x510 Series Installation Guide 4
5Configuration Reset
The ‘Configuration reset’ restores the configuration to the default settings:
1. Web interface: Go to menu ‘Settings’ → ’Administration’ and click on ‘Reset
system configuration’. All settings including the network configuration will be
reset to factory default.
2. Boot menu: Follow the instructions in section 7. Factory Reset.
6Firmware Update Notification
Update information via email
With each release, Allegro Packets will send you an email with release notes and a
link to download the update. If you want to be added to this mailing list, please
send an email with your serial number (‘Info’ → ‘System Info‘ → ‘System ID’) to
support@allegro-packets.com and the subject ‘Release’.
Using the Allegro web interface
Start your Allegro Network Multimeter and click ‘Settings’ in the menu and then
‘Firmware updates’. Click on ‘Check for new firmware’ and the Allegro Network
Multimeter will tell you if a new version is available for download. If so, you can
choose to download it directly to the device. In addition, this page provides an
overview of all versions available to you. To install the new version, click on
‘Activate’.
7Factory Reset
The ‘Factory reset’ will clear the entire system installation and restore the firmware
to the version that was originally shipped with the Allegro Network Multimeter.
1. Power off the Allegro 1510, 3510, 5510, or 7510.
2. Remove all network cables from the device.
3. Connect a display to the VGA port.
4. Connect a USB keyboard to any of the four USB ports.
5. Power on the device by pressing the power button.
6. After initialization a boot menu appears. Select ‘Factory reset’ and press Enter.
Or select ‘Configuration reset’ to reset the configuration settings only while
keeping the current firmware installation.
7. The device will boot, reset everything to factory settings, and reboot again.
8. The device is now reset to factory settings.
9. Disconnect the display and keyboard.
8Manual
The device manual can be accessed from the web interface. Each web section
contains a button to access context-specific documentation. The complete manual
can be opened by clicking on the ‘Manual’ link in the menu and then choosing the
Offline manual in the appliance or the Online manual at:
https://allegro-packets.com/wiki
