Power adapter wiring diagram
•
Connect the Red wire to the positive 12VDC source that is always on.
•
Connect the Yellow wire to a positive 12VDC source that is controlled by
ignition key (also known as ACC port).
•
C
onnect the Black wire to the negative source, battery or ground on the bike.
Quick Installation Guide
1. Locating the proper place to fix the front & rear camera, wired controller,
GPS tracker (optional) and DVR Unit (Recommended to be placed under
the seat or in top case for touring bikes).
2. Plan the path of camera cables and power cable before installation. Most
bikes will require you to remove the fuel tank to properly run the cable for
the front camera.
The wired controller cable, and/or the GPS tracker cable may also have to
run under the tank so plan the mounting locations before putting your
fuel tank back on.
3. Fix and connect the front and rear cameras by method of your choice
(3M tape, screws, cable ties) in the proper viewing location.
Note: If you plan on using 3M tape you should properly clean the surface,
if you use a top coat paint product it can limit the ability of the 3M tape
to adhere properly.
4. Supplied power adapter connection.
It is recommended the supplied power adapter to be connected to ignition,
or any point after, such as fuse box, radio, lights. ... so the system starts up
and shuts down with your bike. However, you can connect to your battery,
but you need to make sure to turn the unit off manually after rides to avoid
draining the battery.
The position of the DVR Unit and camera cables should be away from the
high-voltage circuit like xenon lamp, ignition plug etc. If your motorcycle is
a traditional carburetor system please try to change a suitable R-value
ignition plug.
10
1Lock Button 2LED Indicator
3Reset Hole 4Micro SD Card Slot
5Battery 6Camera Connector
7Power Connector (Red Cable) 8Wired Controller Connector
(Yellow Cable)
9Camera B 10 Camera A
11 Mic
13 USB Port
12 Power Adapter
14 Mounting hole
3
DVR Unit
Structure Diagram
LED Indicator
Controller
GPS
Main body
DVR Unit To Wired Remote Connected to Ground
Connected to Auxiliary Power
(Only on when the key is on)
Connected to Always On Power
