Barco Coronis Fusion 4MP Manuel utilisateur

Getting Started Guide

Nio Fusion 4MP

(This page intentionally left blank.)

This document is copyrighted. All rights are reserved. Nor this

document, nor any part of it, may be reproduced or copied in any form

or by any means - graphical, electronic, or mechanical including

photocopying, taping or information storage and retrieval systems -

without written permission of Barco

Table of Contents

Preface ....................................................................................... 5

Environmental information................................................................. 9

Safety Instructions............................................................................. 10

Explanation of symbols ..................................................................... 13

Introduction ............................................................................. 15

Display parts, controls and connectors............................................. 16

Front............................................................................................ 16

Rear............................................................................................. 17

Connectors .................................................................................. 19

Display installation .................................................................. 23

Installation precautions..................................................................... 24

Connecting the signal cables ............................................................ 25

Cable routing ..................................................................................... 28

Vesa-mount installation.................................................................... 29

Where to get more information .............................................. 31

Troubleshooting ....................................................................... 35

General tips........................................................................................ 36

Warranty Statement ................................................................ 41

Preface

Table of Contents

Notice

Although every attempt has been made to achieve technical accuracy in

this document, we assume no responsibility for errors that may be

found. Our goal is to provide you with the most accurate and usable

documentation possible; if you discover errors, please let us know.

BarcoView software products are the property of BarcoView. They are

distributed under copyright by Barco N.V. or BarcoView, LLC., for use only

under the specific terms of a software license agreement between

Barco N.V. or BarcoView LLC. and the licensee. No other use, duplication,

or disclosure of a BarcoView software product, in any form, is

authorized.

The specifications of BarcoView products are subject to change without

notice.

Trademarks

All trademarks and registered trademarks are property of their

respective owners.

FCC Compliance Information (display)

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the

limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

Table of Contents

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for

help.

Canadian notice

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la Classe A est conforme à la norme NMB-

003 du Canada.

FCC Compliance Information (display controller)

CLASS B:

This Barco Graphics Controller complies with part 15 of the FCC rules.

Operation is subject to the following two conditions:

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC rules. These limits

are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with manufacturer’s instructions, may cause harmful

interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Re-orient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

1. This device may not cause harmful interference, and

1. this device must accept any interference received, including

interference that may cause undesired operation.

Table of Contents

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for

help.

The use of shielded cables for connection of the monitor to the

graphics card is required to ensure compliance with FCC regula-

tions. Changes or modifications to this unit not expressly

approved by Barco could void the user’s authority to operate this

equipment.

Environmental information

Disposal Information

The lamps inside the display contain mercury. Do not throw the display

in the trash. Dispose of it as required by local ordinances or regulations.

This equipment has required the extraction and use of natural resources

for its production. It may contain hazardous substances for health and

environment.

In order to avoid the dissemination of those substances in the

environment and to diminish the pressure on natural resources, we

encourage you to use the appropriate take-back systems.

Those systems will reuse or recycle most of the materials of your end-

of-life equipment in a sound way.

The crossed-out wheeled bin symbol invites you to use those

systems.

If you need more information on the collection, reuse and

recycling systems, please contact your local or regional waste

administrator.

You can also contact us for more information on the environmental

performances of our products.

Safety Instructions

General Recommendations

Read the safety and operating instructions before operating the display.

Retain safety and operating instructions for future reference.

Adhere to all warnings on the display and in the operating instructions

manual.

Follow all instructions for operation and use.

Electrical shock

Type of protection (electrical):

Display with external power supply: Class III equipment

Degree of safety (flammable anesthetic mixture):

Equipment not suitable for use in the presence of a flammable

anesthetic mixture with air or with oxygen or nitrous oxide.

Non-patient care equipment

Equipment primarily for use in a health care facility that is intended for

use where contact with a patient is unlikely.

Power connection - display with external power supply

• Power requirements: The display must be powered using a

medical approved 24 VDC SELV power supply.

• The medical approved DC power supply must be powered by the

AC mains voltage.

Autres manuels pour Coronis Fusion 4MP

Table des matières

Autres manuels Barco Moniteur

Barco

Barco MDRC-2124 Manuel utilisateur

Barco

Barco MVGD 1319 Mode d’emploi

Barco

Barco iStudio Manuel utilisateur

Barco

Barco OverView OVL815 Manuel du propriétaire

Barco

Barco MDRC-2120 Manuel du propriétaire

Barco

Barco iTraffic Manuel utilisateur

Barco

Barco Nio 5MP LED Manuel utilisateur

Barco

Barco Coronis Fusion 6MP Manuel utilisateur

Barco

Barco Coronis 21-inch Installation & user manua Manuel utilisateur

Barco

Barco WeaveMaster Manuel utilisateur

Barco

Barco MDCC-6430 Manuel utilisateur

Barco

Barco DM-1126 Manuel utilisateur

Barco

Barco MDNG-5221 Manuel utilisateur

Barco

Barco MDSC-2326 DDIH Manuel utilisateur

Barco

Barco Coronis 3MP LED Manuel utilisateur

Barco

Barco Eonis MDRC-2222 WP Manuel utilisateur

Barco

Barco MRDS Manuel utilisateur

Barco

Barco Coronis 3MP LED MDCG-3221 Manuel utilisateur

Barco

Barco LC series R5976934 Manuel utilisateur

Barco

Barco MFGD 3220 D Manuel utilisateur

Barco

Barco MDRC-2124 TS Manuel du propriétaire

Barco

Barco RHDM-1701 Manuel utilisateur

Barco

Barco LCD 5521 V4 Manuel utilisateur

Barco

Barco MIVD 1218 Manuel utilisateur

Manuels Moniteur populaires d'autres marques

Linear Acoustic

Linear Acoustic LQ-1000 Manuel utilisateur

AOC

AOC I2579V Manuel utilisateur

Gateway

Gateway FPD1520 Manuel utilisateur

Furuno

Furuno Mu 120c Manuel utilisateur

Asus

Asus VB171D - 17" LCD Monitor Manuel utilisateur

Dell

Dell S2230MX Instructions d'utilisation

Philips

Philips 107C64 Manuel utilisateur

Dell

Dell S2409WFP Manuel utilisateur

EverFocus

EverFocus EN-7517E Manuel utilisateur

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Manuel utilisateur

Dell

Dell Precision 7680 Mode d’emploi

LG 50PM1M - - 50" Plasma Panel Manuel utilisateur

Bosch

Bosch DDU 9 Manuel utilisateur

Acer

Acer A231HL Manuel utilisateur

Philips

Philips 86BDL4152T Manuel utilisateur

NEC

NEC AccuSync LCD5V Manuel utilisateur

Emay

Emay SleepO2 Manuel utilisateur

IBM

IBM 6360 Instructions d'installation