Window for Infrared Receiver
PRINTER INSTALLATION
1. Disconnect any load clamps
from the battery and unplug
the unit from any AC source
before installing the AC-14
printer..
2. Loosen the thumbscrew at
the bottom of the printer
cover plate and remove
entire cover. Save cover if
you think you might want
to use your tester without
a printer. Do not operate
without the printer or cover
plate installed.
3. Carefully pull the printer ribbon cable through the door opening as
shown in the illustration above, but do not disconnect the cable from
the PC board located just behind the front panel.
4. Align the ribbon cable parallel to the printer as shown below.
Note: Next to the PC board the ribbon cable runs in from the
connector. At the printer the ribbon wraps in front as shown.
Do not twist or fold the ribbon cable.
5. Carefully attach the ribbon connector to the pins at the printer. Use
care and do not force. Consider that the pins may not be aligned
Infrared Receiver
This window should be kept clear of obstructions if an Auto Meter hand-
held tester is used to send an infrared signal.
properly.
6. Install the printer making sure the
ribbon is on the outside of the paper
shield and is not crimped at the
door edge. Insert the top tab under
the panel before tightening the
thumbscrew.
Standard 58mm roll thermal paper is
available at your ofce supply
LIMITED WARRANTY
AC-14 1 YEAR FROM DATE OF PURCHASE
The manufacturer warrants to the consumer that this product
will be free from defects in material or workmanship for a
period of one (1) year from the date of original purchase.
Products that fail within this 1 year warranty period will
be repaired or replaced at the manufacturer's option to the
consumer when determined by the manufacturer that the
product failed due to defects in material or workmanship. This
warranty is limited to the repair or replacement of parts and
the necessary labor by the manufacturer to effect the repair or
replacement of the product. In no event shall the manufacturer
be responsible for special, incidental or consequential damages
or costs incurred due to the failure of this product.
Improper use, accident, water damage, abuse, unauthorized
repairs or alterations voids this warranty. The manufacturer
disclaims any liability or consequential damages due to breach
of any written or implied warranty on its test equipment.
WARRANTY AND SERVICE INFORMATION
Warranty claims to the manufacturer's service department
must be transportation prepaid and accompanied with dated
proof of purchase. This warranty applies only to the original
purchaser and is non-transferable. Shipper damage incurred
during return shipments is not covered under this warranty. It
is the responsibility of the shipper (the customer returning the
Test Equipment) to package the tester properly to prevent any
damage during return shipment. Repair costs for such damages
will be charged back to shipper (customer returning the Test
Equipment). Protect the product by shipping in the original
carton. Add plenty of over-pack cushioning such as crumpled
up newspaper.
