5
1.1 Regulation：
1. Only qualified personnel are permitted to maintain and operate this machine.
2. Do not operate or attempt to repair the machine until you have read and
understood all manuals that pertain to the machine, plus all warning and
instructionplates/decals mountedon the machine.
3. Be mentally alert on the job and keepsafety in mind. Never attempt to operate
or repair a machine if you are under medicationor alcohol influence.
4. Wear safetyshoes and eye protection within the work area. Safety shoes should
be oil-resistant and safety glasses with side shields are stronglyrecommended.
5. Remove watches, jewelry andother accessoriesto avoid getting them caught in
movingparts.
6. Maintaina clean and orderly workspace around machine.
7. Store tools and miscellaneousparts properly. Be sure there are on articles
aroundthe machine.
8. Do not use compressed airs to blow chips form the machine spindle or table,
controls,cabinets,or the floor around the machine. Use a brush or chip scraper to
remove chips. Donot remove chips by handor while thespindle is turning. Make
sure that the cutter has completelystopped before attempting to remove chips.
Dispose of chips frequently.
09. Never start the machine when the cutter is in contact with the workplace. Make
sure the direction of spindle rotation is correct to prevent cutter breakage.
10. Know where all the EMERGENCYSTOP push buttons are located. Keep all
machine doors closed while the machine is in operation,including those on the
console and the electrical cabinets.
11. In the event of power failure, turn off main circuit breaker immediately.
