AXIOMTEK CEM830 Series Manuel utilisateur
CEM830 Series
Intel®Core™ 2 Duo
COM Express™ Type-II Module
User’s Manual
ii
Disclaimers
This manual has been carefully checked and believed to contain
accurate information. AXIOMTEK Co., Ltd. assumes no responsibility
for any infringements of patents or any third party’s rights, and any
liability arising from such use.
AXIOMTEK does not warrant or assume any legal liability or
responsibility for the accuracy, completeness or usefulness of any
information in this document. AXIOMTEK does not make any
commitment to update the information in this manual.
AXIOMTEK reserves the right to change or revise this document
and/or product at any time without notice.
No part of this document may be reproduced, stored in a retrieval
system, or transmitted, in any form or by any means, electronic,
mechanical, photocopying, recording, or otherwise, without the prior
written permission of AXIOMTEK Co., Ltd.
CAUTION
If you replace wrong batteries, it causes the danger of explosion. It is
recommended by the manufacturer that you follow the manufacturer’s
instructions to only replace the same or equivalent type of battery,
and dispose of used ones.
©Copyright 2008 AXIOMTEK Co., Ltd.
All Rights Reserved
June 2008, Version A4
Printed in Taiwan
iii
ESD Precautions
Computer boards have integrated circuits sensitive to static electricity.
To prevent chipsets from electrostatic discharge damage, please take
care of the following jobs with precautions:
Do not remove boards or integrated circuits from their anti-static
packaging until you are ready to install them.
Before holding the board or integrated circuit, touch an unpainted
portion of the system unit chassis for a few seconds. It
discharges static electricity from your body.
Wear a wrist-grounding strap, available from most electronic
component stores, when handling boards and components.
Trademarks Acknowledgments
AXIOMTEK is a trademark of AXIOMTEK Co., Ltd.
Windows®is a trademark of Microsoft Corporation.
Phoenix & AWARD are trademarks of Phoenix Technology Ltd.
IBM, PC/AT, PS/2, VGA are trademarks of International Business
Machines Corporation.
Intel®and Pentium®are trademarks of Intel Corporation.
Winbond is a trademark of Winbond Electronics Corp.
Other brand names and trademarks are the properties and registered
brands of their respective owners.
iv
Table of Contents
Disclaimers........................................................................................................... ii
ESD Precautions ................................................................................................. iii
Chapter 1 Introduction.................................................................... 1
1.1 Specifications.......................................................................................... 2
1.2 Utilities Supported................................................................................... 3
Chapter 2 Board Layout and Pin Assignments............................ 5
2.1 Board Dimensions and Fixing Holes....................................................... 5
2.2 Board Layout........................................................................................... 7
2.3 Pin Assignments...................................................................................... 9
Chapter 3 Hardware Description.................................................. 19
3.1 Microprocessors.................................................................................... 19
3.2 BIOS...................................................................................................... 19
3.3 System Memory..................................................................................... 19
3.4 I/O Port Address Map (With CEB94000 under WinXP)......................... 20
3.5 Interrupt Controller (With CEB94000 under WinXP)............................. 22
3.6 Memory Map (With CEB94000 under WinXP)...................................... 23
Chapter 4 Award BIOS Utility....................................................... 25
4.1 Entering Setup....................................................................................... 25
4.2 Control Keys.......................................................................................... 26
4.3 Getting Help .......................................................................................... 26
4.4 The Main Menu ..................................................................................... 27
4.5 Standard CMOS Setup Menu................................................................ 28
4.6 Advanced BIOS Features...................................................................... 31
4.7 Advanced Chipset Features.................................................................. 36
4.8 Integrated Peripherals........................................................................... 40
4.9 Power Management Setup.................................................................... 44
4.10 PnP/PCI Configuration Setup................................................................ 48
4.11 PC Health Status................................................................................... 50
4.12 Frequency/Voltage Control.................................................................... 51
4.13 Load Optimized Defaults....................................................................... 52
4.14 Set Supervisor/User Password ............................................................. 53
4.15 Save & Exit Setup ................................................................................. 54
4.16 Exit Without Saving............................................................................... 55
Appendix A Watchdog Timer ........................................................... 57
Appendix B GPIO & Watchdog Timer Programming Source Code.......... 59
Appendix C Configuring SATA for RAID Function................................ 65
CEM830 COM ExpressTM Type-II Module User’s Manual
Introduction 1
C h a p t e r 1
Introduction
The CEM830 is a new COM ExpressTM Type-II Module to support
Intel®CoreTM 2 Duo, CoreTM Duo, and Celeron®M processors with
533/667MHz FSB. It is practically finest embedded Socket M (478-pin)
computer-on-module in the market. It integrates Intel®945GME &
ICH7M chipsets, excellent Multiple I/O, LVDS LCD, Fast/Gigabit
Ethernet and AC'97/HD digital Audio interface to make all in one
single module as computing engine. It provides one PCI Express X16
for graphics or SDVO, PCI Express X1, 32-bit/33MHz PCI master
which are for expansion purpose.
This module supports various I/O features: CRT, LVDS LCD,
Fast/Gigabit Ethernet, HD Audio, PATA IDE, SATA IDE, USB 2.0,
GPIO and Watchdog timer.
CEM830 COM ExpressTM Type-II Module User’s Manual
Introduction
2
1.1 Specifications
zCPU: Socket M (478-pin) for Intel®CoreTM 2 Duo, CoreTM Duo,
and Celeron®M processors
zSystem Chipset: Intel®945GME & ICH7M
zCPU Frequency: 533/667MHz FSB
zBIOS
Phoenix-Award BIOS, Y2K compliant
4Mbit Flash, DMI, Plug and Play
SmartView for multiple LCD type selection, display
mode option and application extension features
“Load Optimized Default” to backup customized Setting in
the BIOS flash chip to prevent from CMOS battery fail
zSystem Memory
Two x 200-pin DDR2 SO-DIMM sockets
Maximum to 4GB DDR2 memory (Intel 945GME supports
DDR2-400/533/667 up to 4GB, the actual maximum
capacity will be less depending on system configuration)
zL2 Cache: integrated in CPU
zUSB Interface
Eight USB ports with fuse protection and complies with
USB Spec. Rev. 2.0
zGraphics:
Intel®945GME GMCH Gen 3.5 integrated graphic engine
CRT and LVDS LCD output
Maximum up to 224MB frame buffer sharing system
memory
Maximum display resolution:
CRT: 2048 x1536
LVDS: 1920 X1200 (18 or 24-bit
single/dual channel LVDS interface)
zExpansion Interface:
One PCI Express X16 interface for SDVO ADD2+ Card as
default (PCI Express X16 for discrete graphics is optional
CEM830 COM ExpressTM Type-II Module User’s Manual
Introduction 3
with on-board LVDS function removal)
Four PCI Express X1 interface (CEM830VE version)
Three PCI Express X1 interface (CEM830VG version)
Four 32-bit/33MHz PCI master
zEthernet:
Intel®i82562GZ for PCI-E Fast Ethernet and optional with
co-layout as Intel® i82573V for Gigabit Ethernet
zAudio:
HD Audio
zPower Management:
ACPI (Advanced Configuration and Power Interface)
NOTE All specifications and images are subject to change
without notice.
1.2 Utilities Supported
zChipset Driver
zVGA Driver
zEthernet Driver
zAudio Driver
zRAID Driver
CEM830 COM ExpressTM Type-II Module User’s Manual
Introduction
4
MEMO
CEM830 COM ExpressTM Type-II Module User’s Manual
Jumpers and Connectors 5
C h a p t e r 2
Board Layout and Pin Assignments
2.1 Board Dimensions and Fixing Holes
Component Side
CEM830 COM ExpressTM Type-II Module User’s Manual
Jumpers and Connectors
6
Solder Side
Table des matières
Autres manuels AXIOMTEK Système d'E/S
AXIOMTEK
AXIOMTEK AX93276 Manuel utilisateur
AXIOMTEK
AXIOMTEK ETM710 Series Manuel utilisateur
AXIOMTEK
AXIOMTEK AX5214P Manuel utilisateur
AXIOMTEK
AXIOMTEK eBOX550-100-FL Series Manuel utilisateur
AXIOMTEK
AXIOMTEK AX93292 Manuel utilisateur
AXIOMTEK
AXIOMTEK AX93267 Manuel utilisateur
AXIOMTEK
AXIOMTEK AX93A07 Manuel utilisateur
AXIOMTEK
AXIOMTEK NA346 Series Manuel utilisateur
AXIOMTEK
AXIOMTEK AC5410P Manuel utilisateur
