Bogen Easy Design HS15EZ Manuel utilisateur

Easy Design Speaker

Models HS15EZ

HS15EZW

Speaker Layout

The layout of the speakers should be planned prior

to installation. Desired mounting height, barring

obstructions, is 15 to 20 feet, with the speakers

angled downward toward the listening area and

facing in the same direction.

Layout starts in one corner of the area (see Figure

1).The first speaker in Row 1should be positioned

a distance equivalent to (A) (see Figure 2) from the

corner based on the noise level of the area. The

next speaker in Row 1should be a distance equiv-

alent to (B) (see Figure 2) from the first speaker.

Each additional speaker in the row should use this

same spacing.

Row 2 starts a distance equivalent to (C) (see

Figure 2) from Row 1, and, like Row 1, each speak-

er should be a distance apart equivalent to (B).

Row 3 starts a distance equivalent to (C) from

Row 2. Continue this pattern of alternating rows

until the area is appropriately covered.

For areas that include high shelving or corridors,

speakers should be installed so that they project

down the aisles between the shelves or down

through the corridors.

The spacing of the speakers can be adjusted so

that the speakers are evenly spaced in a row.

NOTE: Each environment is unique.This layout

plan is general in nature and may not be

applicable for every installation.

Figure 1

START HORN SPEAKER

Row 1

Row 2

Row 3

Row 4

Figure 2

Specifications subject to change without notice.

Part No. 54-5072-01r2 Printed in Korea 0100

50 ft. 100 ft. 60 ft. 1/2 Rotation

High Noise

(75dB-85dB)

30 ft. 65 ft. 40 ft. Full Clockwise

A B C Volume Setting

PLACEMENT

Very High Noise

(85dB-95dB)

50 Spring Street, Ramsey NJ 07446

Tel. 201-934-8500, Fax: 201-934-9832

www.bogen.com

Speaker Installation

STEP 1-For easier installation, remove the flange (base)

from the speaker by unscrewing the wing nut while at the

same time pressing inwardly on the wing nut. Place the

flange flush with the mounting surface and mark the loca-

tion of the three holes with either a marker or chisel. It is

important that the three holes be exactly aligned with the

flange, otherwise you might stress the base or make the

connection unsteady. Drill the necessary holes and screw

the flange to the surface (see Figure 3). (Use appropriate

hardware for your specific mounting surface.)

NOTE: The speaker may also be strap-mounted using

standard 1/2-inch industrial strapping.

STEP 2 - After mounting the flange, reattach the speaker

to the flange and aim the speaker for the desired coverage.

A 45 downward angle is recommended, but this may vary

depending upon speaker layout.

STEP 3 - Remove the plastic cover to make the electrical

connection and set the volume control (see Figure 4).The

suggested amplifier connections are:

Amplifier Outputs Speaker Connections

70V Terminal 1

COM Terminal 2

NOTE: The speaker will also work perfectly well with these

connections reversed. However, it is important to be

consistent in the wiring of the speakers in the system.

STEP 4 - Adjust the volume control to the desired setting.

See Figure 2 for the suggested initial settings based on the

ambient noise level of the environment. Place the plastic

protective cover back over the exposed area.

NOTE: The two furthermost clockwise settings

(positions 7 and 8) on the volume control will produce

the same volume.

Figure 3

Figure 4

ELECTRICAL

CONNECTION

VOLUME

CONTROL

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Bogen Intervenants

Bogen

Bogen SM1EZ Manuel utilisateur

Bogen

Bogen NEAR LB4TM Manuel utilisateur

Bogen

Bogen Easy Design WB1EZ Manuel utilisateur

Bogen

Bogen FG20B Manuel utilisateur

Bogen

Bogen ASM1 Manuel utilisateur

Bogen

Bogen Easy Design CS1EZ Manuel utilisateur

Bogen

Bogen MB8TSL Manuel utilisateur

Bogen

Bogen SMTB Manuel utilisateur

Bogen

Bogen SP158A Manuel utilisateur

Bogen

Bogen Easy Design HS30EZ Manuel utilisateur

Bogen

Bogen ASM1 Manuel utilisateur

Bogen

Bogen KFLDS30T Manuel utilisateur

Bogen

Bogen CSD1X2 Manuel utilisateur

Bogen

Bogen CSD1X2VR Manuel utilisateur

Bogen

Bogen CSD2X2U-V2 Manuel d'utilisation

Bogen

Bogen A12 Manuel utilisateur

Bogen

Bogen 14018 Manuel utilisateur

Bogen

Bogen CSD2X2L Manuel utilisateur

Bogen

Bogen CSD2X2VR Manuel utilisateur

Bogen

Bogen MB8TSL Manuel utilisateur

Bogen

Bogen CSD1X2 Manuel utilisateur

Bogen

Bogen Easy Design HS15EZ Manuel utilisateur

Bogen

Bogen NYQUIST NQ-S1810WT-G2 Manuel utilisateur

Bogen

Bogen R6/R6T Manuel utilisateur

Manuels Intervenants populaires d'autres marques

argon audio

argon audio IE20 Manuel utilisateur

Denon

Denon SC-N7 Manuel utilisateur

Gemline

Gemline Ace 3952 Manuel utilisateur

Focal

Focal ON WALL 300 Mode d’emploi

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuel utilisateur

SoundLogic

SoundLogic BCCS-6/6395 Manuel utilisateur

Peavey

Peavey DTH 218 Manuel utilisateur

Avantree

Avantree Pluto Air Manuel utilisateur

Morel

Morel Integra Series INTEGRA OVATION 4 Manuel utilisateur

Oppo

Oppo SONICA Manuel utilisateur

Bose

Bose SoundLink Wireless Music System Manuel utilisateur

Rocksteady

Rocksteady Stadium Manuel utilisateur

Bowers & Wilkins

Bowers & Wilkins 4 Manuel utilisateur

Sonance

Sonance SONOS OUTDOOR Series Manuel utilisateur

Electro-Voice

Electro-Voice EVID FM4.2 Manuel utilisateur

Pioneer

Pioneer XW-HTD630 Manuel utilisateur

Onn

Onn BWA16AA002 Manuel utilisateur

HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur