Bosch HWD Series Manuel utilisateur

Warming Drawer Model: HWD BOSCH

Invented for life

Important Safety Instructions ................................... 1

Installation ................................................. 1

Before You Begin ...................................................... 1

Tools and Parts Needed ........................................................ 1

Parts Included ................................................................ 1

Warming Drawer Dimensions .................................................... 1

Cabinet Cutout Dimensions ...................................................... 2

Custom Drawer Front Dimensions (Optional) ........................................ 2

Power Requirements and Grounding .............................................. 3

Installation Procedure ................................................... 3

Prepare Cabinet Cutout ......................................................... 3

Install Support Brackets ......................................................... 3

Install Warming Drawer ......................................................... 3

Attach Custom Drawer Front (Optional) ............................................ 3

Connect Electric .............................................................. 4

Test the Installation ............................................................ 4

Service .................................................... 4

Questions?

1-800-944-2904

www.boschappliances.com

5551 McFadden Ave.

Huntington Beach, CA 92649

We look forward to hearing from you!

Important Safety Instructions

Save these Instructions

Be sure your appliance is properly installed and grounded by a qualified

technician in accordance with the National Electrical Code ANSI/NFPA No. 7lat-

est edition (or the Canadian Electric Code) and local electrical code requirements.

Important: Local codes vary. Installation, electrical connections and grounding

must comply with all applicable codes.

Never use your appliance for warming or heating a room.

Children should not be left alone or unattended in area where appliance is in use.

Do not allow children to sit or stand on any part of the appliance.

Do not repair or replace any part of the appliance unless specifically recom-

mended in the manual. All other servicing should be referred to a qualified techni-

cian.

Flammable materials should not be stored in the appliance.

Installation

Before You Begin

Tools and Parts Needed

Parts Included

• Saw

• Phillips Head Screwdriver

• Measuring Tape

• Screws, 8 x 5/8" (5.9mm) (8)

• Support Brackets (2)Warming Drawer Dimensions

English 1

Figure1 WarmingDrawerOverallDimensions

Table1 WarmingDrawerOverallDimensions

CabinetCutoutDimensions

i i/!iiii!!!! !!!!!!!!!!i

A 11 1/4" (285.8mm) 11 1/4" (285.8 mm)

B 26 5/8" (676.3 mm) 29 1/4" (743 mm)

C 22 1/4" (565.2 mm) 22 1/4" (565.2 mm)

D 20 1/2" (520.7 mm) 20 1/4" (514.4 mm)

Instructions are based on standard American cabinets 36" (914 mm) high x 24"

(609 mm) deep with a 25" 635 mm) countertop. If using non-standard cabinets, to

alter dimensions accordingly.

Cabinet opening bottom must be able to support 90 pounds (41 kg). Otherwise,

use the support brackets provided. If using the brackets, the sidewalls must sup-

port 45 pounds (20.5 kg) each.

Figure 2: Cabinet Cutout Dimensions

1/2" (12 7mm)

__cFrame Overlaps

abinet

(12 7ram)

Allow 3-1/2" (88.9mm) in front

1-1/2" (38 1ram) Min. to _for drawer hand{e clearance

F opening ( see 'terrl 4)_ ?_i - c _

_ H_ D Frame

AOverlaps

Cabinet

Wall

Receptacle

Brackets

Table 2: Cabinet Cutout Dimensions

A 25 3/4" (654.1 mm) 25 3/4" (654.1 mm)

B 10" (254 mm) 10" (254 mm)

English 2

Custom Drawer Front Dimensions

(Optional)

Table 2: Cabinet Cutout Dimensions

C 22 1/4" (565.2 mm) 22 1/4" (565.2 mm)

D 7/16" (11.1 mm) 1 3/4" (44.5 mm)

Build custom drawer front to the dimensions specified in Table 3 on page 3 and-

Table 4 on page 3 below. All four edges must be finished. If using wood, the back

must be sealed to prevent moisture damage.

Figure 3: Custom Drawer Front Dimensions

I A

I G

_ ilot Holes JJ_J_J+

1/2" (12.7 mm)

Diameter Hote

__ D I__

Table 3 Custom Drawer Front Dimensions

Power Requirements and

Grounding

Installation Procedure

1) Prepare Cabinet Cutout

2) Install Support Brackets

A 26 5/8" (676.3 mm) 29 1/4" (743 mm)

B 11 1/4' (285.8 mm) 11 1/4" (285.8 mm)

C 1 1/4" (31.6 mm) 1 1/4" (31.6 mm)

D 1 1/4" (31.6 mm) 2 9/16" (65.1 mm)

E 2 3/4" (69.9 mm) 2 13/16" (71.5 mm)

F 2 1/4" (57.2 mm) 2 1/4" (57.2 mm)

G 21 1/16" (535 mm) 23 5/8" (600.1 mm)

Circuit Specifications: 120 V, 15 A, 60 Hz. The outlet must be properly grounded

in accordance with all applicable codes.

Prepare cabinet cutout and install electrical connection according to the dimen-

sions in Figure 2 on page 2 and Table 2 on page 2.

When the opening does not have a bottom, or the bottom is not strong enough to

support the drawer, install the two support brackets included. Attach brackets 8"

(203.2 mm) from the front wall of the cabinet. Make sure that the brackets are

level before installing screws through screw holes into cabinet sidewalls (two

screws on each side). Note: Cabinet sidewalls must be strong enough to support

45 pounds (20.5 kg) each. See "Cabinet Cutout Dimensions" on page 2 for further

details.

English 3

3) Install Warming Drawer

4) Attach Custom Drawer Front

(Optional)

7) Connect Electric

8) Test the Installation

Service

Slide warming drawer assembly into cutout and over support brackets (if applica-

ble) until it is flush with cabinet. Secure through four screw holes in front frame

(Drill pilot holes in cabinet first if necessary.).

CAUTION: Use care when handling glass panel to avoid breaking. Broken glass

could cause injury.

1) Prepare custom drawer front as explained above.

2) Remove drawer from warming drawer frame (See Use and Care Manual for

instructions).

3) Remove two screws from backside of drawer front. Set handle and screws

aside.

4) Remove signal light viewer and retainer clip from glass panel and set aside.

Discard glass panel (Note: stainless steel models do not have a glass panel).

5) Install the signal light viewer and the retainer clip in the custom drawer front.

6) Attach drawer front with two screws. Attach handle as well if desired.

Insert plug into three-prong, grounded outlet. See "Power Requirements and

Grounding", above for electrical specifications.

Turn the warming drawer on. Signal light turns on immediately. Wait five minutes

and then place palm on drawer bottom. It should be warm to the touch.

If the warming drawer elements or signal light do not turn on, check the power

source to see if the circuit breaker is tripped.

Check the Use and Care Manual for other troubleshooting techniques.

If problems persist, contact Service (see contact information at the front of this

manual).

English 4

YOURLIFE,OURINSPIRATION,

5551 McFadden Avenue, Huntington Beach_ CA 92649 • 800-944-2904 ° www.boschapptiances.com

9000060282 (ECO# 5V03FT) • 10006 Rev A •04/05 © BSH Home Appliances Corporation 2005 • Litho U.S.A.

Autres manuels pour HWD Series

Table des matières

Autres manuels Bosch tiroir chauffant

Bosch

Bosch HWD57 Manuel utilisateur

Bosch

Bosch FAP-OC 500Series Manuel utilisateur

Bosch

Bosch BIC630N 1B Series Manuel utilisateur

Bosch

Bosch BIC510N 0 Series Manuel utilisateur

Bosch

Bosch BIC510NS0 Manuel utilisateur

Bosch

Bosch HWD27 Manuel utilisateur

Bosch

Bosch BI.7101 Series Manuel utilisateur

Bosch

Bosch BID830NC0 Manuel utilisateur

Bosch

Bosch HSC 290 Series Manuel utilisateur

Bosch

Bosch BIC510N 0W Series Manuel utilisateur

Bosch

Bosch HSC140652B Manuel utilisateur

Bosch

Bosch BIC9101B1 Manuel utilisateur

Bosch

Bosch HWD272UC Manuel utilisateur

Bosch

Bosch BID630N 1 Series Manuel utilisateur

Bosch

Bosch HWD Series Manuel utilisateur

Bosch

Bosch HWD57 Manuel utilisateur

Bosch

Bosch HWC800500 - 30 in Built Manuel utilisateur

Bosch

Bosch BIC510N.0 Manuel utilisateur

Bosch

Bosch HWD Series Manuel utilisateur

Bosch

Bosch BIC510N.0B Manuel utilisateur

Bosch

Bosch HWD57 Manuel utilisateur

Bosch

Bosch BIC630NS1W Manuel utilisateur

Bosch

Bosch HWD57 Manuel utilisateur

Bosch

Bosch HWD57 Manuel utilisateur

Manuels tiroir chauffant populaires d'autres marques

Siemens

Siemens HW 290 Series Manuel utilisateur

Hatco

Hatco HDW-1 Instructions d'installation

APW Wyott

APW Wyott WD-2CMF Manuel utilisateur

Viking

Viking DEWD102SS Manuel utilisateur

Miele

Miele ESW 6229 Manuel utilisateur

Brandt

Brandt WD1014X Manuel utilisateur

KitchenAid

KitchenAid KOWT107ESS Manuel utilisateur

Gaggenau

Gaggenau WSP 222 Manuel utilisateur

DCS

DCS WDI Manuel utilisateur

Fisher & Paykel

Fisher & Paykel OR90SCG6R1 Manuel utilisateur

Electrolux

Electrolux EED21600X Manuel utilisateur

Fisher

Fisher PROFESSIONAL WB76SPEX1 Manuel utilisateur

Electrolux

Electrolux EW30WD55GS Manuel utilisateur

Hanseatic

Hanseatic TCN14J6D-S Manuel utilisateur

Jenn-Air

Jenn-Air JWD6030CDX Manuel utilisateur

Gaggenau

Gaggenau WS482710 Manuel utilisateur

NEFF

NEFF N29HA11Y2 Instructions d'utilisation et d'entretien

Fisher & Paykel

Fisher & Paykel WB60SMTB1-SET Manuel utilisateur