Bebe Care Petit Manuel utilisateur

STROLLER

MODEL # 011301

IMPORTANT: RETAIN FOR

FUTURE REFERENCE,

READ CAREFULLY

SAFETY PRECAUTIONS

Fingers or parts of the body could be injured when the stroller is being folded or unfolded. Please use

caution when folding or unfolding the stroller.

Always check that safety locks are engaged before placing a child in the stroller.

Ensure your child is secured with a correctly adjusted safety harness.

Do not allow children to stand on the seat.

Do not hang bags or goods from the handle as this could cause the stroller to tip over.

Do not place more than 3kgs in the basket or 1kg in the hood pocket (if supplied).

The weight of the child using the product should not exceed 17kgs.

The height of the child using the product should not exceed 96cm.

It is unsafe to use parts other than those approved by the manufacturer.

Never ride with more than one child in the stroller.

Regularly inspect all parts and locking devices, promptly replace worn out or broken parts.

Never leave a child in the pram/stroller when ascending or descending stairs or escalators or when

travelling on other forms of transport.

To prevent the risk of the stroller catching ﬁre, do not park it near an open ﬁre, heater or barbeque.

Do not make any changes or alterations to this product, unless through an approved service agent.

To avoid the risk of suffocation, keep all plastic packaging materials out of reach of children.

Never leave safety harness connected when not ﬁtted to a child in the stroller as this may create loops

that could cause a strangulation hazard.

Ensure the storage latch is fully engaged when lifting or carrying the stroller

TO AVOID INJURY OR DEATH:

ALWAYS APPLY THE BRAKES WHENEVER THE STROLLER IS

STATIONARY.

DO NOT LEAVE CHILD UNATTENDED.

SECURE THE CHILD IN THE HARNESS AT ALL TIMES.

DO NOT CARRY EXTRA CHILDREN OR BAGS ON THIS STROLLER.

MAKE SURE CHILDREN ARE CLEAR OF ANY MOVING PARTS IF

YOU ADJUST THE STROLLER.

TO AVOID INJURY ENSURE THAT YOUR CHILD IS KEPT AWAY

WHEN FOLDING AND UNFOLDING THE STROLLER.

ENSURE THAT ALL LOCKING DEVICES ARE ENGAGED BEFORE USE

WARNING

Before assembling this stroller, read and understand the instructions. Incorrect assembly may make the stroller

unsafe. Do not use this stroller if any part is broken, torn or missing. Keep instructions in a safe place for future

reference.

Due to variations in the style and design of our products, the photographs and illustrations

shown in this instruction manual are generic, therefore product fabrics, colour and design

may vary from images shown. CNP Brands reserves the right to alter product speciﬁcations

without notice as a result of our ongoing policy of product improvement.

Assembly contents list

Assembly / Operating instructions

Stroller accessories

How to care for your bebe care stroller

Contents

Congratulations on your purchase of the

bebe care Petit Stroller.

This product has been designed and developed with

safety, comfort and functionality in mind. Please take

the time to read this manual carefully before using

this product and keep it in a safe place for future

reference.

Supplied loose in box:

Check what you have received...

You have received 1 box. Please check the contents of the box against the list below. If anything is

missing, please contact Customer Service. In Australia, contact CNP Brands on 1300 667 137, in

New Zealand contact Wainhouse Distribution on 0800 567 5000.

Frame

Assembly Contents Assembly Instructions

Bumper bar

Infant carrier adapters

Opening the stroller

1. The stroller should be in the locked position when it is

unpacked. To unlock and open the stroller, please use the

following steps.

2. Grasp the stroller latch and pull outward to unlock the stroller.

WARNING: Keep ngers clear of all moving parts when opening or closing stroller.

Assembly / Operating Instructions

3. Lift up the stroller by the handle and

move forward simultaneously until the

stroller opens and ‘clicks’ into position.

Assembly / Operating Instructions

1. Push in buttons on both sides of the frame. These are

located on the inner sides of the frame as per image.

2. Ensure hood is collapsed completely. Fold hood of

stroller back until it’s ush with the back of the stroller.

3. Lift the upper latches located on either side of the

stroller frame and push stroller forward. This will

disengage the stroller and collapse it.

4. Push down rmly to ensure the latch is locked into

place. Ensure the lock at the side is secure.

Folding the stroller

Assembly / Operating Instructions

1. Hold both straps whilst pushing in the

button of the seat adjuster strap and pull

outward to desired seat position.

2. Release straps by pushing in the bottom

of the seat adjuster strap and pulling

downwards.

1. To engage brake, push down on the red brake pedal with foot.

To unlock the brake, lift the brake on the rear wheels with foot.

Adjusting backrest

Using the rear brakes

WARNING: On unmade or uneven surfaces all swivels must be locked.

WARNING: Always apply brakes when parking stroller.

Removing the bumper bar

1. Squeeze the buttons on both sides of the bumper bar as per

image. Pull outwards from seat.

Canopy functions

1. Pull the canopy cover forward or push backward.

Assembly / Operating Instructions

Attaching the bumper bar

1. Insert front bumper bar into

openings on the sides of the seat.

Push gently until you hear a click

on both sides.

WARNING: The bumper is only used for the seat unit; do not use it for carrying the

carry cot._

1110

Assembly / Operating Instructions

Restraints - Harness

1. To secure the child in the harness, place left

hand buckle prong (b) on top of (a).

2. Hold both left hand buckle prongs (a) and (b)

together and insert it into buckle housing (e)

until it snaps into position.

3. Repeat previous steps for right hand buckle

prongs (c) and (d).

4. Once all attached, carefully adjust the harness

straps by pulling each slider (f) until the desired

t is achieved in the lap, shoulder and crotch

straps.

5. To release the buckles, squeeze the top and

bottom prongs (a) and (b), (c) and (d) together

until harness disengages.

CAUTION: Always adjust the harness when

changing the seating position of the child.

(a), (b): Left hand buckle prongs

(c), (d): Right hand buckle prongs

(e): Buckle housing

(f): Strap adjustment sliders

Top strap

Bottom

strap

To adjust waist strap

1. To loosen waist strap, push up both top and

bottom straps through buckle as circled in

diagram.

2. To place waist strap in desired position, slide

the bottom strap into position then pull the top

strap and tighten into position.

WARNING: Use this harness at all times.

Car Seat Adapter

1. Remove the seat from the frame of

the stroller. Insert the set of plastic

adapters into the slots where the seat

normally sits in position. Push gently

until the adapters ‘click’ and lock

into place. The left adapter should

be placed on the left when facing the

stroller from the front, and the right

adapter on the right when facing the

stroller from the front.

This adaptor is designed for Maxi Cosi Car Seat; to be used with the

following strollers:

bebe care Rverse / Rverse XT / Rverse XLR / Childcare Vogue

IMPORTANT:

Insert car seat into adaptor

1. Insert the Maxi Cosi car seat as per car seat manufacturer’s

instructions by aligning the plastic side parts of the car seat into

the corresponding adaptor.

2. Push the car seat down until it clicks into place.

3. Swing the car seat’s handle down while pressing both grey

levers on the car seat side handle moulds until it locks into

position.

4. Car seat can be attached to stroller frame in either forward

facing or reverse facing.

5. To rotate car seat in opposite direction; rotate the car seat

together with the adaptors and insert them into the side stroller

frame’s slots until it ‘clicks’ and locks into place.

WARNING: Lift the Maxi Cosi Car Seat upwards to ensure that it

is fully engaged and locked before use.

Assembly / Operating Instructions

1312

Assembly / Operating Instructions

To remove car seat from stroller frame

1. Simultaneously swing the car seat’s handle up while pressing

both grey levers on the car seat side handle moulds to release

the car seat.

2. Lift up car seat via the handle.

Folding stroller

NOTE: Both plastic adaptors can remain attached to the stroller frame when folding stroller.

Fold the stroller as per stroller manufacturer’s folding instructions.

To remove adaptor

To release the set of plastic adaptor from stroller, slide the red buttons

on the side of the plastic adaptor and lift them out of the stroller

frame slots.

Tether strap

Ensure tether strap is used at all times. Make sure your hand is fed

through the loop as shown.

How to care for your stroller

Cleaning

To ensure the long-lasting use of your change table, wipe down with a damp cloth and use a

mild soap solution if necessary. Do not use abrasive cleaners. Always store product in a clean

dry place.

Maintenance

Always check parts regularly for tightness of bolts, nuts and other fasteners – tighten or

replace if required. To maintain the safety of your change table, seek prompt repairs for bent,

torn, worn or broken parts. Use only those parts and accessories approved by CNP Brands.

If you have any difculties in assembling the change table, please contact our Service

Department. In Australia, contact CNP Brands on 1300 667 137, in New Zealand contact

Wainhouse Distribution on 0800 567 5000.

Distributed in Australia by CNP Brands, 20 Calarco Drive, VIC, 3030

Customer Service 1300 667 137 www.cnpbrands.com.au

Distributed in New Zealand by Wainhouse Distribution, 2-6 Argyle St,

Morningside, PO Box 41-014, St Lukes, Auckland, New Zealand

Customer Service: 0800 567 5000 [email protected]

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Bebe Care Poussette

Bebe Care

Bebe Care Mira Lite Manuel utilisateur

Manuels Poussette populaires d'autres marques

Hauck

Hauck Priya Trioset Manuel utilisateur

CHILDHOME

CHILDHOME CWQDN Manuel utilisateur

Dreamer Design

Dreamer Design Rebound GST Manuel utilisateur

Britax

Britax STEELCRAFT AGILE Manuel utilisateur

Graco

Graco 7427 Manuel utilisateur

Comfort

Comfort COMPASS Manuel utilisateur

OBaby

OBaby Aura Manuel utilisateur

Tutek

Tutek Tirso Manuel utilisateur

Babify

Babify Dual Plus Manuel utilisateur

Graco

Graco Stroller Manuel utilisateur

Special Tomato

Special Tomato Jogger Manuel utilisateur

Chicco

Chicco CORTINA TOGETHER TWO-PASSENGER STROLLER Manuel utilisateur

Otto Bock

Otto Bock Kimba neo Manuel utilisateur

Milly Mally

Milly Mally ROYAL Guide de démarrage rapide

Hauck

Hauck DUETT 3 PRAM Manuel utilisateur

BOB

BOB DUALLIE Manuel utilisateur

Nuna

Nuna Pepp Manuel utilisateur

Britax

Britax B2 Manuel utilisateur