[6]
reflective highlights, and the black background is the best.
c. Scanning stability requirements: Please place the scanner and turntable on a stable
platform to avoid platform shaking. The item should be placed in the center of the
turntable. During the rotation of the turntable, it is necessary to ensure that the item
does not shake or shift, otherwise it needs to be scanned again.
d. Calibration requirements: All the rotation of the turntable, the scanner, and the
change of the angle of the scanner need to be recalibrated to continue scanning. At the
time of calibration, the angle of the calibration plate and the calibration plate bracket
is 68°; the calibration plate is timed as far as possible in the middle of the turntable;
during the calibration process, do not move the position of the calibration plate
bracket, only flip the calibration plate; after the calibration is completed, cut Do not
move the relative position between the turntable and the scanner, and the angle of the
scanner cannot be changed.
e. Software operation requirements: the scanning process, calculation of calibration
results, two model splicing, model packaging and other steps require a certain
calculation processing time (the higher the CPU configuration, the shorter the waiting
time), do not operate the software interface or Rotate the model and wait quietly
f. USB device requirements: Do not plug or unplug other USB devices (mouse,
keyboard, USB flash drive, etc.) during the 3D scanner scanning process.
Note: For the desktop, please use the USB port on the back of the host.
g. Before installing the scanning software, please turn off the desktop assistant, 360
security guard and other anti-virus software.
h. Please run the installation software as an administrator. After the software is shut
down, please wait for about 30 seconds before restarting the software.
Chapter III Equipment Assembly and Scanning Operations
3.1Equipment assembly
a.Place the scan head on the main body of the turntable, and connect the turntable to
the scan head
