Blue Sky Network SKYLINK Manuel utilisateur
SKYLINK QUICK START GUIDE
STEP : ATTACH THE ANTENNAS
Screw the cellular antenna to the cellular antenna connector on the Data Gateway.
Screw the Iridium antenna, or the Iridium antenna cable connector, to the Iridium
antenna connector on the Data Gateway. The Blue Sky Network Iridium antenna
may be one of three antenna types:
1. Direct connection MARUWA black plastic antenna (MHL-1621C)
2. High-profile Maxtena white conical antenna with cable (M1621HCT-HP)
3. Low-profile Maxtena black puck antenna with cable (M1621HCT-SM)
STEP : INSTALL THE SIM CARDS
Insert the Iridium and cellular SIM cards in the slots behind the connectivity port
(the Iridium SIM slot is the larger of the two slots). Re-attach the bottom panel and
tighten the screws, taking care not to damage the cable wires.
Obtain an Iridium SIM card
and a cellular SIM card. Un-
screw the two Phillips screws
that secure the entire bottom
panel and carefully remove the
panel. Take care not to damage
the cable wires.
NOTE: If you purchased the Dual-Mode Data Gateway direct from Blue Sky
Network, it will arrive with the cellular and Iridium®SIM cards already installed.
Questions? Contact us at support@blueskynetwork.com
+ 1 858-551-3894
STEP : CONNECT TO THE DATA GATEWAY
It is recommended that a laptop, PC, or tablet be used to check the configuration
initially due to the size and layout limitations of a phone. A label on the back of
the device shows the Wi-Fi QR code, SSID, and password. If using a smart device,
connect to the Data Gateway Wi-Fi by scanning the QR code. Alternatively, connect
using the Wi-Fi SSID and password.
Open a web browser and type 192.168.111.1 into the address bar, then press enter.
The SkyLink Web Interface (WI) will appear.
In the SkyLink WI, navigate to the General Settings page and check/enter the
cellular APN setting for your network service provider. For detailed SkyLink user
information please refer to the SkyLink User Guide.
STEP : CONNECT THE POWER
Connect one end of the power cable to the power port on the Data Gateway
and connect the other end to a power source. The power cable may be any of
these options:
1. 12VDC Cigarette lighter adapter
2. 12VDC Power adapter with Ignition Sense
3. POE injector (self-assembly kit included)
4. AC/DC Power supply (self-assembly kit included)
NOTE: There are two Ethernet ports on the POE injector adapter. Ensure you
use the Data+Power port.
1455 N. Dutton, Suite A.
Santa Rosa, CA 95401
(888) 989-8199
www.remotesatellite.com
SKYLINK DUAL MODE DATA GATEWAY
www.blueskynetwork.com
1. Iridium antenna connector
2. Power / charging LED light
3. Cellular antenna connector
4. Cellular antenna
5. Power port
6. Connectivity port
SKYLINK-QUICK_START_GUIDE-V1.0
For Early Access use only. Not intended for further distribution.
Bottom Panel:
Top Panel:
Autres manuels pour SKYLINK
5
Table des matières
Autres manuels Blue Sky Network GPS
Blue Sky Network
Blue Sky Network Iridium/GPS Terminal D3000 Manuel utilisateur
Blue Sky Network
Blue Sky Network HawkEye Plus Manuel utilisateur
Blue Sky Network
Blue Sky Network D411 Manuel utilisateur
Blue Sky Network
Blue Sky Network HawkEye 7200A-BB2327 Manuel utilisateur
Blue Sky Network
Blue Sky Network HAWKEYE PT PLUS Manuel utilisateur
Blue Sky Network
Blue Sky Network HE100A Manuel utilisateur
Blue Sky Network
Blue Sky Network HawkEye 7200 Mode d'emploi
Blue Sky Network
Blue Sky Network HawkEye 7200A-BB2327 Manuel utilisateur
Blue Sky Network
Blue Sky Network D1000 Series Manuel utilisateur
Blue Sky Network
Blue Sky Network HawkEye 6300 Mk1 Manuel utilisateur
