Atlona AT-IR300SRS Manuel utilisateur

www.atlona.com | toll free: 1-877-536-3976

For International: 1-408-962-0515

Service Manual

AtlonA

Infrared Extender System

up to 1000ft

AT-IR300SRS

Front View

Rear View

www.atlona.com | toll free: 1-877-536-3976

For International: 1-408-962-0515 2

TABLE OF CONTENTS

1. Setting Up CAT5e/6/7 .................................................. 3

2. No Power on the Extenders .................................................. 3

3. Connecting IR .................................................. 3

4. IR Issues .................................................. 4

www.atlona.com | toll free: 1-877-536-3976

For International: 1-408-962-0515 3

SETTING UP CAT5E/6/7

NO POWER ON THE EXTENDERS

CAT5E or higher is recommended for use withal ATLONA units. If cables are run in the walls make

sure to stay away from light xtures, electrical boxes, uorescent lights, and any or other electrical

cables to reduce and prevent signal degradation. T568B termination is recommended to be used for

this device.

Pin T568A Pair T568B Pair Wire T568A Color T568B Color Pins on plug face

(socket is reversed)

1 3 2 tip

white/green stripe white/orange stripe

2 3 2 ring

green solid orange solid

3 2 3 tip

white/orange stripe white/green stripe

4 1 1 ring

blue solid blue solid

5 1 1 tip

white/blue stripe white/blue stripe

6 2 3 ring

orange solid green solid

7 4 4 tip

white/brown stripe white/brown stripe

8 4 4 ring

brown solid brown solid

1 2 3 4 5 6 7 8

Pin Position

If the unit is not powering-on double check the surge protector/outlet that the unit is connected to. A Volt

Meter can also be used to check the power supply; it needs to be outputting 5V DC. Only one power

supply needs to be used for this system either on transmitter or receiver side.

CONNECTING IR

IR OUT1 IR INIR OUT2 IR OUT1IR OUT3 IR OUT2

1 12

AT-IR300R IR Extender AT-IR300S IR Extender

Repeater

www.atlona.com | toll free: 1-877-536-3976

For International: 1-408-962-0515 4

IR ISSUES

1. IR OUT1, 2 and 3: Place included IR cables to near your sources and connect them to the outputs of the

Extender

2. IR IN: Connect to IR Eye receiver cable (2M long) for receiving IR remote control signal.

Note: Please be very careful with plug in the blaster and receiver cables as a wrong connection will

result in cable and device burn out.

1. RJ45: Connect CAT 5/6/7 cable to next Infrared Extender Unit.

2. Power: Plug the 5VDC power supply into the unit and connect the adaptor to AC wall outlet.

Note: Only one power adapter is required, it could either be used on the Repeater or Extender Unit.

Note: IR receiver eye can take signals from up to 20 ft. away in the open distance

DC 5V

RJ 45

1 2

VERY IMPORTANT:

When connecting IR receivers and IR emitters, be very careful as if they are reversed the IR Eye will

burn-out and also may damage the IR module inside of the switch and Receiver.

When installing IR’s, the IR TX (Transmitter) is used on Sources. The eye should be placed over the

Source IR eye on most applications. If there is a signal issues e.g., device is not switching, the IR may-

be being over ooded. Place an IR TX to the side of the IR eye at 30-degree. User can also try moving

the IR up or down from the IR senson on the source to x the issue.

NOTE: the IR300SRS is designed to handle all IR signals up to 38KHz, which is acceptable for most

sources; however there are cases where the IR frequency of the certain source may be higher and in

this case, the IR300SRS will not work.

The IR RX (Receiver) should be placed in a visible location for the remote control view.

Autres manuels Atlona Extenseur

Atlona

Atlona AT-HD4-V110SR Manuel utilisateur

Atlona

Atlona AT-HD-RG100SR Manuel utilisateur

Atlona

Atlona AT-HD4-SI40SR Manuel utilisateur

Atlona

Atlona AT-DVI15SRS Manuel utilisateur

Atlona

Atlona AT-UHD-EX-70C-KIT Manuel utilisateur

Atlona

Atlona AT-HD-IR40SR Manuel utilisateur

Atlona

Atlona AT-HD4-V40SRS Manuel utilisateur

Atlona

Atlona AT-HD4-V110SR Manuel utilisateur

Atlona

Atlona AT-AV-SR Manuel utilisateur

Atlona

Atlona AT-VGA180AR Manuel utilisateur

Atlona

Atlona AT-COMP300SR Manuel utilisateur

Atlona

Atlona AT-PRO3HDREC Manuel utilisateur

Atlona

Atlona AT-VGA-RS300SRS Manuel utilisateur

Atlona

Atlona AT-UHD-EX-70-KIT Manuel utilisateur

Atlona

Atlona AT-DVI60SRS Manuel utilisateur

Atlona

Atlona AT-VBNC400SR Manuel utilisateur

Atlona

Atlona AT-USB50-SR Manuel utilisateur

Atlona

Atlona AT-SDI10SR-LC Manuel utilisateur

Atlona

Atlona AT-IR300SRS Manuel utilisateur

Atlona

Atlona AT-DVI40SRS Manuel utilisateur

Atlona

Atlona AT-2VGA300SL Manuel utilisateur

Atlona

Atlona AT-DVIDF40SR Manuel utilisateur

Atlona

Atlona AT-COMP300SL Manuel utilisateur

Atlona

Atlona ATAEX702PSK Manuel utilisateur

Manuels Extenseur populaires d'autres marques

SY HDBT-60T Manuel utilisateur

Appsys ProAudio

Appsys ProAudio ADX-16 Manuel utilisateur

IDK

IDK OPF-TH1000-A Manuel utilisateur

Enable-IT

Enable-IT 824WP Manuel utilisateur

Worx

Worx Landroid RadioLink WA0864 Fiche technique

TP-Link

TP-Link TL-WA730RE Manuel utilisateur

Camplex

Camplex CMX-HDMI-SFPL Manuel utilisateur

SC&T

SC&T HE03-4K Manuel utilisateur

Marmitek

Marmitek MegaView70 Manuel utilisateur

Samsung

Samsung SCS-26UC4 Manuel utilisateur

Foxun

Foxun SX-GES24 Manuel utilisateur

MuxLab

MuxLab 500771 Manuel utilisateur

foxunhd

foxunhd SX-AEX01 Manuel utilisateur

TERK Technologies

TERK Technologies LFIRX2 Manuel utilisateur

Devolo

Devolo Audio Extender Manuel

Edimax

Edimax EW-7438RPn V2 Manuel utilisateur

Shinybow USA

Shinybow USA SB-6335T5 Manuel utilisateur

SECO-LARM

SECO-LARM ENFORCER EVT-PB1-V1TGQ Manuel utilisateur