Bercomac 700706 Manuel utilisateur
Instructions
FOR KIT
700706
N-11
LIFT LINKS FOR NORTHEAST SNOWBLOWER #700706
INSTALLATION
STEP 1: REMOVE THE BELT GUARD AND THE BOLTS OF THE HITCH:
STEP 2: INSTALL THE LIFT LINKS:
For this step, position the snowblower in this way to facilitate the
installation.
Do the same thing on both sides. Make sure not to reverse the
lift links.
IMPORTANT : Before installing the update kit, follow all safety instructions and indications by
reading and understanding all of the snowblower and the subframe owner’s manual.
STEP 3: UNINSTALL THE TENSION ARM AND THE PULLEYS:
STEP 4: INSTALL THE NEW TENSION ARM AND RE-INSTALL THE
PULLEYS:
All the parts shown at this step, except 1,2,7 and 8, must be
removed to be re-installed in the next step. Memorize the position of
the parts.
Reinstall the parts removed in the previous step, make sure to install
the new parts in the table below. The nylon insert lock nuts 3/8” n.c.
furnished with the kit are there to replace those of the previous step.
Make sure to put the nylon insert lock nut 3/8” n.c. (thin) (item 4) for
the pulley installation.
Note: Tighten the carriage bolt 3/8” n.c. x 1 1/4” to allow the tension
arm to pivot freely.
FOR KIT
700706
N-11
STEP 6: INSTALL THE SNOWBLOWER:
Refer to the manual of the snowblower to install the snowblower
on the hitch.
Insert the links (one of each side) in the ends of the actuators
and install the following parts in the indicated direction.
Note: As needed, extend actuators with the switch to be able to
insert the pin
STEP 5: RE-INSTALL THE BELT GUARD:
FOR KIT
700706
N-11
FOR KIT
700706
N-11
Table des matières
Autres manuels Bercomac Accessoires pour souffleuses à neige
