Bemodern 2893 Manuel utilisateur

16” and 22” 75mm Electric Fire

Instructions for use

Patent pending

UK Registered Design

R1 Jan 2020 200797_1

Complete with Remote Control

Model 2893 / 2921

Contents

Tech Specs 3

Safety Info 4 –5

Fixing the appliance 6 –7

Attaching the Trim 7

User Instructions 8 -13

Maintenance 14

General information 15

Guarantee 16

200797_1

Technical Specification

Model No.: 2893 / 2921

Supply Voltage: AC 230-240V 50Hz

Maximum power consumption: 2KW

Power for flame effect: 13W (LED 5W + Motor for flame 8W)

Heat Output:

Nominal heat output (Pnom): 2KW

Minimum heat output (indicative) (Pmin): 1KW

Maximum continuous heat output (Pmax): 2KW

Auxiliary Electricity Consumption:

At nominal heat output (elmax): 14W

At minimum heat output (elmin): 14W

In standby mode (elSB): 0.48 W

Single

stage heat output and no room temperature control No

Two

or more manual stages, no room temperature control No

With

mechanic thermostat room temperature control No

With

electronic room temperature control No

Electronic

room temperature control plus day timer No

Electronic

room temperature control plus week timer Yes

Room

temperature control, with presence detection No

Room

temperature control, with open window detection No

With

distance control option No

With

adaptive start control Yes

With

working time limitation No

With

black bulb sensor No

Type of heat output / room temperature control

Other Control Options

20797_1

Safety Information

Read all of the instructions carefully before using the appliance.

For indoor use only This appliance is not suitable for use outside the house and only suitable for well

insulated spaces or occasional use.

If the fire is to be placed in front of an existing chimney opening and there is any risk of chimney debris

falling down onto the fire or drafts from the chimney it is recommended that the flue or opening is

sealed off with non-combustible non-fibrous insulation materials. Do not place into an existing

fireplace that is prone to dampness. Should it be necessary to cap and seal the chimney to prevent

personal injury, a professional should be hired to do the work

Do not use this appliance in the immediate surroundings of a bath, a shower or a swimming pool or any

wet area

This fire must not be located immediately below a socket-outlet.

This appliance must be earthed.

This appliance must not be supplied through an external switching device, such as a timer, or

connected to the circuit that is regularly switched on and off by utility in order to avoid a hazard due to

the inadvertent resetting of the thermal cut out.

A non-rewirable plug fitted with a 13A fuse is supplied. Should the fuse or plug need replacing, and you

are competent to do so, it must be replaced with a 13A fuse or plug being 13A BS1363A approved.

If the power cord is damaged, it must be repaired by the manufacturer, its authorised service centre or

professional person.

The meaning of this symbol is “DO NOT COVER”. Warning: in order to avoid overheating, do not

allow the appliance to be covered or let the air inlet / outlet to become obstructed. Please note the

warning symbol on the appliance (see above).

To reduce the risk of fire, keep textiles, curtains, or any other flammable material a minimum distance

of 1 meter from the air outlet.

Keep the power cord away from hot surfaces and hot conditions. Do not route the power lead in front

of the appliance.

Do not use this fire in rooms that have explosive gas in them (for example petrol), or if you are using

solvents, glue, aerosol spray or in flammable paints, as these may catch fire.

200797_1

Safety Information (continued)

This appliance can be used by children aged from 8 years and above and persons with reduced

physical, sensory or mental capabilities or lack of experience and knowledge if they have been given

supervision or instruction concerning use of the appliance in a safe way and understand the hazards

involved.

Children and vulnerable people must be supervised at all times when using this appliance, as some

parts can become very hot and cause burns.

Do not use this appliance in small rooms when they are occupied by persons not capable of leaving the

room on their own, unless constant supervision is provided.

Cleaning and user maintenance shall not be made by children without supervision.

Children aged from 3 years and less than 8 years only can switch on / off the appliance provided that it

has been placed or installed in its intended normal operating position and instructions and supervisions

concerning the safe way of the use of the appliance are offered. Children aged from 3 years and less

than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.

This appliance shall not be played with by children.

Children of less than 3 years should be kept away unless continuously supervised.

If the fire is to be placed in front of an existing chimney opening and there is any risk of chimney debris

falling down onto the fire it is recommended that the flue or opening is sealed off with non-

combustible non-fibrous insulation materials. Do not place into an existing fireplace that is prone to

dampness. Should it be necessary to cap and seal the chimney to prevent personal injury, a

professional should be hired to do the work

200797_1

6200797_1

Securing the Appliance

Prior to installation / securing the fire select the preferred fixing method.

A. Securing the fire into position using the fixing holes in the rebate stops.

B. Securing the fire using the back panel clamp.

Back panel / cavity opening size

Model A B C

Model 2893 –16” Version 565 413 75 min

Model 2921 - 22” Version 595 570 75 min

Fixing method A.

Position the fire in the back panel opening ensuring it is centralised. Depending on the back panel

medium , mark the hole positions then remove the fire, drill and plug the holes ensuring the correct

fixings are used for the wall medium. *NOTE Fixings are not supplied. Once fixing holes have been

plugged replace the fire and secure in position via the holes in the rebate stops.

Rebate stops

Fixing Method A

601227_1 7

Place the four 10mm magnets on the rebate stop tabs and position the trim over the fire magnetically

securing it to the fire and holding it in position.

Fixing method B.

Loosely attach the back panel clamp to the top of the fire as shown below in Figure 1. Hook the clamp

under the back panel so it site behind the panel and centralise the fire in position. Once in the correct

position hold the fire against the back panel and pull the bracket forwards Figure 2. Tighten the bracket

screws to secure the fire in position

Securing the Appliance

Figure 1 Figure 2

Attaching the Trim

User Instructions

WARNING! Do not operate the appliance if it is damaged or has malfunctioned. If you suspect the

appliance is damaged or has malfunctioned call a qualified service engineer to inspect the appliance,

and replace any part of the electrical system if necessary, before reuse.

WARNING! To reduce the risk of fire, keep textiles, curtains, or any other flammable material a

minimum distance of 1 meter from the air outlet.

MAKE SURE the plug fits tight in the outlet. Faulty wall outlet connections or loose plugs can cause the

outlet to overheat.

Do not disconnect the power at the mains supply whilst the appliance is running. Use the functions on

the remote to turn the fire off and ensure the mains switch has been moved to the off position before

disconnecting.

PREPARATION FOR USE

The appliance can be operated by both remote control and the manual controls on the appliance.

NOTE: To use either the remote or the manual functions the main power switch must be in the ‘ON’

position. (See below)

Batteries

Ensure that the handset batteries are new and inserted correctly.

Main Power Switch

The mains power switch is located on the control panel behind the door of the stove. This needs to be

switched ON before operating either the remote or manual controls. A long beep will be heard to

indicate the fire is ready for use.

200797_1

User Instructions Continued

Manual control panel

200797_1

Use the ON / OFF switch to power on the heater (set it to standby mode).

In standby mode, the heater can be operated either manually by the switches located behind the fret

or by the supplied remote control.

Heater powered off

Heater powered on, set to standby mode

Press to switch the flame effect ON

OFF

Press and hold to toggle between

different flame effect brightness levels

Press once to activate low level

heating(1000W)

Press twice to activate high level

heating(2000W)

Press three times to switch off heating

Press to toggle between 7 different fuel

bed effect colours

BACKLIGHT

Main

Power

Switch

Appliance Control

Panel

NOTE: The heater should be powered on using the Main Power switch before it can be operated using

remote control

User Instructions Continued

Remote control operation

200797_1

The remote control requires 2 x AAA size batteries.

Open the battery compartment. Pull tab downwards and lift out the cover, insert the batteries noting

the polarity indicated in the battery compartment.

Keep batteries out of reach of children.

Remote control operations are identical to the functions on the control panel.

The remote control must be pointed directly at the sensor on control pad.

Switches the appliance on

Switches the appliance into

standby mode

Set day / time

Decrease temperature

Decrease hour / minute

Confirm selection

Set automatic heating mode

Press once to activate low

heat setting

Press twice to activate high

heat setting

Press three times to switch of heat

Toggle between the 7 different

fuel bed light colours

Toggle between the 5 different

flame brightness levels

Timer on / off

Cancel

Menu down (Change day)

Increase temperature

Increase hour / minute

Timer set

Menu up (Change day)

2 x AAA

DIMMER

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels bemodern Cheminée intérieure

bemodern

bemodern Arteon Pryzm 10003SL Mode d’emploi

bemodern

bemodern PRIZM MEDIAVUE Manuel de programmation

bemodern

bemodern Arteon 4119 Manuel utilisateur

bemodern

bemodern Pryzm 1000 Manuel utilisateur

bemodern

bemodern EARDF16NG Guide de l'utilisateur

bemodern

bemodern Pryzm Volta 42 Mode d’emploi

bemodern

bemodern Arteon Pryzm 10003SL Mode d’emploi

bemodern

bemodern Arteon Pryzm 10003SL Manuel de programmation

bemodern

bemodern Elgin & Hall Instructions de montage

bemodern

bemodern EVOLV GAS FIRES 520 Slimline Inset Guide de l'utilisateur

bemodern

bemodern 2100 Manuel utilisateur

bemodern

bemodern 580 Deluxe Inset Manuel utilisateur

bemodern

bemodern Juliette Instructions de montage

bemodern

bemodern BROSELEY EVOLUTION Canterbury Remote Manuel

bemodern

bemodern BM-10 Manuel utilisateur

bemodern

bemodern BM-05XXX1 Manuel utilisateur

bemodern

bemodern BM-06 2 SLIDE Series Manuel utilisateur

bemodern

bemodern BM-091 2 Series Manuel utilisateur

bemodern

bemodern BM-081 2 Series Manuel utilisateur

bemodern

bemodern Beadnell Manuel du propriétaire

bemodern

bemodern 2983 Manuel utilisateur

bemodern

bemodern Pryzm 750 Manuel utilisateur

bemodern

bemodern 2599M Manuel utilisateur

bemodern

bemodern 600CF Manuel utilisateur

Manuels Cheminée intérieure populaires d'autres marques

Brigantia

Brigantia 35-DVRS31N-2 Manuel du propriétaire

Nordpeis

Nordpeis Bergen Manuel utilisateur

Superior

Superior BCT2536TMN Manuel utilisateur

Quadra-Fire

Quadra-Fire 5100I-GD-B Manuel utilisateur

Renaissance

Renaissance RUMFORD 1000 Manuel utilisateur

Lacunza

Lacunza IV-800 Manuel utilisateur

Baxi

Baxi 940 Instructions d'utilisation

Dru

Dru Maestro 60/2 Tall RCH Manuel utilisateur

Diamond Fireglass

Diamond Fireglass SS-O22 Manuel utilisateur

HearthStone

HearthStone Windsor Bay 8830 Manuel de programmation

Napoleon

Napoleon ASCENT B42 Manuel utilisateur

Enviro

Enviro E33GI Manuel utilisateur

Smeg

Smeg L30 FABE Instructions de montage

KEDDY

KEDDY K700 Manuel utilisateur

Godin

Godin 3451 Manuel utilisateur

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Manuel utilisateur

Austro Flamm

Austro Flamm Heidi Back 2.0 945048 Manuel utilisateur

Desa

Desa CCFPDFT Manuel d'utilisation

bemodern 2893 Manuel utilisateur

Manuels Cheminée intérieure populaires d'autres marques