If the double profile cylinder
is already installed, continue
with Step 10. Otherwise, install
the double profile cylinder as
follows:
3. Remove the screws and spring
washers (19) from the cylinder plate (18).
4. Take the cylinder plate out and remove
the plastic insert.
5. Remove the gear inserted under the
cylinder plate (4, 5)
6. Slide one part (4) of the gear onto the
double profile cylinder from the left, and
the other part (5) from the right. The wider
segment of the gear parts is placed on
the lock pin (21) of the double profile
cylinder. Both parts form an interlocking
connection with the locking nose.
7. Insert the double profile cylinder into
the cylinder plate (18) and fasten the
cylinder with the M5x15 screws (20) and
spring washers (23).
8. Slide the gear racks (2, 3) onto the
stop, so that the crossbar is in what will
later become the opening position. The
locking bit must fit into the wide recess
on the gear rack.
9. Now insert the assembled cylinder into
the reinforced bolt lock with the cylinder
plate and fasten the plate with the screws
and spring washers (19).
Now fasten the reinforced bolt lock to
the door:
10. Place the reinforced bolt lock with the
inserted double profile cylinder, so that
the cylinder is in the drill hole in the door.
11. Align the crossbar with the spirit level
and mark both fastening holes for the ZA
outer rosette (16).
12. Drill the holes with a 12 mm Ø drill bit.
13. Reinsert the reinforced bolt lock, slide
the ZA outer rosette (16) over the locking
cylinder on the outer side of the door and
fasten the rosette with the spring washers
and M4x10 screws (19) (cylinder head).
14. Check the alignment with the spirit
level, mark the holes at the ends (24).
15. Drill the holes and fasten the
reinforced bolt lock to the door leaf with
the M5x35 screws (17).
16. Put the cover (7) back on and press
the side parts (6) and the plastic inner
rosette (15) in.
(covert)
X = bolt adjustable three times on both sides
