CURRENT REVISION LOG
1MANUL222 Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
Under Drive Motor in step 4 added note to use both safety brackets in
order to jack the machine up evenly.
Under Drive Motor in Step 8 added note to use either both safety
brackets per side or all four safety brackets to jack the machine up
evenly.
Added images to the following instructions: Changing a Roller or Drive
shaft, Replacing a Bent Shaft or Wheel Bearing, Replacing a
Motor/Gearbox Assembly, Wheel Motors, Drive Motors, Replacing an
Arm Rotation Bearing, Replacing A Pivot Shaft Assembly, Inside the
Pods
Updated the image in Carbon Tank. Updated the following sections
per current practices: Backflush and Exchanging Carbon
Added Pulsatron Suction and Discharge Valve - Replacement
Procedure and Questions to ask prior to returning a Pulsatron
Solenoid Metering Pump
Removed the reference to part numbers & concentrate/non-
concentrate pumps in the titles per the current product offering
Under Remove Motor Gearbox Assembly step 8 added note to
examine the rubber grommets and replace if needed.
Updated and added images per the curent design and current
practices
Changed Zone 1 image, frame legs are to be on exit side of the head
beam
Changed Zone 1 note from End Clamp to Rail Stop Clamp Assembly
Changed Overview image the legs on the 4 legged frames face out
Changed Zone 1 image, frame legs are to be on exit side of the head
beam
Changed Zone 1 note from End Clamp to Rail Stop Clamp Assembly
Changed Zone 1 image, frame legs are to be on exit side of the head
beam
Changed Zone 1 note from End Clamp to Rail Stop Clamp Assembly
Changed Zone 1 image, frame legs are to be on exit side of the head
beam
Changed Zone 1 note from End Clamp to Rail Stop Clamp Asembly
Changed Overview image the legs on the 4 legged frames face out
Changed Zone 1 image to show correct distance from Rail Stop
Assembly to L-Bracket Assembly
Changed Zone 1 note from End Clamp to Rail Stop Clamp Assembly
Changed Frame Rail Stop Clamp Assembly Locations image the legs
on the 4 legged frames face out
Changed Zone 1 note from End Clamp to Rail Stop Clamp Asembly
Updated cap attachment per the current design
Updated images on these pages (per Change Request #32):
Combined images in Zone 1 & 2, changed sub heading from Zone 1
to Zone 1: 108251 and removed Zone 2 heading and image
Combined images in Zone 3 & 4, changed sub heading from Zone 3
to Zone 2: 108178
In Zone 1 & 4 images changed part number 7381 to 7181
Added note to both Zone 1 & 2 images: See the enlarged image of
this assembly for part numbers.
Moved enlarged image of bearing from page 4-15 to 4-14 and added
part numbers 1WASHR-FL498(4) and 1NUT-LC214 (4)
In Zone 2 changed 1FSTNR-SH177(3) to 1FSTNR-SH148(3) and
1FSTNR-SH457(2) to 1FSTNR-FH750(4) per the BOM
