Behringer K-2 Manuel utilisateur

page 1 of 2

985-40000-01088 Rev.A

2021-02-03

Condential, for internal use only. Not to be reproduced.

Analog and Semi-Modular Synthesizer with

Dual VCOs, Ring Modulator, External

Signal Processor, 16-Voice Poly Chain and

Eurorack Format

Synthesizers and Samplers

K-2

User Support Bulletin

Calibration Procedure

Set the K-2 controls as shown.

Make sure your K-2 has been powered on for more than 30 minutes, and that it is in a place where the temperature will

not change drastically while performing the calibration.

Follow all steps in the order in which they are presented.

Introduction

The unit is carefully calibrated at the factory. The performance may change over time or due to environmental changes,

and the following recalibration procedures can be used to bring it back to its factory settings.

page 2 of 2

985-40000-01088 Rev.A

2021-02-03

Condential, for internal use only. Not to be reproduced.

page 2 of 2

Condential, for internal use only. Not to be reproduced.

Music Tribe accepts no liability for any loss which may be suered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein.

Technical specications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik,

Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Oberheim, Auratone and Coolaudio are trademarks or registered trademarks of Music Tribe Global

Synthesizers and Samplers

K-2

VCO PITCH Calibration

Press and hold “TRIG SW” while powering up to enter the testing mode. (In this mode, the ON LED will blink yellow).

The K-2 has an internal calibration routine to calibrate the pitch of the VCO.

Press and hold “TRIG SW,” and then set the “FILTER1/2” switch. The ON LED will light yellow, indicating that the

VCO calibration has begun.

Wait until the ON LED changes color:

- Green indicates that the calibration was successful.

- Red indicates calibration failure. If this occurs, turn o the power and repeat from Step1.

Restart the unit.

End of Procedure

Table des matières

Autres manuels Behringer Synthétiseur

Behringer

Behringer PRO-VS MINI Manuel utilisateur

Behringer

Behringer CRAVE Manuel utilisateur

Behringer

Behringer PRO-1 Manuel utilisateur

Behringer

Behringer NEUTRON Guide de référence

Behringer

Behringer POLY D Manuel utilisateur

Behringer

Behringer MS-1 Manuel utilisateur

Behringer

Behringer NEUTRON Instructions d'utilisation et d'entretien

Behringer

Behringer ODYSSEY Manuel utilisateur

Behringer

Behringer FILTAMP MODULE 1006 Manuel utilisateur

Behringer

Behringer NEUTRON Manuel utilisateur

Behringer

Behringer SYSTEM 15 Manuel utilisateur

Behringer

Behringer DeepMind 6 Manuel utilisateur

Behringer

Behringer K-2 Manuel utilisateur

Behringer

Behringer SYSTEM 55 Manuel utilisateur

Behringer

Behringer MS-1-BK Manuel

Behringer

Behringer 110 VCO/VCF/VCA Manuel utilisateur

Behringer

Behringer 962 SEQUENTIAL SWITCH Manuel utilisateur

Behringer

Behringer PRO-800 Manuel utilisateur

Behringer

Behringer Victor Manuel utilisateur

Behringer

Behringer UB-Xa Manuel utilisateur

Behringer

Behringer VOCODER VC340 Manuel utilisateur

Behringer

Behringer SYSTEM 55 Manuel utilisateur

Behringer

Behringer MonoPoly Manuel utilisateur

Behringer

Behringer PRO-1 Manuel utilisateur

Manuels Synthétiseur populaires d'autres marques

Kawai

Kawai MP7 Manuel technique

Joranalogue

Joranalogue Contour 1 Manuel utilisateur

Full Bucket Music

Full Bucket Music Mono/Fury Manuel utilisateur

Kawai

Kawai PH50 Manuel utilisateur

IK Multimedia

IK Multimedia UNO Synth PRO X Manuel utilisateur

Roland

Roland Gaia SH-01 Manuel utilisateur

Roland

Roland GR-30 Manuel utilisateur

Gotharman

Gotharman Gotharman's anAmoNo-box Manuel utilisateur

Yamaha

Yamaha DX21 Manuel utilisateur

QuStream

QuStream HDFS-550 Manuel utilisateur

Modal Electronics

Modal Electronics ARGON8 Manuel utilisateur

Roland

Roland GS-500 Manuel utilisateur

Octave

Octave Cat SRM Manuel utilisateur

Dreadbox

Dreadbox Murmux Initiate Manuel utilisateur

neutral labs

neutral labs ELMYRA 2 Manuel utilisateur

Waldorf

Waldorf KYRA Manuel utilisateur

Tubbutec

Tubbutec Juno-66 Manuel utilisateur

EFM

EFM VCADSR - 3510 Manuel utilisateur