• After fitting the door closer these instructions and the retaining plate should be
kept in a safe place and referred to before any work on the door is carried out.
It is dangerous to remove the closer plate screws without first placing the
retaining plate in position.
• You are advised to use an approved installer when fitting or removing this
product. It is potentially dangerous to remove or tamper with this product.
• Poor ventilation and limited air flow may, like other closers, affect the
performance of this closer. A suitable latching device may help door latching,
but we accept no liability for the performance of the closer in these
circumstances.
• It is important that the door hinges and associated fittings are correctly
installed and do not affect the ability of the closer to close and latch the door.
• All doors must be fitted with a pair and a half of EN1935 approved hinges.
• The door closer is designed to open to 1 5° when installed with the centre line
of the plate 22mm from the hinge edge of the door. When installing the closer
in a thicker door the centre line of the plate must remain at 22mm from the
hinge edge to allow for 1 5° opening.
• Do not fit in conjunction with rising butts or parliament hinges.
• It is essential that fixing plate centres are exactly in line with each other when
the door is closed and each plate is recessed flush into the door and frame.
The gap between the fixing plates when the door is closed should be no
greater than 5mm and no less than 3mm.
• Please refer to the website www.astradoorcontrols.com for installation video
and advice. Fitting jigs and auger bits are available from approved stockists
and Astra Door Controls Ltd.
Astra Door Controls Ltd, Preston PR2 5AP, England www.astradoorcontrols.com
IMPORTANT. PLEASE READ THESE NOTES BEFORE INSTALLATION
3000 SERIES
INSTALLATION INSTRUCTIONS
