Audiovox AS 9075a Manuel utilisateur

128-6601

1 of 4

Page 1

Model AS 9075a

Owner’sManual

Remote Start

Upgrade Module

FEATURES :

wRemote Start Safety Control Switch

wSelectable Automatic Timed Start Mode (2 Or 4 Hours Selectable intervals)

wOn-Board Start Relay

wOn-BoardAccessoryRelay

wOn-Board Ignition 1 Relay

wOn-Board Ignition 2 Relay

wIgnition 2 Relay Selectable On or Off During Cranking

wOn-Board Parking Light Relay

wIgnition 3 / Shock By-Pass / GM VAT Output (relay required)

wTach Signal Learning Circuitry

wTwo ( +) and Two ( -)Safety Shutdown Circuits

AlarmBy-Pass Outputs

Selectable Steady or Flashing Parking Lights for Run Indication

wSelectable 10 or 15 Minute Run Time

wFactoryKeyless UpgradeInputs(AllowsStartingFromFactoryKeylessEntryUnit)

w4 Auxiliary Outputs To Allow Control Of A Factory Alarm

wDiesel Glow Plug Preheat Mode select

CAUTION!

Be certain that the vehicle is outdoors before using this or any re-

motevehiclestartingdevice. Arunningengine produces dangerous

carbon monoxide fumes which can be harmful or fatal if prolonged

exposure occurs. DO NOT remote start the vehicle if the car is

garaged.

128-6601

2 of 4

Page 2

This Remote Start Upgrade unit is designed to be added to an existing remote

control keyless entry system, or remote alarm system.

Because it is an upgrade unit it can be wired to operate from any unused button(s)

from your keychain transmitter. Please check with your installing dealer for which

transmitter button is connected to your remote start unit and, if you require a

single, double, or sequential press of the button(s) to operate your system.

SAFETY(RedHandled )CONTROLSWITCH

The control switch allows you to temporarily disable the remote starting function

of your Remote Start System. To disable the unit, move the red handled control

switch to the off position.

The control switch also allows you to select between automatic 2 hour start up

or 4 hour start up when using the automatic start up timer mode. The factory

preset start up time for this mode is every 4 hours. To select between 2 or 4 hour

start up timer:

1.Begin with the control switch in the on position

2.Turn the ignition switch on then off

3.Within 10 seconds, move the control switch off, on, off, on (2 switch cycles) to

select a 2 hour start timer. After 10 seconds expire, the parking lights will

flash 2 times confirming that the two hour start cycle is set. Or, within 10

seconds move the control switch off, on, off, on, off, on, off, on (4 switch cycles)

to select a 4 hour start timer. The parking lights will flash 4 times confirming that

the 4 hour start timer is set.

REMOTESTARTINGTHEVEHICLE

The System WILL NOT start the vehicle if any one of the following conditions

exists:

1.The Vehicle Hood Is Opened.

2.The Gear Selector Is In Any Gear Other Then Park.

3.The Brake Is Depressed.

4.The Safety Control Switch Is In The Off Position.

CAUTION! Be certain that the vehicle is outdoors before using this or any remote

vehicle starting device. A running engine produces dangerous carbon monox-

ide fumes which can be harmful or fatal if prolonged exposure occurs. DO NOT

remote start the vehicle if the car is garaged.

128-6601

3 of 4

To Remote Start The Vehicle:

Press and release the proper button or combination of buttons on your keychain

transmitter to activate the remote start system. The vehicle will start and

remain running for the pre-programmed 10 or 15 minutes. As a visual indica-

tion, the parking lights will flash or turn on dependent on the programming set

up by your installation center.

When you arrive at your vehicle, unlock the vehicle by pressing and releasing

the unlock button of your keychain transmitter or by use of the vehicle key. Enter

the vehicle and turn the ignition key to the on position.

CAUTION! Do not turn the key to the start position. This will cause the starter

motor to engage with the already running

engine which could result in damage. Step on the brake

pedal to disengage the remote start unit. The vehicle will continue to run on it's

own power.

NOTE: The engine will stop running before the expiration of the pre-pro-

grammed run timer if you complete any of the

following:

1.Pressing the proper button or buttons of your keychain transmitter while run-

ning under control of the remote start system will turn

the vehicle off.

2.Depress the brake pedal.

3.Open the hood.

4.Move the red handled control switch to the off position.

5.Race the engine to above 4000 RPM.

OPERATINGONAUTOMATICSTARTUPTIMERMODE

The system has the ability to automatically start the vehicle every 2 or 4 hours

over a 48 hour period. This feature is especially useful in cold climates where

the only means to keep the engine and engine fluids warm is to periodically

start the engine.

CAUTION! Be certain that the vehicle is outdoors before using this or any re-

mote vehicle starting device. A running engine produces dangerous carbon

monoxide fumes which can be harmful or fatal if prolonged exposure occurs.

DO NOT remote start the vehicle if the car is garaged.

Page 3

128-6601

4 of 4

FUNCTIONSETTINGCHART

To be completed by installer

Lights Steady oPulse o

Run Time 10 Min. o15 Min. o

TOBEGINTHEAUTOMATICSTARTUPTIMER

1.Turn the ignition key on then off.

2.Within 10 seconds, activate the RF start command two times.

The parking lights will flash 4 times indicating the timed start mode is activated.

The vehicle, on a 2 or 4 hour interval basis, will automatically start, run

for the pre-programmed time (10 of 15 minutes), and then shut off. This will

continue for 48 hours.

NOTE: The automatic start up timer can also be initiated from the keychain trans-

mitter.

To do this:

1.Start the vehicle using the keychain transmitter by pressing and releasing the

remote start transmitter button'(s).

2.Shut off the vehicle using the keychain transmitter by pressing and releasing

the remote start transmitter button'(s).

3.Within 10 seconds of step 2, activate the RF start command two times.

The parking lights will flash 4 times indicating the timed start mode is activated.

CANCELINGTHEAUTOMATICSTARTUPTIMER

To cancel the automatic start up timer do one of the following;

1. Start the vehicle manually with the use of the ignition key and depress the

brake pedal.

2. Remote start the vehicle using your keychain RF transmitter.

And then

3. Shut off the vehicle using the keychain RF transmitter.

150 Marcus Blvd., Hauppauge NY 11788 ®(516) 231-7750

128-6601

Autres manuels pour AS 9075a

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Audiovox Démarreur à distance

Audiovox

Audiovox Prestige APS-905 Manuel utilisateur

Audiovox

Audiovox Pursuit PRO-9276 Manuel utilisateur

Audiovox

Audiovox JKRS3 Manuel utilisateur

Audiovox

Audiovox Pursuit PRO-9671FT Manuel utilisateur

Audiovox

Audiovox Prestige APS-55TWT Manuel utilisateur

Audiovox

Audiovox Pursuit PRO-9556 Manuel utilisateur

Audiovox

Audiovox Platinum+ APS 687C Manuel utilisateur

Audiovox

Audiovox Prestige APS-905 Manuel utilisateur

Audiovox

Audiovox PRO9555 Manuel utilisateur

Audiovox

Audiovox Patinum APS-997 Manuel utilisateur

Audiovox

Audiovox Prestige APS-56 Manuel utilisateur

Audiovox

Audiovox AS-9055T Manuel utilisateur

Audiovox

Audiovox Pursuit PRO-9276 Manuel utilisateur

Audiovox

Audiovox AS 9076N Manuel utilisateur

Audiovox

Audiovox aps787n Manuel utilisateur

Audiovox

Audiovox Auto Security AS-9501a Manuel utilisateur

Audiovox

Audiovox Pursuit PRO 9232a Manuel utilisateur

Audiovox

Audiovox APS620 - Prestige Remote Start Manuel utilisateur

Audiovox

Audiovox Prestige Platinum+ APS 675 Manuel utilisateur

Audiovox

Audiovox Pursuit PRO-9275 Manuel utilisateur

Audiovox

Audiovox Prestige APS-45 Manuel utilisateur

Audiovox

Audiovox AS-9055T Manuel utilisateur

Audiovox

Audiovox PURSUIT PRO-9056i Manuel utilisateur

Audiovox

Audiovox Prestige APS-45 Manuel utilisateur

Manuels Démarreur à distance populaires d'autres marques

AstroStart

AstroStart 803U Manuel utilisateur

Durite

Durite 0-649-20 Manuel

EINHELL

EINHELL BT-PS 1000 Manuel

Linear

Linear ACCESS AK-21 Caractéristiques techniques

Soundstream

Soundstream TARANTULA RS.2 Manuel utilisateur

Jaycar Electronics

Jaycar Electronics MB3752 Manuel utilisateur

Ultra Start

Ultra Start 72 Series Manuel utilisateur

ADS

ADS FLASHLOGIC FLRSVW1 Manuel utilisateur

Selecta

Selecta JS012 Manuel utilisateur

Black Widow Security

Black Widow Security BW RAS 400 Manuel utilisateur

Vector

Vector Power City DK080706 Supplément

Code Alarm

Code Alarm CA-535 Manuel utilisateur

Ozito

Ozito OJS-800 Manuel utilisateur

Profi-Partner

Profi-Partner 46387 Manuel utilisateur

EZ STARTER

EZ STARTER EZ-45 Manuel utilisateur

Viper

Viper 4204 Manuel utilisateur

Essex Electronics

Essex Electronics KE-1701 Manuel utilisateur

EINHELL

EINHELL EGS 3600 Manuel