5
PLEASE NOTE: One of the safety features is that The Hidden Igni-
on Switch draws it’s power from your models’ receiver so The
Hidden Ignion Switch is completely inoperable unless connect-
ed to your model’s receiver and the receiver is powered up!
The Hidden Ignion Switch also requires one receiver channel to
operate and is set to switch at approximately 50% of sck posi-
on. It is recommended to connect The Hidden Ignion Switch
to a switch channel on your receiver and adjust the switch unl
The Hidden Ignion Switch operates as required. Seng up a
transmier for switching will dier for each transmier type so
please refer to your transmier manual for switch channel set-
ng.
FOR THE TECHNICALLY MINDED ONLY
The Hidden Ignion Switch has a dead-band where neither an
On or O state is acve. This funconality is built into The Hid-
den Ignion Switch so that Switch uer cannot happen.
Also a bad signal (no pulse or less than 50% mark space rao)
must be present for more than 20 connuous frames before The
Hidden Ignion Switch will kill the ignion. In most modern re-
ceivers fail safe is built in so this condion should never be met
except as a complete system safety feature.
This dead band feature comes at a cost of a small delay (approxi-
mately 500 - 600 milliseconds) in switching ON/OFF.
PLEASE NOTE
Please observe correct connecon polarity i.e. RED is baery
posive and BLACK is baery negave.
An Incorrect polarity connecng will not allow your baery to
supply power to the Ignion.
