ALLPOWER APC4016 Manuel utilisateur

2.5HP6GALLON

AIRCOMPRESSOR

FORTECHNICALSUPPORTPLEASE

AirCompressor

Tableof Contents

Topic

Safety Guidelines - Definitions

Hazard Warnings

Air Compressor

•Precautions

• Basic Air Compressor Components

• Assembling the Compressor

• Compressor Controls

• Electrical Power Requirements

• Breaking InThe Pump

• Operating Instructions

• Maintenance

•Storage

• Service

Troubleshooting

Glossary of Terms

Limited Warranty

Page

Owner'sManual

WARNING! READAND UNDERSTANDALL SAFETY PRECAUTIONSIN

THISMANUAL BEFORE OPERATING.FAILURE TO COMPLY WITH

INSTRUCTIONS IN THIS MANUALCOULD RESULT IN PERSONAL

INJURY, PROPERTYDAMAGE,AND/OR VOIDINGOF YOUR

WARRANTY.ALL-POWERAMERICA WILL NOTBE LIABLEFOR ANY

DAMAGE BECAUSEOF FAILURE TO FOLLOW THESEINSTRUCTIONS.

Compressor Inspection

Prior to installation and usage, thoroughly inspect air compressor

for damage or flaws.

• Check tank, compressor, compressor motor and pump for

any signs of damage or corrosion.

• Check all screws, bolts, nuts and fasteners. Confirm that they

are secure.

• Confirm that all fittings, tank petcock and hardware are free

of paint, rust and corrosion.

• Confirm that all compressor settings are correct prior to

set-up and usage.

Air Tool Inspection

Prior to connecting to compressor and usage, thoroughly inspect

each air tool for damage or flaws.

• Check entire tool assembly for any signs of damage or

corrosion.

• Check all assembly screws, bolts, nuts and fasteners and

confirm that they are secure.

• Confirm that all fittings, bits and hardware for integrity.

• Confirm that tool settings are correct prior to connection and

usage.

AirCompressor

SafetyGuidelines- Definitions

This manualcontains important informationthat you need to know and

understand in order to protect YOUR SAFETY and to PREVENT

EQUIPMENT PROBLEMS. The following symbols help you recognize this

information. Please read the manual and pay attention to these sections.

WARNING!WARNINGSINDICATEA CERTAINTYORSTRONG

POSSIBILITYOFPERSONALINJURYORDEATHIFINSTRUCTIONS

ARENOTFOLLOWED.

A_ CAUTION: CAUTIONS INDICA TE A POSSIBILITY OF

EQUIPMENT DAMAGE IF INSTRUCTIONS ARE NOT

FOLL 0 WED.

Note: Notes give helpful information.

WARNING!IMPROPEROPERATIONORMAINTENANCEOFTHIS

PRODUCTCOULDRESULTINSERIOUSINJURYANDPROPERTY

DAMAGE.READANDUNDERSTANDALLWARNINGSANDOPERATING

INSTRUCTIONSBEFOREUSINGTHISEQUIPMENT.WHENUSINGAIR

TOOLS,BASICSAFETYPRECAUTIONSSHOULDALWAYSBE

FOLLOWEDTOREDUCETHERISKOFPERSONALINJURY.

SaveTheseImportantSafety

Instructions!

Read and understand all ofthese safety instructions. Be

sure to retain them for future use.

Owner'sManual

HazardWarnings

Dust

WARNING!SOMEDUSTCREATEDBYPOWERSANDING,SAWING,

GRINDING,DRILLING,ANDOTHERCONSTRUCTIONACTIVITIES

CONTAINSCHEMICALSKNOWNTOTHESTATEOFCALIFORNIATO

CAUSECANCER,BIRTHDEFECTSOROTHERREPRODUCTIVEHARM.

These chemicalsmay include (but are not limitedto) the following:

•Lead from lead-based paints

• Crystalline silica from bricks and cement and other masonry products

• Arsenic and chromium from chemically-treated lumber

Your risk from these exposures varies, depending on how often you do this

type of work. To reduce your exposure to these chemicals: work in a well

ventilated area, and work with approved safety equipment, always wear

MSHA/NIOSH approved, properly fitting face masks or respirators when

using such tools.

Always follow basic safety precautions when using air tools to reduce the

risk of personal injury.

Bursting

Rust can weaken the tank. Drain the condensed water from the tank after

each use to reduce rusting. If a leak is detected in the tank, replace the tank

immediately. Do not weld, drill or modify the air tank of this compressor.

Welding or modifications on the air compressor tank can severely impair

tank strength and cause an extremely hazardous condition. Welding or

modifying the tank in any manner will void the warranty.

Check the manufacturer's maximum pressure rating for air tools and

accessories. Compressor outlet pressure must be regulated so as to never

exceed the maximum pressure rating of the tool. Relieve all pressure

through the hose before attaching or removing accessories.

Do not adjust the pressure switch or relief valve for any reason. Doing so

voids all warranties. They have been preset at the factory for the maximum

pressure of this unit. Personal injury and/or property damage may result if

the pressure switch or the relief valve are tampered with.

Do not use plastic or pvc pipe for compressed air. Use only galvanized steel

pipe and fittings for compressed air distribution lines.

AirCompressor

HazardWarnings(cont'd)

RiskofEyeorHeadInjury

What could happen:

•Air powered equipment and power tools are capable

of propelling materials such asfasteners, metal chips,

saw dust, and other debris at high speed, which could

resultin seriouseye injury.

• Compressedair can be hazardous.The air stream

can cause injuryto softtissueareas such as eyes,

ears, etc. Particlesor objectspropelledbythestream

can cause injury.

•Toolattachmentscan become looseor breakand fly

apart propellingparticlesat theoperatorand othersin

thework area.

How toprevent it:

•Alwayswear ANSI approvedZ87.1 safety glasses withside shields.

•Never leaveoperatingtoolunattended.Disconnectair hosewhen toolis

notin use.

•Foradditionalprotection, usean approvedface shieldin additionto

safety glasses.

•Make surethat anyattachmentsare securelyassembled.

•Never pointanynozzle or sprayertowarda personor any partofthe

body.Equipmentcan cause seriousinjuryifthe spray penetratesthe

skin.

Owner'sManual

HazardWarnings(cont'd)

RiskofFireorExplosion

What could happen:

•Abrasive tools such as sanders and grinders, rotating

tools such as drills, and impact tools such as nailers,

staplers, wrenches, hammers, and reciprocating saws

are capable of generating sparks which could result in

ignition of flammable materials.

• It is normal for the compressor motor and pressure

switch to produce sparks while operating. If sparks

come into contact with vapors from gasoline or other

solvents, they may ignite, causing fire or explosion.

• Exceeding the maximum pressure rating of tools or

accessories could cause an explosion resulting in

serious injury.

How to prevent it:

• Never operate tools near flammable substances such as gasoline,

cleaning solvents, etc.

• Work in a clean, well ventilated area free of combustible materials.

•Never useoxygen, carbondioxide or otherbottled gasesas a power

source for air tools.

• Use compressedair regulatedto maximumpressure at or below the

ratedpressureof anyattachments.

•Never connectto anair sourcethatis capableofexceeding200 psi.

•Alwaysverify priorto usingthe toolthatthe air sourcehasbeen

adjustedtothe rated air pressure range.

•Never sprayflammable liquidsin a confinedarea. Do not spraywhere

sparksor flame are present.

•Do notsmokewhilespraying.

•Keep compressor as far from spray area as possible.

AirCompressor

HazardWarnings(cont'd)

RiskofHearingLoss

What could happen:

•Long term exposure to noise produced from the

operation of air tools can lead to permanent hearing

loss.

How to prevent it:

Always wear ANSI $3.19 hearing protection when usinga compressor.

HazardRiSkto Breathing/Inhalation

What could happen:

• Abrasive tools such as grinders, sanders, and cut-off

tools generate dust and abrasive materials which can

be harmful to human lungs and respiratory system.

• Some materials suchas adhesives and tar contain chemicals whose

vapors could cause serious injury with prolonged exposure.

How to prevent it:

• Always wear MSHA/NIOSH approved, properly fitting face mask or

respirator when using such tools. Read all instructions and be sure that

your respirator mask will protect you.

• Always work in a clean, dry, well ventilated area.

• Never directly inhale the compressed air produced by a compressor. It is

not suitable for breathing purposes.

• Be certain to read all labels when you are spraying paints or toxic

materials, and follow the safety instructions.

Owner'sManual

HazardWarnings(cont'd)

RiskofInjury

What could happen:

•Tools leftunattended,or with theair hoseattached

can be activated by unauthorized persons leading to

their injury and/or injury to others.

• Air tools can propel fasteners or other materials

throughout the work area.

• A wrench or key that is left attached to a rotating part

of the tool increases the risk of personal injury.

• Using inflator nozzles for duster applications can

cause serious injury.

• Air toolscanbecome activatedby accident during

maintenance or tool changes.

• Air tools can cause the work-piece to move upon

contact leading to injury.

• Loss of control of the tool can lead to injury to self or

others.

•Poor quality, improper, or damaged tools such as

grinding wheels, chisels, sockets, drills, nailers,

staplers, etc., can fly apart during operation,

propelling,particles throughout the work area causing

senousinjury.

• Fasteners could ricochet or be propelled causing

serious injury or property damage.

• Improperly maintained tools and accessories can

cause seriousinjury.

• There is a riskof burstingifthetoolis damaged.

•The compressor unitstartsautomatically.Serious

injurycouldoccurfrom contact with movingparts.

AirCompressor

HazardWarnings(cont'd)

RiskofInjury(cont'd)

How toprevent it:

•Remove air hose when toolisnot inuse and storetool in securelocation

away from reach ofchildrenand or untrainedusers.

• Useonlyparts,fasteners,and accessoriesrecommendedbythe

manufacturer.

• Keep workarea clean and free ofclutter. Keep childrenand others

away from workarea duringoperationof thetool.

•Keep workarea well lit.

•Remove adjustingkeysand wrenchesbeforeturningthe toolon.

•DO NOT use inflatornozzlesfor dusterapplications.

• Remove air hoseto lubricateor add grindingattachments,sanding

discs,drills,etc.to the tool.

•Never carrythetool bythe hose.

•Avoidunintentionalstarting.

•Repairservicingshouldbe doneonlyby an authorizedservice

representative.

•Useclampsor otherdevicesto preventmovement.

•Never operatetoolwhileunderthe influenceofdrugsor alcohol.

•Don'toverreach. Keep properfooting and balanceof alltimes.

•Keep handlesdry,clean andfree from oil and grease.

•Stay alert. Watchwhat you are doing. Use common sense. Do not

operatetoolwhen you are tired.

•Always usetoolattachmentsrated for the speed ofthe powertool.

•Never usetoolswhichhavebeen dropped,impactedor damaged by

use.

Autres manuels pour APC4016

Table des matières

Autres manuels ALLPOWER Compresseur d'air

ALLPOWER

ALLPOWER APC4007 Manuel utilisateur

ALLPOWER

ALLPOWER APC005 Manuel utilisateur

ALLPOWER

ALLPOWER APC4017 Manuel utilisateur

ALLPOWER

ALLPOWER APC4011 Manuel utilisateur

ALLPOWER

ALLPOWER APC4035 Manuel utilisateur

ALLPOWER

ALLPOWER apc4200 Manuel utilisateur

ALLPOWER

ALLPOWER APC4016 Manuel utilisateur

ALLPOWER

ALLPOWER APC4004 Manuel utilisateur

ALLPOWER

ALLPOWER APC4009 Manuel utilisateur

ALLPOWER

ALLPOWER 3.5HP PEAK 6 GALLON Manuel utilisateur

ALLPOWER

ALLPOWER APC4003 Manuel utilisateur

ALLPOWER

ALLPOWER APC4016 Manuel utilisateur

ALLPOWER

ALLPOWER APC4006 Manuel utilisateur

ALLPOWER

ALLPOWER APC4025 Manuel utilisateur

ALLPOWER

ALLPOWER APC4408 Manuel utilisateur

ALLPOWER

ALLPOWER 1/3HP 3 Gallon Manuel utilisateur

ALLPOWER

ALLPOWER APC4007 Manuel utilisateur

ALLPOWER

ALLPOWER Quietzone APC4406 Manuel utilisateur

ALLPOWER

ALLPOWER APC4008 Manuel utilisateur

ALLPOWER

ALLPOWER APC4302 Manuel utilisateur

ALLPOWER

ALLPOWER Quietzone APC4406 Manuel utilisateur

Manuels Compresseur d'air populaires d'autres marques

Sparmax

Sparmax DC-25XR Manuel utilisateur

KAESER

KAESER M122 Manuel utilisateur

GMC

GMC GAC1500 Manuel utilisateur

Briggs & Stratton

Briggs & Stratton Air Compressor Manuel utilisateur

Fini

Fini F3GST2TK Manuel utilisateur

Industrial Air

Industrial Air CP1580325 Manuel de programmation

Campbell Hausfeld

Campbell Hausfeld RP3300 Guide de démarrage rapide

Ingersoll-Rand

Ingersoll-Rand UP6 20 HP Manuel utilisateur

Hitachi

Hitachi EC99S Manuel de l'opérateur

Parkside

Parkside PKO 270 A1 Manuel utilisateur

Sullair

Sullair 185 Manuel utilisateur

Clas Ohlson

Clas Ohlson QIE-ZTH-15 Manuel utilisateur

Ferm

Ferm CRM1046 Manuel utilisateur

BE AC153 Manuel utilisateur

RIDGID

RIDGID OF25150A Manuel utilisateur

Johnson Controls

Johnson Controls QUANTUM LX Manuel

Sears

Sears Craftsman 919.167463 Manuel utilisateur

Ring Automotive

Ring Automotive RAC700 Manuel utilisateur