Atlantic Technology ICTS-6.1 Manuel utilisateur

Installation Instructions

Thank you for purchasing Atlantic Technology speaker products.These

high quality 2-way speakers solve a myriad of surround sound and

distributed audio installation problems. We work very hard to ensure

that all of our speakers consistently deliver exceptional performance

and value.

We hope you enjoy them to their fullest. Please take a moment to read

these instructions so you can get the most from your speakers.

Mounting Speciﬁcations

These speakers are intended for mounting in a ceiling,in material rang-

ing from ½ inch to 1 inch thick.They require at least 4 5

⁄8inches of depth

as measured from the front surface of the ceiling .The cutout opening

for the ICTS-6.1 is 7 3

⁄8inches in diameter (3 11

⁄16 inches radius). These

speakers will work equally as well in a wall as in a ceiling; however note

that they require more mounting depth than is normally available in a

2x4 studded wall.

Mounting Locations

Generally, it’s best to keep the speaker at least 24 inches away from any

nearby wall boundaries (wall/corner), since placing any speaker in

close proximity to other boundary surfaces will artiﬁcially reinforce

the upper bass/lower midrange sound, adversely “coloring” the sound

that the speaker produces.

The ICTS-6.1’s 1-inch dome tweeter is mounted in a pivoting housing,

so it to can be directed precisely towards the listening area for best

sound.

Model ICTS-6.1

When painting the grille...

™

ICTS-6.1-IP

Ceiling Speakers

Speciﬁcations

Dimensions 8 9⁄16” (220 mm)

Cutout Dimensions 7 3⁄8” (188 mm)

Mounting Depth (from front surface of ceiling) 4 5⁄8” (118 mm)

New Construction Bracket (optional) IC-NC-6.1

In-ceiling Back Box (optional) IC-BOX-6/8

Frequency Response 59-20kHz +/- 3dB

Sensitivity 88dB 1Watt/1 Meter

Recommended Ampliﬁer Power 10-100 Watts RMS

Impedance 6 ohms

Woofer 6 ½” Polypropylene cone

Tweeter 1” Pivoting soft dome

Net Weight 4.6 Lbs (2.1 kg)

1. Remove Scrim

2. Paint Grille

3. Reapply Scrim

For Connection to an IP-type system,like NetStreams®:

Unscrew the 4 setscrews

on top of the built-in

Phoenix connector and

pull the wires away from

the connector. See Figure

3 (You may tie or clip the

wires that used to connect

here.)

Connect the wires from

the NetStreams ampliﬁer

to the ICTS-6.1's Phoe-

nix connector and screw

down tightly.Consult your

NetStreams manual for

wiring details.

Atlantic Technology

343 Vanderbilt Avenue Norwood, MA 02062

(781) 762-6300 www.atlantictechnology.com

015-1061

New Construction and Retroﬁt Installations

Note: A new construction rough-in kit and back box kit are optionally

available from Atlantic Technology. Please refer to the instructions included

in those kits for their use. If the rough in kit has been used please go directly

to Step 2 below.

Mounting Hole Speciﬁcations:

ICTS-6.1: Diameter = 7 3⁄8in., 188mm; Depth = 4 5⁄8 in., 118mm

1Cut an appropriately sized opening in the ceiling material.Be sure that the

ceiling material can support the weight of the speaker.Also be sure that

the sides of the opening are at least 1 ½ inches away from any beams or

studs within the cavity.If it is not,the rotating clamps will be restricted

in their movement and may not clamp properly.

No less than 1 ½”

Joist

or Stud Joist

or Stud

Figure 1

2Be sure that all foreign material in the ceiling is kept out of the speaker

assembly,particularly the back of the woofer cone.There is a cloth shield

on the rear of the woofer, but please use care anyway.

3For conventional Connection to an audio ampliﬁer/receiver:

Attach the speaker wires that have been already run through the ceiling

to the speaker terminals. Simply remove ½ inch of insulation from the

end of each input wire. Push down on the terminal connector and an

opening will appear in the connector that is capable of holding up to 14

gauge wire.Insert the bare wire into the opening and release the terminal.

Be sure to observe correct polarity, connecting the positive (+) leads to

the red terminals and the negative (-) leads to the black terminals.Also

be sure that no stray strands of wire touch across any terminals. See

Figure 2.

Figure 2

Grille

Ceiling

Figure 3

4Mount the speaker in the ceiling.

Tighten the mounting screws one at a time. As you tighten the screws,

the clamps on the back of the assembly will turn and lower, grabbing

the back of the ceiling and sandwiching the ceiling between themselves

and the frame’s circular trim ring.

5Snug all four mounting screws in this manner. Be careful not to over-

tighten them.

IMPORTANT: If you are using an electric screwdriver, make sure it is

set to the“low torque”position.

6You may now install the grille into the frame by gently pushing it into

the recess.

Figure 4

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Atlantic Technology Intervenants

Atlantic Technology

Atlantic Technology IWTS-14 SR Manuel utilisateur

Atlantic Technology

Atlantic Technology IWTS-14 LCR Manuel utilisateur

Atlantic Technology

Atlantic Technology IWTS-4LCR-IP Manuel utilisateur

Atlantic Technology

Atlantic Technology FS-252 Manuel utilisateur

Atlantic Technology

Atlantic Technology 6200C Manuel utilisateur

Atlantic Technology

Atlantic Technology THX ULTRA 2 IWTS-155 Manuel utilisateur

Atlantic Technology

Atlantic Technology AT-2 Manuel utilisateur

Atlantic Technology

Atlantic Technology ICTS-6.3e Manuel utilisateur

Atlantic Technology

Atlantic Technology AT-1-S-GLF Manuel utilisateur

Atlantic Technology

Atlantic Technology IWTS-6 CMS Manuel utilisateur

Atlantic Technology

Atlantic Technology 5 LCR Manuel utilisateur

Atlantic Technology

Atlantic Technology 2200 C Manuel utilisateur

Atlantic Technology

Atlantic Technology Gatecrasher 1 Manuel utilisateur

Atlantic Technology

Atlantic Technology IWTS-6 CMS Manuel utilisateur

Atlantic Technology

Atlantic Technology System 10 LCR Manuel utilisateur

Atlantic Technology

Atlantic Technology M110 Manuel utilisateur

Atlantic Technology

Atlantic Technology lcr2 Manuel utilisateur

Atlantic Technology

Atlantic Technology 6200e Manuel utilisateur

Atlantic Technology

Atlantic Technology ICTS-6.2e Manuel utilisateur

Atlantic Technology

Atlantic Technology IW-155SR Manuel utilisateur

Atlantic Technology

Atlantic Technology IW Series Manuel utilisateur

Atlantic Technology

Atlantic Technology 1400 LR S Manuel utilisateur

Atlantic Technology

Atlantic Technology 8200 System Manuel utilisateur

Atlantic Technology

Atlantic Technology IWTS-4 LCR Manuel d'utilisation

Manuels Intervenants populaires d'autres marques

argon audio

argon audio IE20 Manuel utilisateur

Denon

Denon SC-N7 Manuel utilisateur

Gemline

Gemline Ace 3952 Manuel utilisateur

Focal

Focal ON WALL 300 Mode d’emploi

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuel utilisateur

SoundLogic

SoundLogic BCCS-6/6395 Manuel utilisateur

Peavey

Peavey DTH 218 Manuel utilisateur

Avantree

Avantree Pluto Air Manuel utilisateur

Morel

Morel Integra Series INTEGRA OVATION 4 Manuel utilisateur

Oppo

Oppo SONICA Manuel utilisateur

Bose

Bose SoundLink Wireless Music System Manuel utilisateur

Rocksteady

Rocksteady Stadium Manuel utilisateur

Bowers & Wilkins

Bowers & Wilkins 4 Manuel utilisateur

Sonance

Sonance SONOS OUTDOOR Series Manuel utilisateur

Electro-Voice

Electro-Voice EVID FM4.2 Manuel utilisateur

Pioneer

Pioneer XW-HTD630 Manuel utilisateur

Onn

Onn BWA16AA002 Manuel utilisateur

HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur