Bosch 715ES Manuel utilisateur

Models: 715ES, C800ES, C920ES, C920ESC, 2400ES, 2700ES

Cleaning and replacing ignition group

Service Bulletin G3-23

Introduction

The ignition group consists of two ignition electrodes and one

ame sensing rod. These components may need to be cleaned

or the entire group replaced if the heater has frequent EC or EA

error codes or fails to produce a spark.

Tools needed:

Phillips head screwdriver

 8mm wrench or small adjustable wrench

Fine steel wool for cleaning

Preparation

1. Unplug water heater and turn off gas to heater using installer

supplied manual shut off valve.

2. Loosen two Phillips head screws located at bottom rear of cover.

(Fig. 1, step 1, pos. 1).

3. Lift front cover upward and remove. (Fig. 1, step 1, pos. 2 & 3)

4. Remove combustion cover by unclipping two upper and two

lower clips securing cover. (Fig. 1, step 2)

Step 1 Step 2

tep

Figure 1

Removing the ignition group

1. Locate ignition group. (Fig. 2, pos. 1).

2. Disconnect two large yellow ignition wires from ignition group.

(Fig. 2, pos. 2)

3. Disconnect small black ame sensor wire from ignition group.

(Fig. 2, pos. 3).

Figure 2

Data subject to change without notice | Printed in the USA | BTC710002310 A | 01.2009 Bosch Thermotechnology Corp.

Service bulletin

18 | G3-23 | 715ES, C800ES, C920ES, C920ESC, 2400ES, 2700ES

Bosch Thermotechnology Corp.

50 Wentworth Avenue

Londonderry, NH 03053

Tel: 1-866-642-3198

Fax: 1-603-584-1681

www.boschhotwater.com

4. Remove two 8mm nuts from ignition group. (Fig. 3, pos. 1).

5. Remove ignition group and gasket from the water heater. Leave

the observation window in place.

Figure 3

Cleaning ignition group

1. If the ignition group gasket is discolored or torn, replace with a

new gasket. (Fig. 4)

2. Using steel wool, gently polish all metal surfaces of the ame

sensor and the ignition electrodes. (Fig. 4)

Figure 4

Gasket

Flame

sensor

Ignition

electrodes

Replacing ignition group

1. Gently place ignition group gasket over left bolt stud for 8mm

nut. The stud will hold the gasket in place.

(Fig. 3, pos. 1)

2. Carefully feed tips of ignition group into heat exchanger ensuring

that the ame sensor rod is on the far left.

3. Ensure a proper seal between the heat exchanger and ignition

group.

4. Replace and tighten two 8mm retaining nuts. (Fig. 3, pos. 1).

5. Reconnect two large ignition wires to the right and center igniter

terminals. (Fig. 2, pos. 2).

6. Reconnect small black ame sensor wire to the left terminal.

(Fig. 2, pos. 3).

7. Ensure that all three wire connections t securely on the

terminals.

8. Replace combustion cover and front cover. (Fig. 1).

9. Plug in water heater‘s power cord and press On/Off button to

"ON". Reset any error that is displayed.

10. Open manual gas shutoff valve.

11. Return water heater to service.

!WARNING

FAILURE TO PROPERLY SEAL THE

IGNITION GROUP WITH GASKET MAY

CREATE A HAZARDOUS CONDITION

CAUSING SEVERE PERSONAL INJURY

OR DEATH.

Autres manuels pour 715ES

Ce manuel convient aux modèles suivants

Autres manuels Bosch Chauffe-eau

Bosch

Bosch BC2600RA Manuel utilisateur

Bosch

Bosch Tronic 3000T Guide de sécurité

Bosch

Bosch 715ES Manuel de référence

Bosch

Bosch AquaStar GWH 2700 ES NG Manuel utilisateur

Bosch

Bosch TR6000R 18/21 ESOB Manuel utilisateur

Bosch

Bosch GWH 635 ES Manuel utilisateur

Bosch

Bosch TR5000 Series Manuel utilisateur

Bosch

Bosch ED5-2S Manuel utilisateur

Bosch

Bosch 660 EF Manuel utilisateur

Bosch

Bosch TR5000R Series Manuel utilisateur

Bosch

Bosch W 325 K**T1 Manuel du propriétaire

Bosch

Bosch Pro Tankless GWH-635-ES-N Manuel utilisateur

Bosch

Bosch BC2680RA5 Manuel utilisateur

Bosch

Bosch Therm 4300 Series Mode d’emploi

Bosch

Bosch TR3500T Series Manuel utilisateur

Bosch

Bosch GWH C 920 ES Manuel de référence

Bosch

Bosch PROTANKLESS GWH 345 Manuel utilisateur

Bosch

Bosch GWH 2400 ES NG Manuel utilisateur

Bosch

Bosch AquaStar 125X LP Manuel utilisateur

Bosch

Bosch AQ 125BO NG Manuel utilisateur

Bosch

Bosch WR8 series Document technique

Bosch

Bosch Tronic 5000C Manuel de référence

Bosch

Bosch Water Wizard 600 Manuel

Bosch

Bosch TRONIC 3000 US3-2R Document technique

Manuels Chauffe-eau populaires d'autres marques

Kenmore

Kenmore 153.582400 Manuel utilisateur

Applimo

Applimo Edel AIR Manuel utilisateur

STIEBEL ELTRON

STIEBEL ELTRON Eltronom SHU 5 S Manuel utilisateur

clage

clage E-Mini Series Manuel utilisateur

Toyotomi

Toyotomi Oil Miser OM-180 Manuel utilisateur

Bradford White

Bradford White EF Series Manuel utilisateur

Eccotemp

Eccotemp 40-H Manuel utilisateur

Dimplex

Dimplex ECSd125-580 Mode d’emploi

Dux

Dux 32FCR6N Manuel utilisateur

Toyotomi

Toyotomi Oil Miser OM-148 (Type D) Guide de dépannage

Noritz

Noritz N-132M Manuel d'instructions

TESY

TESY GCV7/4S 10047 Fiche technique

A.O. Smith

A.O. Smith Gphe 50 Manuel utilisateur

Koryo

Koryo KWHZF15Y Manuel utilisateur

Pentair

Pentair PSC-14-4-02 Manuel utilisateur

GE 40M06AAG Instructions de montage

Thermor

Thermor AEROMAX SPLIT 2 Manuel utilisateur

American Hometec

American Hometec AHQ-B03X Manuel utilisateur