Belkin 1000VA Manuel utilisateur

F6U1000au/F6U1400au

Line Interactive UPS 1000VA/1400VA

Quick Install Guide

Introduction

Each year, several natural and man-made occurrences put the power supplied to your

electronics in your home or office in jeopardy. At risk are your hardware, software, and

data because of these power problems.

This product is designed to provide clean power to all computer systems and peripherals

with maximum protection. It integrates quality surge protection and battery backup

capabilities to provide complete power protection for your computer, modem, hard drive,

and other related equipment. This product will safeguard against power disturbances of

all kinds; blackouts, surges, spikes and line noise contamination.

1 - Inspection

Remove the UPS from its package and inspect it for damage that may have occurred

during shipping. If any damage is discovered, re-pack the unit and return it to the place

of purchase.

2 - Placement

Install the UPS unit in any protected environment that provides adequate airflow around

the unit, and is free from excessive dust, corrosive fumes and conductive contaminants.

DO NOT operate your UPS in an environment where the ambient temperature exceeds

40oC.

3 - Charging

This unit is shipped from the factory with its internal battery fully charged, however

some charge may be lost during shipping and the battery should be recharged prior to

use. Plug the unit into an appropriate power outlet and allow the UPS to charge fully

by leaving it plugged in for at least 10 hours with no load (no electrical devices such as

computers, monitors, etc) connected.

4 - Computer Connection

Connect your PC, monitor and modem/router into the outlets at the back of the

UPS labelled "Battery Backup". Battery power is automatically provided in case

of power failure.

10 Hours

Incoming

Internet line

5 - Peripheral Equipment Connection

Plug your peripheral equipment (printer, scanner or speakers) into the full-time surge

protection outlet.

This receptacle does not provide any power during a power failure.

6 - Modem/Phone line Connection

Plug incoming phone line into the "IN" socket on the front of the UPS. Connect another

phone line cable into the "OUT" socket on the front of the UPS. Plug the other end into

the modem input socket as shown.

Note: DO NOT plug a laser printer, copier, space heater, vacuum or other large electrical device into

the UPS. The power demands of these devices will overload and possibly damage the unit.

Speakers

Printer

Modem

7 - Turn On/Off

Press power switch to turn on the UPS. Press power switch again to turn off the UPS.

8 - DC Start Function

DC Start Function enables UPS to be started up when AC utility power is not available

and battery is fully charged. Just simply press the power switch to turn on the UPS

Installing Belkin Automatic Power

Management Software

Step 1:

PC Installation Mac Installation

- Insert CD - Insert CD

- After a short moment - Open “Belkin APMS” CD icon

the CD will automatically - Open Mac OSX folder

run - Open Disk 1 folder

- Open INSTDATA folder

- Select setup icon

Follow prompts until software is installed (Note: Mac users will be prompted to restart at

the end of this process, do so)

Upon completion you will now have an “agent’ icon in your system tray

(PC) or in your dock (Mac).

Installing Belkin Automatic Power

Management Software

Step 2:

To launch the software,

PC - double click agent icon in your system tray to start the monitor

Mac - click the agent icon in your dock and select “Start Monitor”

Step 3:

Select System Menu then “Auto Search UPS”, the software should now detect your

connected UPS.

Step 4:

Using the menu system on the left hand side of the software drill down levels until you

reach the “LINE INT” level, you should receive a visual depiction of the operating UPS

and general information about it’s status.

Please consult the help menu in the software to configure advanced software features

Important Safety Instructions

Caution

Please read the following information carefully and save this manual for future reference.

Disregard of these safety notes may endanger life or health, as well as the function of the

equipment and the safety of your data.

• Donotconnectthisproducttoanotherbatterybackup,powerboard,surge

protector, extension cord or double adapter.

• Risk of Electric Shock. Heatsinks are live. Disconnect unit before servicing.

• Risk of Electric Shock. This unit receives power from more than one source.

Disconnection of AC sources and the DC source is required to de-energise this unit

before servicing.

• Risk of Electric Shock. Hazardous live parts inside this unit are energised from the

battery supply even when the power cord is connected.

• Risk of Electric Shock. Do not remove cover. No user serviceable parts inside.

Refer servicing to qualified service personnel.

• ThesumoftheleakagecurrentoftheUPSandtheconnectedequipmentshould

not exceed 3.5mA.

• Donotdisposeofbatteriesinafireastheymayexplode.

• Donotopenordamagethebattery.Releasedelectrolyteisharmfultotheskinand

eyes. It may be toxic.

• Abatterycanpresentariskofelectricshockandhighshortcircuitcurrent.

The following precaution should be observed when working on batteries:

- Remove watches, rings or other metal objects from the handles

- Use tools with insulated handles

- Wear rubber gloves and boots

- Do not lay tools or metal parts on top of the batteries

- Disconnect charging source prior to connecting or disconnecting

batteries terminal.

• Themaximumambienttemperatureratingis40oC

Specification

Model F6U1000au F6U1400au

Capacity VA/W 1000VA/600W 1400VA/840W

Input

Voltage 220/230/240VAC

Frequency 50/60Hz

Phase Single

Output

(inverter Mode)

Voltage Range 220/230/240VAC+10%

Frequency 50Hz or 60Hz+1Hz

Waveform Modiﬁed Sinwave

Transfer Time Typical 4-6MS 4-8MS

Battery

Battery Type 12V/7AHX2 12V/9AHX2

Backup Time at a PC

load with monitor

(Typical 100W)

40 Minutes 45 Minutes

Recharging Time 10 hours max

(recharge up to 90% capacity)

Display LCD Power on, Backup, Fault

Audible Alarm

Battery Mode Sounding every 10 seconds

Low Battery Sounding every second

Overload Sounding every 0.5 second

Fault Continuously Sounding

Protection Full Protection

Overload, Modem/Phone

Line Surge Protection and Short

Circuit Protection

Physical

Dimension

(DxWxH) 400x145x205 (mm)

Net Weight 10.5kgs 10.8kgs

Outlets IEC 6 outlets (2 for surge protection, 4 for

surge protection with battery backup)

Environment

Operation

Temperature 0-40oC

Operation Humidity 0-90%

Interface USB Port Supports Windows 98/2000/ME/XP/

Vista/7 x32 and x64, Mac OS 10.x, Linux

System Description

Front

1 LCD Back-Light

2 Power On/Off Switch

Back

1 USB Communications Port

2 Cooling Fan

3 Battery Backup Outlet

4 Surge Protected Outlet

5 Modem/Phone Line Surge Protection

6 Circuit Breaker

7 AC Input

F6U1000au

F6U1400au

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Belkin UPS

Belkin

Belkin F6H350-SER Manuel utilisateur

Belkin

Belkin OmniGuard F6C150-RKM-2U Manuel utilisateur

Belkin

Belkin RACKMOUNT WHITE PAPER Manuel utilisateur

Belkin

Belkin AP51300fc10-BLK Manuel utilisateur

Belkin

Belkin F6B750-AVR Manuel utilisateur

Belkin

Belkin F6C.B550.750AVRT Manuel utilisateur

Belkin

Belkin F6H350ukUNV Manuel utilisateur

Belkin

Belkin Regulator Pro Gold Series Manuel utilisateur

Belkin

Belkin F6C1200-UNV Manuel utilisateur

Belkin

Belkin F6C100 Manuel utilisateur

Belkin

Belkin P73220uk Manuel utilisateur

Belkin

Belkin PureAV AP30800-10 Manuel utilisateur

Belkin

Belkin 400va Manuel utilisateur

Belkin

Belkin SILVER SERIES F6C350ZSER-SB Manuel utilisateur

Belkin

Belkin OmniGuard F6C110-RKM-2U Manuel utilisateur

Belkin

Belkin F6HXXX-SER Manuel utilisateur

Belkin

Belkin F6C350-USB Manuel utilisateur

Belkin

Belkin 600VA Manuel utilisateur

Belkin

Belkin F6C700 Manuel utilisateur

Belkin

Belkin F6H350-USB Manuel utilisateur

Belkin

Belkin F6H375-USB Manuel utilisateur

Belkin

Belkin F6C700-EUR Manuel utilisateur

Belkin

Belkin F6C1100-UNV Manuel utilisateur

Belkin

Belkin F6C900.1100UNVT Manuel utilisateur

Manuels UPS populaires d'autres marques

Pylontech

Pylontech Victron & Pylontech US5000 Manuel utilisateur

Tecnoware

Tecnoware EVO DSP PLUS MM 6.8 Manuel utilisateur

Mecer

Mecer ME-1000-WTU Manuel utilisateur

Mustek

Mustek PowerMust 530(B) Plus Manuel d'installation et d'exploitation

Emerson

Emerson Liebert NXL series Manuel utilisateur

MAKELSAN

MAKELSAN BOXER SERIES Manuel utilisateur

Block

Block PC-0524-400-0 Manuel utilisateur

CyberPower

CyberPower CP585LCD Manuel utilisateur

Eaton

Eaton 3S Instructions de montage

CyberPower

CyberPower Office Tower Series UPS 1000 Manuel utilisateur

CyberPower

CyberPower BM100 Manuel utilisateur

Best Power

Best Power 610 Manuel utilisateur

Best Power

Best Power Unity/I UT3K Manuel utilisateur

Mustek

Mustek PowerMust 400 Offline Manuel utilisateur

Xantrex

Xantrex Trace 512 UR-UPS Manuel utilisateur

Forza

Forza SL-1501UL Manuel utilisateur

LEGRAND

LEGRAND keor 310081 Manuel utilisateur

ABB

ABB Conceptpower DPA 500 Manuel utilisateur