AVFI LFT7000FS Manuel utilisateur
VFI
Assembly Instructions
LFT7000FS Fixed stand
Thank you for purchasing AVFI’s LFT7000FS fixed stand.
This stand is designed for TV setups totaling up to 280lbs.
Confirm all hardware is included before you begin assembly.
Read these instructions start to finish before beginning installation.
Note: If you cannot understand these instructions or are concerned about safety
of the installation contact a qualified contractor or contact AVFI at 1-877-834-3876.
Supplied Parts
Supplied Hardware (additional to hardware bags)
1
www.video-furn.com 190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
M8 X 40
(4)
Tower
Box 1
Not all hardware supplied will be used.
TV Hardware bag
x2 if dual mount
Tools required
TV Brackets
S (shown)/XL/D
Box 3+ Tube
M8 Nut
(6) Wrench or Socket set
Allen Keys found
In hardware bag
Keys
(6)
Fixed Base
Box 2
1/2 X 1
(2)
VF
I
Assembly Instructions
LFT7000FS Stand
www.video-furn.com 190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
1
2
2
Unlock and remove front panels.
Attach base using
Included nuts and Bolts.
TIP: Attach all fasteners before tightening.
VF
I
Assembly Instructions
3
www.video-furn.com 190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
LFT7000FS Stand
Install rack equipment and run wiring.
Unlock and remove rear top panel.
Pull panel straight out, keep parallel.
Plug in and test run unit up and down.
Then install and lock front top panel.
4
3
Insert Tube into carriage openings.
Center and tighten using M8 bolts.
(Single version shown)
5
VF
I
Assembly Instructions
LFT7000FS Stand
www.video-furn.com 190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
6
4
Install TV brackets onto back of TV.
Remove top bolts if present
X
Lower to bottom position
To hang TV.
See step 8.1 before
proceeding.
Hang TV onto
tube.
7
VF
I
Assembly Instructions
LFT7000FS Stand
www.video-furn.com 190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
8
5
Lock TV onto tube.
VF
I
Assembly Instructions
LFT7000FS Stand
www.video-furn.com 190 Don Hillock Drive |Aurora |Ontario|L4G 0G9 | 1.877.834.3876
9
6
Confirm all cable clearances when moving up
and down. Reinstall and lock rear panel.
Finished.
Floor anchoring holes x4. (optional step)
Levelers x2.
Use small wrench to adjust.
Autres manuels AVFI Support et étagère
Manuels Support et étagère populaires d'autres marques
Salamander
Salamander Acadia AC/W/L400/WH Manuel utilisateur
Fohhn
Fohhn VAT-09 Guide de l'utilisateur
ricoo
ricoo FS0522 Manuel utilisateur
AMSOIL
AMSOIL BMK-22 Guide rapide
Kargo Master
Kargo Master 48220 Manuel utilisateur
Milestone AV Technologies
Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur
