisateur
