AmpliVox BELT BLASTER Manuel utilisateur

AmpliVox • 650 Anthony Trail Suite D, Northbrook, IL 60062 • Phone: (800)267-5486 • Fax: (800)267-5489 www.ampli.com

S206 BELT BLASTER /

S207 BELT BLASTER PRO

WAISTBAND AMPLIFIER

INCLUDED:

1. Belt Blaster Pro Personal Waistband Amplifier

2. 44″ Adjustable Belt

3. Headset and Lapel Microphone

4. AC Adapter/Recharger

5. Storage Case

6. Waistband Case

7. 6 - NiMH rechargeable batteries

S206 Batteries: Insert six (6) standard ʺAAʺ batteries (not included) as show below.

Install Batteries:

1. Locate the battery compartment on the right rear side of the amplifier.

2. Press (do not pry) the cover locking tab to the right and lift to remove battery cover.

3. Install the 6 batteries . Follow the picture of battery direction as seen in the bottom of

the holder. Negative (-) flat side of battery toward spring.

4. Insert battery cover and press back into place.

BATTERY REPLACEMENT

When batteries (S207) will no longer hold a charge, all 6 batteries MUST be replaced at the same

time. Mixing old and new batteries can lead to battery failure.

CHARGING BATTERIES FOR FIRST USE (S207)

Your new Belt Blaster Pro is shipped with 6 NiMH rechargeable batteries. Once they have been installed,

they must receive a deep charge (24 hours) before being used.

1. Insert battery charger mini plug (AC adapter) into the charging port located on the bottom of the amplifier.

2. Plug the adapter into a working power outlet. Charge the Belt Blaster Pro for 24 hours for the first charge.

After this, only 8 - 14 hour charge is necessary

S207 Rechargeable Batteries: The rechargeable Nickel Metal Hydride batteries of the S207 Belt Blaster Pro will have a life

expectancy of approximately 2 years. Actual life will vary significantly depending on your usage and charging habits. There may

be a time when you need to use backup power to get through a presentation. The Belt Blaster PRO was intentionally designed

to accommodate standard ″AA″ batteries for just such occasions.

NOTE:

The AC Adapter/Charger can ONLY be used to recharge the batteries . Can not power the amplifier simultaneously.

CAUTION! NEVER PLUG IN AC ADAPTER/CHARGER WITH NON-RECHARGEABLE BATTERIES INSIDE AMPLIFIER.

SERIOUS DAMAGE MAY BE CAUSED TO BATTERIES AND AMPLIFIER.

1. Belt Blaster Personal Waistband Amplifier

2. 44″ Adjustable Belt

3. Headset and Lapel Microphone

4. Storage Case

INCLUDED:

S206 S207

INSERTING/CHANGING THE BATTERIES

CHARGER PORT

AmpliVox • 650 Anthony Trail Suite D, Northbrook, IL 60062 • Phone: (800)267-5486 • Fax: (800)267-5489 www.ampli.com

OPERATING INSTRUCTIONS

The amplifier is usually worn on the front of the waist, much

like a “waist pack” . The woven nylon waist band is adjusta-

ble to 44 inches. Remember to wear the Belt Blaster so the

speaker grill faces out away from the body to avoid feed-

back.

1. With the amplifier turned OFF, insert the 3.5mm lapel/

headset microphone plug into the jack on top of the

amplifier.

2. Put the amplifier on your waist, adjust the attached belt

to fit, then clip the buckle. Please take note of the path

of the nylon belt through the clips. In the event that the

belt is disassembled, it is imperative that the belt be

correctly reinstalled.

3. Turn the amplifier ON by turning the volume control

knob to the 11 o’clock position while speaking at a con-

sistent volume level.

4. When you perceive your voice is loud enough, reduce

the volume slightly. This is done because you are

standing behind the speaker and your voice is consider-

ably louder then you perceive.

USB THUMB DRIVE

1. Insert USB Thumb Drive into the USB Slot on top of

amplifier.

2. Press ON/OFF/Play button to turn on the USB. USB

power LED will light up and flash. Press button again to

play first recorded item.

3. Press to advance to next song/message or hold for 2

seconds to fast forward.

4. Press to go back to last song/message or hold for 2

seconds to fast backwards.

TROUBLE SHOOTING

POPPING OR CRACKLING NOISE

Popping or crackling noises coming from the speaker of your Belt Blaster, particularly when the microphone cable is moved, are

usually caused by dirt, finger oils or corrosion build-up on the microphone plug.

Remove the plug and clean the metal tip and sleeve with a clean cloth or cotton swab moistened with alcohol, or with a pre-

moistened towelette (Wet Wipe or similar). If none of these are available, use a clean, dry cloth or paper towel. While not as

effective, this should still improve the contact.

ON/OFF

VOLUME

POWER/BATTERY

LOW LED MICROPHONE

JACK

Nov, 2020

TOP

USB

SLOT USB

ON/OFF/

PLAY USB

FF/FB

USB

PWR LED

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels AmpliVox Intervenants

AmpliVox

AmpliVox Mega Hailer S680 Manuel utilisateur

AmpliVox

AmpliVox S1204 Manuel utilisateur

AmpliVox

AmpliVox SW 720 Manuel utilisateur

AmpliVox

AmpliVox Mity-Vox SW212 Manuel utilisateur

AmpliVox

AmpliVox Digital Audio Travel Partner Manuel utilisateur

AmpliVox

AmpliVox Megaphones S601 Manuel utilisateur

AmpliVox

AmpliVox HALF-MILE HAILER W/INTERNAL WIRELESS PORTABLE PUBLIC ADDRESS SYSTEM... Manuel utilisateur

AmpliVox

AmpliVox SW6200 Manuel utilisateur

AmpliVox

AmpliVox S602R Manuel utilisateur

AmpliVox

AmpliVox S1090 Manuel utilisateur

AmpliVox

AmpliVox SW222A Manuel utilisateur

AmpliVox

AmpliVox S805A Manuel utilisateur

AmpliVox

AmpliVox S1100 Manuel utilisateur

AmpliVox

AmpliVox S1234 Manuel utilisateur

AmpliVox

AmpliVox SW300 Mity-Lite Portable PA Manuel utilisateur

AmpliVox

AmpliVox Rechargeable Mity-Vox SW212 Manuel utilisateur

AmpliVox

AmpliVox TITAN WIRELESS PORTABLE PA Manuel utilisateur

AmpliVox

AmpliVox S601R Manuel utilisateur

AmpliVox

AmpliVox ST3240 Manuel utilisateur

AmpliVox

AmpliVox INFRARED COMPAC PA SYSTEM Manuel utilisateur

AmpliVox

AmpliVox SC800 Manuel utilisateur

AmpliVox

AmpliVox Mity-Lite Plus SW320 Manuel utilisateur

AmpliVox

AmpliVox SW227 Manuel utilisateur

AmpliVox

AmpliVox SW915 Digital Audio Travel Partner Fiche technique

Manuels Intervenants populaires d'autres marques

argon audio

argon audio IE20 Manuel utilisateur

Denon

Denon SC-N7 Manuel utilisateur

Gemline

Gemline Ace 3952 Manuel utilisateur

Focal

Focal ON WALL 300 Mode d’emploi

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuel utilisateur

SoundLogic

SoundLogic BCCS-6/6395 Manuel utilisateur

Peavey

Peavey DTH 218 Manuel utilisateur

Avantree

Avantree Pluto Air Manuel utilisateur

Morel

Morel Integra Series INTEGRA OVATION 4 Manuel utilisateur

Oppo

Oppo SONICA Manuel utilisateur

Bose

Bose SoundLink Wireless Music System Manuel utilisateur

Rocksteady

Rocksteady Stadium Manuel utilisateur

Bowers & Wilkins

Bowers & Wilkins 4 Manuel utilisateur

Sonance

Sonance SONOS OUTDOOR Series Manuel utilisateur

Electro-Voice

Electro-Voice EVID FM4.2 Manuel utilisateur

Pioneer

Pioneer XW-HTD630 Manuel utilisateur

Onn

Onn BWA16AA002 Manuel utilisateur

HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur