Audiovox SP-6CDP Manuel utilisateur
OWNER’’
S MANUAL
MODEL : PAV-6CDP
6 COMPACT DISC AUTO CHANGER
1
* Tracks from 6 CDs stored in the disc magazine can be selected and
played.
* Horizontal, vertical, angled and suspended installation.
* Do not install the unit in a location where it may be
subjected to :
- direct sun or other forms of excessive temperature.
- excessive heat.
- fluid, rain or moisture.
- excessive dirt or dust.
- excessive vibration.
* This unit is designed to be operated on a 13.8 volt DC
negative ground electrical system only.
Notes on CDs
* A defective or soiled disc stored in the disc magazine can
cause sound to drop out during play.
* Always handle a disc by holding its inner and outer edges.
* Do not touch the surface of the
unlabeled side of the disc.
* Do not stick paper or tape etc.
onto a disc.
2
* Do not expose the discs to direct
sunlight or excessive heat.
* Clean the discs before inserting
them into the disc magazine.
Always clean a disc from center
outward with a cleaning cloth.
* Never use solvents such as benzine or alcohol to clean a disc.
* You cannot play an 8cm(3 inch) CD even with the specially
designed adapter.
Notes on the disc magazine
* Do not leave the disc magazine in a place subject to
excessive temperature or humidity.
* Do not insert more than one disc per slot.
* Do not drop the disc magazine.
3
1. * Pull out the slot by pulling
the part with finger.
* With the label side up, insert
a CD all the way
6 discs, one in each slot
* Push slot and close it.
3. Insert the magazine firmly
(which has been taken out
of the unit) with the
mark visible on the top side.
* Press the eject button and pull
out the disc magazine.
2. 4.
4
Precautions
Select the mounting location very carefully by referring to the following points
* Make sure that there is not a fuel tank, wiring or piping on the other side of
the mounting surface.
* Make sure that the installation of the unit will not hinder the movement of the
trunk lid or interfere with the spare tire etc.
* Use only the supplied mounting kit for a safe and proper installation.
Supplied mounting kit
BRACKET X 2 Double-sided
tape X 1
TAPPING
SCREW X 4
Adhesive
label X 1
WASHER
SCREW X 4
PLATE
BRACKET
BOLT X 4 NUT X 4
5
Installing the unit
Mounting angle setting lever
Be sure to adjust Mounting Angle
Setting Lever(A) to appropriate
angle; 0°for horizontal, 22.5°
angle, 45°angle, 67.5 angle, 80°
angle, or 90°for vertical.
Removing the transport
screws
Find the 3 transport screws at the
bottom of the unit, which lock the
unit’s mechanism during transport.
Remove these screws before
installation and attach the supplied
adhesive labels ④over the holes.
Retain these screws and replace
them in the original positions if the
unit is transported for service or
maintenance.
6
After adjustment, be sure to
attach the Double side Tape .
Note
Do the same procedure on
the other side of the unit.
Horizontal installation
Construction
Removing temporarily
Making holes on the carpet
Completion
Note
About parts numbers ❶❷
❺❻❼❽,refer to page 4.
angled installation
Be sure to turn the mounting
angle setting dial to the 45。
position.
7
Vertical installation
1. Construction
2. Removing temporarily
3. Making holes on the carpet
4. Completion
Note
About parts numbers ❶❷❺
❻❼❽, refer to page 4.
8
Suspended installation
When installing the unit in the
trunk under the rear window
shelf, observe the following.
- Make sure that the unit is
suspended horizontally.
- Select the mounting location
carefully so that the unit does
not hinder the movement of
the torsion bars of the trunk
lid.
- Make sure that there is nothing
on the other side of the
mounting location before drilling
the holes.
- Select the correct size screw to
avoid damaging the vehicle rear
deck.
1. Construction
2. Making holes
3. Completion
Note
About parts numbers ❶❷❺,
refer to page 4.
9
When connecting, run the
supplied connecting cable and
connect to Audiovox model
PAV-9 as illustrated here.
Caution
Make sure to disconnect the ground
wire terminal of the car battery before
making a connection in order to
prevent short circuiting.
Note
Use only the supplied connecting
cable.
For complete operation instructions,
refer to pages 18,19 and 20 in the
PAV-9 owner’s manual.
System
Usable Disc
Power Source
Weight
Dimensions(WXHXD)
Frequency Response
S/N Ratio
Channel Separation
T.H.D
Output Power
Note
The design features and/or specifications are subject to change
without notice.
6 CD Change system
Compact disc (12cm)
DC 13.8V Negative ground
1.9kg(4.2 lbs)
254×63×157mm(10”×2.5”×6.2”)
20~20kHz
90dB
70dB
0.03dB
700 mV
General
Autres manuels pour SP-6CDP
1
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Audiovox Lecteur CD
Audiovox
Audiovox CE240 Manuel utilisateur
Audiovox
Audiovox Rampage ACC-31 Manuel utilisateur
Audiovox
Audiovox CDA-475 Manuel utilisateur
Audiovox
Audiovox CE152MP Manuel utilisateur
Audiovox
Audiovox CDA1361 Manuel utilisateur
Audiovox
Audiovox CE1000X Manuel utilisateur
Audiovox
Audiovox CE145B Manuel utilisateur
Audiovox
Audiovox PRESTIGE P-MC3 Manuel utilisateur
Audiovox
Audiovox CE101C Manuel utilisateur
Audiovox
Audiovox DMP8733 Manuel utilisateur
Audiovox
Audiovox CE146B Manuel utilisateur
Audiovox
Audiovox CE150MP Manuel utilisateur
Audiovox
Audiovox CE101A - annexe 1 Manuel utilisateur
Audiovox
Audiovox CDC-10R Manuel utilisateur
Audiovox
Audiovox CE101B Manuel utilisateur
Audiovox
Audiovox Portable MP3 CD Player Manuel utilisateur
Audiovox
Audiovox SP-6CD Manuel utilisateur
Audiovox
Audiovox CE147 Manuel utilisateur
Audiovox
Audiovox CE154MP Manuel utilisateur
Audiovox
Audiovox CE531MP Manuel utilisateur
