Ariston ASL 75 CXS NA Mode d'emploi

REPAIR MANUAL

Pages:

1 - 18

The information included in this Ariston Repair Manual may change without notice. Please see our web site

www.usservicenet.com for updates, corrections or additions.

PRODUCT: CONDENSATION DRYER

MODEL: ASL75CXS NA

REPAIR MANUAL

This Repair Manual is intended for persons having electrical and mechanical training and a level of knowledge

of these subjects generally considered acceptable in the Appliance Service Industry. Ariston cannot be

responsible, nor assumes any liability for injury or damages of any kind arising from the use or misuse of

the information contained in this Repair Manual.

If you have any questions regarding the proper diagnosis, repair or operation of any Ariston Appliance, please

contact the Ariston Customer Care Center or your Service Representative at 888-426-0825.

SERVICING SAFEGAURDS:

To avoid personal injury and/or property damage, it is important that safe servicing practices be observed at all times. Examples of

safe service practices are listed below but are not limited to the following:

1) Never attempt a product repair if you have any doubts as to your ability to complete the repair in a safe and

satisfactory manner.

2) Before servicing or removing an appliance:

- Disconnect power to the appliance.

- Turn off the gas / LP supply.

- Turn off the water supply.

3) Never interfere with the proper operation of any safety device.

4) Use only genuine factory replacement parts as substitutions may interfere with compliances to home safety codes or standards.

5) It is extremely important that all safety ground connections be reestablished prior to the completion of the service call. Failure to

do so will result in a hazardous condition being created.

6) Prior to returning the appliance back into active service, ensure the following:

- All electrical connections are correct and secure.

- Electrical leads are properly dressed and secured away from sharp edges, high temperature components and moving parts.

- All non-insulated electrical terminals, connectors, heaters, etc. are adequately spaced away from metal parts or panels.

- All safety grounds (both internal and external) are correctly and securely connected.

- All access panels are properly and securely reassembled.

SAFE SERVICE PRACTICES

ASL75CXS NA

Page: i

REPAIR MANUAL

Page

1. Control Panel ASL75CXS............................................................................................................... 1

2. Model / Serial Number Location..................................................................................................... 2

3. Top Panel....................................................................................................................................... 3

4. Control Panel.................................................................................................................................. 4

5. Control Panel Program Board......................................................................................................... 4

6. Door Switch.................................................................................................................................... 5

7. Condensation Unit..........................................................................................................................5

8. Heater Assembly............................................................................................................................6

9. Thermistor and High Limit Thermostat ........................................................................................... 7

10. Right Side Panel and Components................................................................................................. 8

11. Control Board and EEPROM.......................................................................................................... 9

12. Motor Replacement and Installation............................................................................................. 10

13. Drum Belt and Bearing Block........................................................................................................ 12

14. Drain Motor.................................................................................................................................. 13

15. Fault Codes.................................................................................................................................. 14

16. Schematic..................................................................................................................................... 15

TABLE OF CONTENTS

Page: ii

ASL75CXS NA

REPAIR MANUAL

Page: 1

1. CONTROL PANELASL75CXS

ASL75CXS NA

REPAIR MANUAL

2. MODEL / SERIAL NUMBER LOCATION

• The Model and Serial Number

Tag is located on the front of

the Dryer behind the door

(Fig. 2-1).

• The Model number is ASL75CXS NA with a nine (9) digit Serial

Number (Fig. 2-2).

Page: 2

Fig. 2-1

Fig. 2-2

ASL75CXS NA

REPAIR MANUAL

Page: 3

3. TOP PANEL

• To remove the Top Panel, first remove the two Phillips screws located at the rear corners of the panel (Fig. 3-1). With the two

screws removed slide the Rear Panel back and off the unit (Fig. 3-2). When reinstalling the Top Panel, Slide the Top Panel Clips

under the Control Panel and then replace the two Phillips Screws (Fig. 3-3).

Fig. 3-2

Fig. 3-3

Fig. 3-1

ASL75CXS NA

REPAIR MANUAL

4. CONTROL PANEL

• To remove the Control Panel, first

remove the two Phillips screws located

on the top left and right corners

(Fig. 4-1).

• The Control Panel will then lift up and off

the four cut outs located on the inner

frame (Fig. 4-2).

• Disconnect the single wire harness

connection and the complete Control

Panel can be separated from the frame.

Page: 4

Fig. 4-1

5. CONTROL PANEL PROGRAM BOARD

Fig. 5-1

• To remove the Control Panel Program Board, first remove the Program Dial by carefully prying it out from the Control Panel making

sure not to damage the Dial or Control Panel (Fig. 5-1). Next, release the three Program Board locking tabs and removed Program

Board from the Control Panel (Fig. 5-2).

Fig. 5-2

Fig. 4-2

REAR VIEW

ASL75CXS NA

REPAIR MANUAL

6. DOOR SWITCH

Page: 5

Fig. 6-1 Fig. 6-2

• To remove the Door Switch (Fig. 6-1),

first remove the Control Panel (see

Section 4, page 4).

• Then push down on the locking tab and

lift the door switch from the frame cut

out (Fig. 6-2).

TECH NOTE: The Door Switch can be

removed and installed easier with the Door

Panel in the open position.

• The Condensation Unit is located behind the Lower Access Door. To remove the Condensation Unit turn the three locking clips to

the open position (Fig. 7-1) and the complete Condensation Unit can be removed by pulling it forward (Fig. 7-2).

TECH NOTE: For best performance and operation the Condensation Unit should be cleaned once each month.

7. CONDENSATION UNIT

Fig. 7-1 Fig. 7-2

ASL75CXS NA

REPAIR MANUAL

8. HEATER ASSEMBLY

Page: 6

Fig. 8-1

TECH NOTE 1

Fig. 8-3

Fig. 8-2

• To access the Heater Assembly and Rear Thermostats,

remove the nine Heater Housing Phillips Screws (Fig. 8-1).

• The Heater Housing will come clear of the Rear Panel, but

it will still be attached to the wire harness (Fig. 8-2).

• The Heating Element Assembly is attached to the Heater

Housing with two Phillips screws. To remove the Heating

Element from the Heater Housing remove these two

screws (Fig. 8-3). See TECH NOTE on Fig. 8-1 for Heating

Element screw locations.

• The Heating Element Assembly contains both an upper

and lower element with a total output of 2500w along with

two Thermostats, see Section 9, Page 7 for Thermostat

details.

• To access the wire harness disconnect for the Heater

Assembly, it will be necessary to remove the Right Side

Panel (See Section 10, Page 10).

TECH NOTE 1: The two Heating Element Assembly screws

DO NOT have to be removed when removing the Heater

Housing.

ASL75CXS NA

REPAIR MANUAL

9. THERMISTOR & HIGH LIMIT - REAR

Page: 7

• There are two temperature sensing devises located on the Heating Element Assembly Figures 9-1 and 9-2.

• HIGH LIMIT: The High Limit Thermostat (white) is a One-Shot Cut Out (143˚f) Non-resetable.

• THERMISTOR (Rear): The Rear Thermistor (black) cycles the Heating Elements as necessary to maintain temperature. The Rear

Thermister measures inlet air temperature and communicates this information back to the Control Board.

TECH NOTE: The Thermistor has a value of approximately 500k Ohms at room temperature.

Fig. 9-1 Fig. 9-2

THERMISTER

HIGH LIMIT

9. THERMISTOR - FRONT

Fig. 9-3

• The Front Thermistor is located just behind the Control Panel to the right of the Door Switch (Fig. 9-3). The Front Thermistor

measures exhaust air temperature and communicates this information to the Control Board.

TECH NOTE: The Thermistor has a value of approximately 500k Ohms at room temperature.

ASL75CXS NA

Autres manuels pour ASL 75 CXS NA

Table des matières

Autres manuels Ariston Séchoir

Ariston

Ariston A35V Guide de référence rapide

Ariston

Ariston A45V Mode d'emploi

Ariston

Ariston A45V Guide d'installation

Ariston

Ariston TCM 80 Manuel utilisateur

Ariston

Ariston AS600V Manuel utilisateur

Ariston

Ariston ASL700CX Manuel utilisateur

Ariston

Ariston ASL 65 VXS NA - 35140 Mode d’emploi

Ariston

Ariston ASL70C Manuel utilisateur

Ariston

Ariston ASD70C Manuel utilisateur

Ariston

Ariston ASL 75 CXS NA Mode d’emploi

Ariston

Ariston ASL70C Manuel utilisateur

Ariston

Ariston TVF 75C Manuel utilisateur

Ariston

Ariston TCL73XNA Mode d’emploi

Ariston

Ariston A46C Guide d'installation

Ariston

Ariston TVM63 Mode d’emploi

Ariston

Ariston TVF 75 C Manuel utilisateur

Ariston

Ariston AS60V Manuel utilisateur

Ariston

Ariston TVM63X NA Instructions d'utilisation et d'installation

Ariston

Ariston AS66VX Mode d’emploi

Ariston

Ariston AS700C Manuel utilisateur

Ariston

Ariston TCF 87B Manuel utilisateur

Ariston

Ariston TVM 70 Manuel utilisateur

Ariston

Ariston A45V Guide d'installation

Ariston

Ariston TCL73X Caractéristiques techniques

Manuels Séchoir populaires d'autres marques

Bosch

Bosch WTA79200GB Manuel utilisateur

Amana

Amana W10233410A Manuel utilisateur

Miele

Miele TWH 780 WP Manuel utilisateur

Asko

Asko T760 Manuel utilisateur

Alliance Laundry Systems

Alliance Laundry Systems 25 Series Manuel utilisateur

Bosch

Bosch Logixx 10 WTB76556GB Fiche technique

STIEBEL ELTRON

STIEBEL ELTRON Ultronic S Mode d’emploi

Electrolux

Electrolux EW2H328R2 Manuel utilisateur

Beko

Beko DS8433RX1M Manuel utilisateur

Dawlance

Dawlance Spinner DS 6000 C Manuel utilisateur

Electrolux

Electrolux TP5080TW Manuel utilisateur

AEG

AEG TR838P4OB Manuel utilisateur

Indesit

Indesit IDV 75 Manuel utilisateur

Infiniton

Infiniton SD-DG85C Manuel utilisateur

BOMANN

BOMANN WT 5019 Manuel utilisateur

Alliance Laundry Systems

Alliance Laundry Systems TMB795C Manuel utilisateur

Asko

Asko T793C Manuel utilisateur

Kenmore

Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer Manuel utilisateur