Zone Input Device Item Number: 4210-0058, 4210-0059
Installation guide
1
Description
The Zone Input Device is available in two variants:
The DIN-Rail Mounted Zone Input Device, Item No
4210-0058, is designed to be mounted in an enclosure,
clipped onto a standard 35mm DIN Rail (DIN46277)
and secured using the built in fixing. End stops can also
be used to provide additional security. Alternatively, the
4210-0058 can be mounted direct to an enclosure
back panel using the internal preformed fixing holes.
The Enclosed Zone Input Device, Item No 4210-0059,
is supplied within a backbox for surface mounting.
Note: Both variants are not intended for outdoor use
unless mounted in a suitable weatherproof enclosure.
The installation must conform to applicable local codes
and be carried out such that the Zone Input Device is
not subjected to exposure to temperatures exceeding
the maximum ambient, exposure to moisture, dust and
foreign bodies or exposure to a risk of mechanical
damage.
The Zone Input Device is loop powered and controlled
by the main fire control panel. The address is set using
the onboard DIL switch.
The Zone Input Device incorporates a bi-directional
short circuit isolator between the loop input and loop
output terminals which will protect the conventional
zone of detectors against a single loop short circuit on
either side of the device.
Installation
DIN Rail - Item No 4210-0058
Clip the Zone Input Device to the standard 35mm DIN
rail using the Red locking clip located in the front of the
device. Alternatively, fix direct to the enclosure back
panel using appropriate M4 nuts and bolts.
Enclosed - Item No 4210-0059
Remove the clear ABS cover and securely mount the
backbox to a wall or suitable structure using the
integral fixing positions then install all external cables
using the knock outs and/or cable tray entry points as
required.
1. Connect the cables from the detection loop and the
conventional detector zone into the device. Ensure
that the earth continuity is maintained.
2. Set the End of Line (EOL) monitoring to match the
device used by the conventional zone circuit in
accordance with Table 1. Polling LED indication
can also be enabled during commissioning.
3. Set the Device address using the DIL switch in
accordance with the address Table 2 and record
the location description of the device itself together
with the address setting on the device fascia label.
4. Following commissioning ensure that the device is
securely fastened and replace the ABS clear cover.
Schematic Diagram
Programming
When configuring the Zone Input Device for use with
the FireFinder range of panels, using ConfigManager
the device is assigned as an AMPAC ZID type. When
configuring for use with LoopSense range of panels,
using LoopMaster the device is configured as an XP95
Zone Monitor Unit.
The Zone Input Device can be programmed to function
in any one of the following modes:
•Normal (latching alarm)
•Non-latching
•Self Reset
•Dependency A,B and C (LoopSense only)
•Investigation (LoopSense only)
•Alarm Verification Facility (FireFinder only)
The conventional Zone Input has a programmable End
of Line feature that allows for either 3K3Ω or 6K2Ω
resistor value to be used. Alternatively, the EOL can be
a 10uF capacitor which is required to support the
detector head removal feature when used with diode
bases on the conventional zone circuit. The default
setting for the device is 3k3 No AVF.
Table 1
EOL and LED indication switch settings 1= On
