AFTER SALES SUPPORT
1 888 367 7373 customer-service@wk-usa com 2-12-14 / ZQ2001
PLEASE READ AND SAVE ALL INSTR CTIONS TO ENS RE THE SAFE AND EFFECTIVE SE OF THE JACK STANDS.
•Read, understand and follow all the instructions before operating this device. Failure to heed all warnings could
result in severe personal or bystander injury, even death and/or property damage.
•DO NOT exceed rated capacity. Load should be evenly distributed over the 2 Jack Stands or the Jack Stands may
fail causing severe injury or death.
•Use only on a hard level surface.
•Place the load in the center of the saddle only.
•DO NOT drop the vehicle onto the Jack Stands, even if the load is less than the weight capacity limit. The force of
the weight dropping on the Jack Stands may cause the Jack Stands to fail.
•DO NOT move the release handle when the Jack Stands are supporting a vehicle.
•Use Jack Stands as a matched pair to support one end of a vehicle only.
•These Jack Stands are not to be used to simultaneously support both ends or one side of a vehicle.
•Lift only areas of vehicle as specified by the vehicle manufacturer.
•DO NOT get under or allow anyone under the vehicle until it has been supported by the Jack Stands.
•DO NOT alter or modify this product.
•Visual inspections should be made before each use of the Jack Stands by checking for abnormal conditions such
as cracked welds and damaged, loose, or missing parts.
•If the Jack Stands are accidentally subjected to an abnormal load or shock they must be taken out of service
immediately and be inspected by a qualified repair or service center. It is recommended that owners and/or
operators perform an annual inspection of the Jack Stands.
•WARNING: before using the Jack Stands you must check to make sure that the tab is bent in and the ratchet mast
cannot be pulled up and out of the base. This prevents accidental removal of the ratchet mast from the base.
SAVE THESE
INSTR CTIONS!
General Information
General Information General Information
General Information
Safety Instructions
Safety InstructionsSafety Instructions
Safety Instructions
3
